參數資料
型號: LTC2206CUK
廠商: LINEAR TECHNOLOGY CORP
元件分類: ADC
英文描述: 16-Bit, 105Msps/80Msps ADCs
中文描述: 1-CH 16-BIT PROPRIETARY METHOD ADC, PARALLEL ACCESS, PQCC48
封裝: 7 X 7 MM, PLASTIC, MO-220WKKD-2, QFN-48
文件頁數: 17/32頁
文件大?。?/td> 1489K
代理商: LTC2206CUK
LTC2207/LTC2206
17
22076fa
CONVERTER OPERATION
The LTC2207/LTC2206 are CMOS pipelined multistep con-
verters with a front-end PGA. As shown in Figure 1, the con-
verter has five pipelined ADC stages; a sampled analog input
will result in a digitized value seven cycles clock later (see the
Timing Diagram section). The analog input is differential for
improved common mode noise immunity and to maximize
the input range. Additionally, the differential input drive
will reduce even order harmonics of the sample and hold
circuit. The encode input is also differential for improved
common mode noise immunity.
The LTC2207/LTC2206 have two phases of operation,
determined by the state of the differential ENC
+
/ENC
input pins. For brevity, the text will refer to ENC
+
great-
er than ENC
as ENC high and ENC
+
less than ENC
as
ENC low.
Each pipelined stage shown in Figure 1 contains an ADC,
a reconstruction DAC and an interstage amplifier. In
operation, the ADC quantizes the input to the stage and
the quantized value is subtracted from the input by the
DAC to produce a residue. The residue is amplified and
output by the residue amplifier. Successive stages oper-
ate out of phase so that when odd stages are outputting
their residue, the even stages are acquiring that residue
and vice versa.
When ENC is low, the analog input is sampled differen-
tially directly onto the input sample-and-hold capacitors,
inside the “input S/H” shown in the block diagram. At the
instant that ENC transitions from low to high, the voltage
on the sample capacitors is held. While ENC is high, the
held input voltage is buffered by the S/H amplifier which
drives the first pipelined ADC stage. The first stage acquires
the output of the S/H amplifier during the high phase of
ENC. When ENC goes back low, the first stage produces
its residue which is acquired by the second stage. At the
same time, the input S/H goes back to acquiring the analog
input. When ENC goes high, the second stage produces
its residue which is acquired by the third stage. An iden-
tical process is repeated for the third and fourth stages,
resulting in a fourth stage residue that is sent to the fifth
stage for final evaluation.
Each ADC stage following the first has additional range to
accommodate flash and amplifier offset errors. Results
from all of the ADC stages are digitally delayed such that
the results can be properly combined in the correction
logic before being sent to the output buffer.
APPLICATIONS INFORMATION
相關PDF資料
PDF描述
LTC2206IUK 16-Bit, 105Msps/80Msps ADCs
LTC2206UK 16-Bit, 105Msps/80Msps ADCs
LTC2207 16-Bit, 105Msps/80Msps ADCs
LTC2207CUK 16-Bit, 105Msps/80Msps ADCs
LTC2207IUK 16-Bit, 105Msps/80Msps ADCs
相關代理商/技術參數
參數描述
LTC2206CUK#PBF 制造商:Linear Technology 功能描述:Single ADC Pipelined 80Msps 16-bit Parallel 48-Pin QFN EP 制造商:Linear Technology 功能描述:IC ADC 16-BIT 80MSPS 48-QFN 制造商:Linear Technology 功能描述:MS-ADC/High Speed, 16-bit, 80Msps ADC 制造商:Linear Technology 功能描述:IC, ADC, 16BIT, 80MSPS, QFN-48, Resolution (Bits):16bit, Sampling Rate:80MSPS, Supply Voltage Type:Single, Supply Voltage Min:3.135V, Supply Voltage Max:3.465V, Supply Current:220mA, Digital IC Case Style:QFN, No. of Pins:48 , RoHS Compliant: Yes
LTC2206CUK#TRPBF 制造商:Linear Technology 功能描述:IC ADC 16-BIT 80MSPS 48-QFN
LTC2206CUK-14 制造商:LINER 制造商全稱:Linear Technology 功能描述:14-Bit, 105Msps/80Msps ADCs
LTC2206CUK-14#PBF 功能描述:IC ADC 14BIT 80MSPS 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極
LTC2206CUK-14#TRPBF 功能描述:IC ADC 14-BIT 80MSPS 48-QFN RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率(每秒):83k 數據接口:串行,并聯 轉換器數目:1 功率耗散(最大):95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP(0.600",15.24mm) 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端,雙極