參數資料
型號: LTC1704B
廠商: Linear Technology Corporation
元件分類: 通用總線功能
英文描述: Synchronous 8-Bit Up/Down Binary Counters 24-SOIC 0 to 70
中文描述: 550kHz的同步開關穩壓器控制器加線性穩壓控制器
文件頁數: 11/28頁
文件大小: 343K
代理商: LTC1704B
LTC1704/LTC1704B
11
1704bfa
APPLICATIU
W
U
U
Overcurrent protection is achieved by limiting the drive
current. The input current at the REGILM pin programs the
current limit threshold. Refer to the Linear Regulator
Supply Current Limit Programming section for more
information on choosing R
REGILM
. The linear regulator
controller employs a foldback current limit scheme for
overcurrent protection. Under a short-circuit condition,
the external NPN transistor is subjected to the full input
voltage across its collector-emitter terminal. This increases
the power dissipation of the NPN and may eventually
cause damage to the transistor. LTC1704 overcomes this
problem by using a foldback current limit scheme whereby
the available drive current is reduced as the output voltage
at REGFB pin drops. This limits the power dissipation and
prevents catastrophic damage to the external NPN.
ARCHITECTURE DETAILS
Switcher Supply Architecture
The LTC1704 switcher supply is designed to operate as a
synchronous buck converter (Figure 1). The controller
includes two high power MOSFET gate drivers to control
the external N-channel MOSFETs QT and QB. The drivers
have 0.5
output impedances and can carry over an amp
of continuous current with peak currents up to 5A to slew
large MOSFET gates quickly. The drain of QT is connected
to the input supply and the source of QT connected to the
switching node SW. QB is the synchronous rectifier with
its drain at SW and its source at PGND. SW is connected
to one end of the inductor, with the other end connected
to V
OUTSW
. The output capacitor is connected from V
OUTSW
to PGND.
When a switching cycle begins, QB is turned off and QT is
turned on. SW rises almost immediately to V
IN
and the
inductor current begins to increase. When the PWM pulse
completes, QT turns off and one nonoverlap interval later,
QB turns on. Now SW drops to PGND and the inductor
current decreases. The cycle repeats with the next tick of
the master clock. The percentage of time spent in each
mode is controlled by the duty cycle of the PWM signal,
which in turn is controlled by the feedback amplifier. The
master clock runs at a 550kHz rate and turns QT once
every 1.8
μ
s. In a typical application with a 5V input and a
1.5V output, the duty cycle will be set at 1.5/5 100% or
30% by the feedback loop. This will give roughly a 540ns
on-time for QT and a 1.26
μ
s on-time for QB.
This constant frequency operation brings with it a couple
of benefits. Inductor and capacitor values can be chosen
with a precise operating frequency in mind and the feed-
back loop components can be similarly tightly specified.
Noise generated by the circuit will always be in a known
frequency band with the 550kHz frequency designed to
leave the 455kHz IF band free of interference. Subharmonic
oscillation and slope compensation, common headaches
with constant frequency current mode switchers, are
absent in voltage mode designs like the LTC1704. During
the time that QT is on, its source (the SW pin) is at V
IN
. V
IN
is also the power supply for the LTC1704. However, QT
requires V
IN
+ V
GS(ON)
at its gate to achieve minimum R
ON
.
The LTC1704, needs to generate a gate drive signal at TG
higher than its highest supply voltage. To accomplish this,
the TG driver runs from floating supplies, with its negative
supply attached to SW and its power supply at BOOST.
This allows it to slew up and down with the source of QT.
Figure 1. Synchronous Buck Architecture
TG
SW
BG
PGND
LTC1704
QT
C
IN
QB
L
+
C
OUTSW
1704 F01
V
OUTSW
V
IN
+
Figure 2. Floating TG Driver Supply
TG
C
CP
D
CP
BOOST
SW
BG
PGND
PV
CC
LTC1704
QT
C
IN
QB
L
+
C
OUTSW
1704 F02
V
OUTSW
V
IN
+
相關PDF資料
PDF描述
LTC1705 Dual 550kHz Synchronous Switching Regulator Controller with 5-Bit VID and 150mA LDO
LTC1705EGN Dual 550kHz Synchronous Switching Regulator Controller with 5-Bit VID and 150mA LDO
LTC1710 Synchronous 8-Bit Up/Down Binary Counters 24-PDIP 0 to 70
LTC1710C Synchronous 8-Bit Up/Down Binary Counters 24-PDIP 0 to 70
LTC1710CMS8 Dual 16-By-4 Register Files 24-SOIC 0 to 70
相關代理商/技術參數
參數描述
LTC1704BEGN 功能描述:IC REG DL BUCK/LINEAR 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓(降壓)同步(3),線性(LDO)(2) 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LTC1704BEGN#PBF 功能描述:IC REG DL BUCK/LINEAR 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓(降壓)同步(3),線性(LDO)(2) 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LTC1704BEGN#TR 功能描述:IC REG DL BUCK/LINEAR 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓(降壓)同步(3),線性(LDO)(2) 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LTC1704BEGN#TRPBF 功能描述:IC REG DL BUCK/LINEAR 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓(降壓)同步(3),線性(LDO)(2) 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LTC1704EGN 功能描述:IC REG DL BUCK/LINEAR 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓(降壓)同步(3),線性(LDO)(2) 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*