參數資料
型號: LTC1566-1
廠商: Linear Technology Corporation
英文描述: Low Noise 2.3MHz Continuous Time Lowpass Filter(低噪聲,2.3MHz,連續時間,低通濾波器)
中文描述: 低噪聲2.3MHz的連續時間低通濾波器(低噪聲,2.3MHz的,連續時間,低通濾波器)
文件頁數: 6/8頁
文件大?。?/td> 147K
代理商: LTC1566-1
LTC1566-1
6
a common mode voltage that is equal to one-half of the total
supply voltage. Figure 5 illustrates the THD versus output
common mode voltage for a 0.5V
P-P
/2.0V
P-P
differential
input/output voltage and a common mode input voltage
that is equal to one-half the total supply voltage.
Output DC Offset Control
A unique feature of the LTC1566-1 is the ability to introduce
a differential offset voltage at the output of the filter. As
seen in the “Block Diagram”, if a DC voltage is applied to Pin
5 with respect to Pin 3, the same voltage will be added to
the differential voltage seen between Pins 8 and7.
The output DC offset control pin can be used for sideband
suppression in differential modulators, calibration of A/D
converters, or simple signal summation. Since the voltage
summing occurs at the output of the filter, Pin 5 acts as a
unfiltered input. The response from Pin 5 to Pin 8 – Pin 7
with Pins 1,2 and 3 grounded is shown in Figure 7. The
range of voltages that can be applied to Pin 5 is shown in
Figure 6 where THD is plotted versus output offset. Pin 3 is
biased to mid supply.
Output Drive
Pins 7 and 8 can drive a 1k
or 300pF load connected to
AC ground with a
±
0.5V signal (corresponding to a 2V
P-P
differential signal). For differential loads (loads connected
across Pins 7 and 8) the outputs can produce a 2V
P-P
differential signal across 2k
or 150pF. For smaller signal
amplitudes the outputs can drive correspondingly larger
loads.
–5 –4
–2
0
2
4
–30
–40
–50
–60
–70
–80
–90
–3
–1
1
3
1566-1 F03
5
INPUT COMMON MODE VOLTAGE (V)
T
V
S
= 5V
V
S
=
±
5V
DIFFERENTIAL OUTPUT (V
P-P
)
0.5
T
–30
–40
–50
–60
–70
–80
–90
2.0
3.0
1566-1 F04
1.0
1.5
2.5
3.5
4.0
V
S
= 5V
V
S
=
±
5V
S/N
OUTPUT COMMON MODE VOLTAGE (V)
–4
T
–30
–40
–50
–60
–70
–80
–90
–1
2
1566-1 F05
–3
–2
1
0
3
4
V
S
= 5V
V
S
=
±
5V
Figure 3
Figure 4
Figure 5
APPLICATIU
W
U
U
Input Common Mode and Differential Voltage Range
The range of voltage each input can support while operat-
ing in its linear region is typically 0.8V to 3.7V for a single
5V supply and –4.2V to 3.2V for a
±
5V supply. Therefore,
the filter can accept a variety of common mode input
voltages. Figure 3 shows the total harmonic distortion of
the filter versus input common mode voltage with a
2V
P-P
differential output signal.
Figure 4 shows the total harmonic distortion and signal to
noise ratio versus differential output voltage level for both
a single 5V and a
±
5V supply. The common mode voltage
of the input signal is one-half the total power supply voltage
of the filter. The spurious free dynamic range (SFDR), the
level where the THD and S/N ratio are equal, is 72dB.
For best performance, the inputs should be driven differen-
tially. For single-ended signals, connect the unused input
to Pin 3 or a common mode reference.
The filter DC differential swings listed in the “Electrical
Characteristics” are measured with input differential volt-
ages of 0.9V
P-P
and 1.5V
P-P
for 5V and
±
5V supplies
respectively. Ideally the corresponding output levels would
be 3.6V
P-P
and 6V
P-P
. As seen in Figure 4, these levels are
above the range of linear operation. Input signals larger
than 0.9V
P-P
/1.5V
P-P
will result in phase inversion and
should be avoided.
Output Common Mode and Differential Voltage Range
The output is a fully differential signal with a common
mode level equal to the voltage at Pin 3 when Pin 5 is
shorted to Pin 3. The best performance is achieved using
相關PDF資料
PDF描述
LTC1569-7 Linear Phase, DC Accurate, Tunable, 10th Order Lowpass Filter(線性脈沖,直流精度,可調諧的10階低通濾波器)
LTC1623 SMBus Dual High Side Switch Controller(SMBus 雙高邊開關穩壓器)
LTC1654 Dual 14-Bit Rail-to-Rail DAC in 16-Lead SSOP Package(雙路14位,滿幅度電壓輸出數模轉換器(16腳SSOP封裝))
LTC1655 16-Bit Rail-to-Rail Micropower DACs in SO-8 Package(16位,微功耗滿幅度電壓輸出數模轉換器(SO-8封裝,內部基準2.048V))
LTC1655L 16-Bit Rail-to-Rail Micropower DACs in SO-8 Package(16位,微功耗滿幅度電壓輸出數模轉換器(SO-8封裝,內部基準1.25V))
相關代理商/技術參數
參數描述
LTC1566-1CS8 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC1566-1CS8#PBF 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC1566-1CS8#TR 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC1566-1CS8#TRPBF 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)
LTC1566-1IS8 功能描述:IC FILTER LP 7ORDER 2.3MHZ 8SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間,帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V,±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR)