- 您現在的位置：買賣IC網 > PDF目錄385504 > LTC1551 (Linear Technology Corporation) Low Noise, Switched Capacitor Regulated Voltage Inverters() PDF資料下載
參數資料
| 型號： | LTC1551 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Low Noise, Switched Capacitor Regulated Voltage Inverters() |
| 中文描述： | 低噪聲，開關電容穩壓逆變器（） |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 287K |
| 代理商： | LTC1551 |
7
LTC1550/LTC1551
except that the Shutdown pin is active-high (SHDN). All
members of the LTC1550 family feature a 900kHz charge
pump frequency. The LTC1550/ LTC1551 come standard
with fixed –4.1V output voltages and the LTC1550 is
available with an adjustable output voltage. Both devices
can be configured with other fixed output voltages; contact
Linear Technology for more information.
The LTC1550 consists of two major blocks (see Block
Diagram): an inverting charge pump and a negative linear
regulator. The charge pump uses two external capacitors,
C1 and C
CP
to generate a negative voltage at CP
OUT
. It
operates by charging and discharging C1 on alternate
phases of the internal 900kHz clock. C1 is initially charged
to V
CC
through switches S1 and S3. When the internal
clock changes phase, S1 and S3 open and S2 and S4 close,
shorting the positive side of C1 to ground. This forces the
negative side of C1 below ground, and charge is transferred
to C
CP
through S4. As this cycle repeats, the magnitude of
the negative voltage approaches V
CC
. The 900kHz internal
clock frequency helps keep noise out of 400kHz to 600kHz
IF bands commonly used by portable radio frequency
systems and reduces the size of the external capacitors
required. Most applications can use standard 0.1
μ
F ceramic
capacitors for C1 and C
CP
. Increasing C1 and C
CP
beyond
0.1
μ
F has little effect on the output ripple or the output
current capacity of the LTC1550/LTC1551.
The negative voltage at CP
OUT
supplies the input to the
negative regulator block. This block consists of an
N-channel MOSFET pass device and a feedback amplifier
that monitors the output voltage and compares it to the
internal reference. The regulated output appears at the
V
OUT
pin. The regulation loop is optimized for fast tran-
sient response, enabling it to remove most of the switch-
ing artifacts present at the CP
OUT
pin. Output ripple is
typically below 1mV
P-P
with output loads between 0mA
and 10mA. The output voltage is set to –4.1V by a pair of
internal divider resistors. The N-channel pass device mini-
mizes dropout, allowing the output to remain in regulation
with supply voltages as low as 4.5V. An output capacitor
of at least 4.7
μ
F from V
OUT
to ground is required to keep
the regulator loop stable; for optimum stability and mini-
mum output ripple, at least 10
μ
F is recommended.
APPLICATIO
S I
FOR
ATIO
U
W
U
U
6, 7
10
PGND, AGND
LTC1550
V
OUT
, SENSE
4, 11
ADJ
R1
R2
V
OUT
= –1.24VRR2
(
)
LTC1550/51 F02
Figure 1. External Resistor Connections
Adjustable Hook-Up
The LTC1550CGN is available in an adjustable output
version in a 16-pin SSOP package. The output voltage is
set with a resistor divider from GND to SENSE/V
OUT
(Figure 1). Note that the internal reference and the internal
feedback amplifier are set up as a positive-output regula-
tor referenced to the SENSE pin, not a negative regulator
referenced to ground. The output resistor divider must be
set to provide a 1.24V at the ADJ pin with respect to V
OUT
.
For example, a –3V output would require a 13k resistor
from GND to ADJ, and a 9.1k resistor to SENSE/V
OUT
. If,
after connecting the divider resistors, the output voltage is
not what you expected, try swapping them.
CAPACITOR SELECTION
The LTC1550/LTC1551 requires four external capacitors:
an input bypass capacitor, two 0.1
μ
F charge pump capaci-
tors and an output filter capacitor. The overall behavior of
the LTC1550/LTC1551 is strongly affected by the capaci-
tors used. In particular, the output capacitor has a signifi-
cant effect on the output ripple and noise performance.
Proper capacitor selection is critical for optimum perfor-
mance of the LTC1550/LTC1551.
Output Ripple vs Output Capacitor
Figure 3 shows the effect of using different output capaci-
tor values on LTC1550/LTC1551 output ripple. These
curves are taken using the circuit in Figure 2, with
C
IN
= 4.7
μ
F and I
LOAD
= 5mA. The upper curve shows the
performance with a standard tantalum capacitor alone and
the lower curve shows the tantalum capacitor in parallel
with a 0.1
μ
F ceramic capacitor. As a general rule, larger
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1553 | 5-Bit Programmable Synchronous Switching Regulator Controller for Pentium II Processor(用于奔騰II處理器的5位可編程同步開關穩壓器) |
| LTC1555L-1.8 | SIM Power Supply and Level Translator(SMI電源和電平轉換器) |
| LTC1555 | SIM Power Supply and Level Translator(SMI電源和電平轉換器) |
| LTC1556 | SIM Power Supply and Level Translator(SMI電源和電平轉換器) |
| LTC1559-5 | Backup Battery Controller with Fixed Output(帶固定輸出后備電池控制器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1551CS8-4.1 | 功能描述:IC REG SWITCHED CAP INV 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1551CS8-4.1#PBF | 功能描述:IC REG SWITCHED CAP INV 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1551CS8-4.1#TR | 功能描述:IC REG SWITCHED CAP INV 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1551CS8-4.1#TRPBF | 功能描述:IC REG SWITCHED CAP INV 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
| LTC1551LCMS8 | 功能描述:IC REG SWITCHD CAP INV ADJ 8MSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:升壓（升壓） 輸出類型:可調式 輸出數:1 輸出電壓:1.24 V ~ 30 V 輸入電壓:1.5 V ~ 12 V PWM 型:電流模式，混合 頻率 - 開關:600kHz 電流 - 輸出:500mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 包裝:帶卷 (TR) 供應商設備封裝:8-SOIC |
發布緊急采購，3分鐘左右您將得到回復。