- 您現在的位置：買賣IC網 > PDF目錄385504 > LTC1546 (Linear Technology Corporation) Software-Selectable Multiprotocol Transceiver with Termination(軟件-可選擇多協議3發3收收發器（帶終端）) PDF資料下載
參數資料
| 型號： | LTC1546 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Software-Selectable Multiprotocol Transceiver with Termination(軟件-可選擇多協議3發3收收發器（帶終端）) |
| 中文描述： | 軟件選擇多協議收發器與終端（軟件-可選擇多協議3發3收收發器（帶終端）） |
| 文件頁數： | 9/20頁 |
| 文件大?。?/td> | 267K |
| 代理商： | LTC1546 |
9
LTC1546
Figure 15. V.28 Driver Propagation Delays
Figure 16. V.28 Receiver Propagation Delays
V
IH
V
IL
1.3V
0.8V
1.7V
2.4V
t
PHL
V
OH
R
V
OL
A
t
PLH
1546 F16
3V
0V
1.5V
0V
–3V
3V
1.5V
0V
3V
SR = 6V
–3V
t
PHL
t
f
V
O
–V
O
D
A
t
PLH
t
r
1546 F15
SR = 6V
t
f
t
r
SWITCHU
W
W
Overview
The LTC1546 and LTC1544 form a complete software-
selectable DTE or DCE interface port that supports the
RS232, RS449, EIA530, EIA530-A, V.35, V.36 and X.21
protocols. Cable termination is provided on-chip, elimi-
nating the need for discrete termination designs.
A complete DCE-to-DTE interface operating in EIA530
mode is shown in Figure 17. The LTC1546 half of each port
is used to generate and appropriately terminate the clock
and data signals. The LTC1544 is used to generate the
control signals along with LL (Local Loopback).
Mode Selection
The interface protocol is selected using the mode select
pins M0, M1 and M2 (see Table 1).
For example, if the port is configured as a V.35 interface,
the mode selection pins should be M2 = 1, M1 = 0, M0 = 0.
For the control signals, the drivers and receivers will
operate in V.28 (RS232) electrical mode. For the clock and
data signals, the drivers and receivers will operate in V.35
electrical mode. The DCE/DTE pin will configure the port
for DCE mode when high, and DTE when low.
The interface protocol may be selected simply by plugging
the appropriate interface cable into the connector. The
mode pins are routed to the connector and are left uncon-
nected (1) or wired to ground (0) in the cable as shown in
Figure 18. The internal pull-up current sources will ensure
a binary 1 when a pin is left unconnected.
The mode selection may also be accomplished by using
jumpers to connect the mode pins to ground or V
CC
.
When the cable is removed, leaving all mode pins uncon-
nected, the LTC1546/LTC1544 will enter no-cable mode.
In this mode the LTC1546/LTC1544 supply current drops
to less than 500
μ
A and the LTC1546/LTC1544 driver
outputs are forced into a high impedance state. At the
same time, the R2 and R3 receivers of the LTC1546 are
differentially terminated with 103
and the other receiv-
ers on the LTC1546 and LTC1544 are terminated with
30k
to ground.
APPLICATIU
W
U
U
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1550 | Low Noise, Switched Capacitor Charge Pump Voltage Inverters(低噪聲，開關電容電荷泵電壓反相器) |
| LTC1551 | Low Noise, Switched Capacitor Regulated Voltage Inverters() |
| LTC1553 | 5-Bit Programmable Synchronous Switching Regulator Controller for Pentium II Processor(用于奔騰II處理器的5位可編程同步開關穩壓器) |
| LTC1555L-1.8 | SIM Power Supply and Level Translator(SMI電源和電平轉換器) |
| LTC1555 | SIM Power Supply and Level Translator(SMI電源和電平轉換器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1546CG | 功能描述:IC SW TRANSCEIVER W/TERM 28-SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1546CG#PBF | 功能描述:IC TXRX SOFTWARE SEL TERM 28SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:RS-232 & USB Transceiver 標準包裝:2,000 系列:- 類型:收發器 驅動器/接收器數:1/1 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:16-SSOP 包裝:帶卷 (TR) 其它名稱:296-19849-2 |
| LTC1546CG#TR | 功能描述:IC TXRX SOFTWARE SELECTBL 28SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1546CG#TRPBF | 功能描述:IC SW TRANSCEIVER W/TERM 28-SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1546IG | 功能描述:IC TXRX SOFTWARE SELECTBL 28SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。