- 您現在的位置：買賣IC網 > PDF目錄385504 > LTC1545 (Linear Technology Corporation) Software-Selectable Multiprotocol Transceiver(軟件-可選擇多協議5發5收收發器) PDF資料下載
參數資料
| 型號： | LTC1545 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Software-Selectable Multiprotocol Transceiver(軟件-可選擇多協議5發5收收發器) |
| 中文描述： | 軟件選擇多協議收發器（軟件-可選擇多協議5發5收收發器） |
| 文件頁數： | 12/16頁 |
| 文件大小： | 248K |
| 代理商： | LTC1545 |
12
LTC1545
APPLICATIO
S I
FOR
ATIO
U
Any mismatch in the driver rise and fall times or skew in
the driver propagation delays will force current through
the center termination resistor to ground, causing a high
frequency common mode spike on the A and B terminals.
The common mode spike can cause EMI problems that are
reduced by capacitor C1 which shunts much of the com-
mon mode energy to ground rather than down the cable.
W
U
U
DTE vs DCE Operation
The DCE/DTE pin acts as an enable for Driver 3/Receiver
1 in the LTC1543, and Driver 3/Receiver 1 in the LTC1545.
The LTC1543/LTC1545 can be configured for either DTE
or DCE operation in one of two ways: a dedicated DTE or
DCE port with a connector of appropriate gender, or a port
with one connector that can be configured for DTE or DCE
operation by rerouting the signals to the LTC1543/LTC1545
using a dedicated DTE cable or dedicated DCE cable.
A dedicated DTE port using a DB-25 male connector is
shown in Figure 22. The interface mode is selected by logic
outputs from the controller or from jumpers to either V
CC
or GND on the mode select pins. A dedicated DCE port
using a DB-25 female connector is shown in Figure 23.
A port with one DB-25 connector, can be configured for
either DTE or DCE operation is shown in Figure 24. The
configuration requires separate cables for proper signal
routing in DTE or DCE operation. For example, in DTE
mode, the TXD signal is routed to Pins 2 and 14 via Driver
1 in the LTC1543. In DCE mode, Driver 1 now routes the
RXD signal to Pins 2 and 14.
Compliance Testing
A European standard EN 45001 test report is available for
the LTC1343/LTC1545/LTC1344A chipset. A copy of the
test report is available from LTC or TUV Telecom Services
Inc. (formerly Detecon Inc.)
The title of the report is:
Test Report No. NET2/071601/98.
The address of TUV Telecom Services Inc. is:
TUV Telecom Services Inc.
Suite 107
1775 Old Highway 8
St. Paul, MN 55112 USA
Tel. +1 (612) 639-0775
Fax. +1 (612) 639-0873
No-Cable Mode
The no-cable mode (M0 = M1 = M2 = D4ENB = 1, R4EN = 0)
is intended for the case when the cable is disconnected
from the connector. The charge pump, bias circuitry,
drivers and receivers are turned off, the driver outputs are
forced into a high impedance state, and the supply current
drops to less than 200
μ
A.
Charge Pump
The LTC1543 uses an internal capacitive charge pump to
generate V
DD
and V
EE
as shown in Figure 21. A voltage
doubler generates about 8V on V
DD
and a voltage inverter
generates about –7.5V for V
EE
. Four 1
μ
F surface mounted
tantalum or ceramic capacitors are required for C1, C2, C3
and C4. The V
EE
capacitor C5 should be a minimum of
3.3
μ
F. All capacitors are 16V and should be placed as close
as possible to the LTC1543 to reduce EMI. The turn-on
time for the charge pump is 60ms.
28
27
26
25
1545 F21
3
2
1
4
C3
1
μ
F
C4
1
μ
F
5V
C1
1
μ
F
C2
1
μ
F
C5
3.3
μ
F
LTC1543
V
DD
C1
+
C1
–
V
CC
C2
+
C2
–
V
EE
GND
+
Figure 21. Charge Pump
Receiver Fail-Safe
All LTC1543/LTC1545 receivers feature fail-safe opera-
tion in all modes. If the receiver inputs are left floating or
shorted together by a termination resistor, the receiver
output will always be forced to a logic high.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1546 | Software-Selectable Multiprotocol Transceiver with Termination(軟件-可選擇多協議3發3收收發器（帶終端）) |
| LTC1550 | Low Noise, Switched Capacitor Charge Pump Voltage Inverters(低噪聲，開關電容電荷泵電壓反相器) |
| LTC1551 | Low Noise, Switched Capacitor Regulated Voltage Inverters() |
| LTC1553 | 5-Bit Programmable Synchronous Switching Regulator Controller for Pentium II Processor(用于奔騰II處理器的5位可編程同步開關穩壓器) |
| LTC1555L-1.8 | SIM Power Supply and Level Translator(SMI電源和電平轉換器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1545CG | 功能描述:IC TXRX SOFTWARE SELECTBL 36SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1545CG#PBF | 功能描述:IC TXRX SOFTWARE SELECT 36-SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1545CG#TR | 功能描述:IC TXRX SOFTWARE SELECTBL 36SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1545CG#TRPBF | 功能描述:IC TXRX SOFTWARE SELECTBL 36SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| LTC1545IG | 功能描述:IC TXRX SOFTWARE SELECTBL 36SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。