參數資料
型號: LTC1543IG#TRPBF
廠商: Linear Technology
文件頁數: 5/20頁
文件大?。?/td> 0K
描述: IC TXRX SOFTWARE SELECTBL 28SSOP
標準包裝: 2,000
類型: 收發器
驅動器/接收器數: 3/3
電源電壓: 4.75 V ~ 5.25 V
安裝類型: 表面貼裝
封裝/外殼: 28-SSOP(0.209",5.30mm 寬)
供應商設備封裝: 28-SSOP
包裝: 帶卷 (TR)
13
LTC1543
sn1534 1543fas
APPLICATIO S I FOR ATIO
WU
UU
No-Cable Mode
The no-cable mode (M0 = M1 = M2 = 1) is intended for the
case when the cable is disconnected from the connector.
The charge pump, bias circuitry, drivers and receivers are
turned off, the driver outputs are forced into a high
impedance state, and the supply current drops to less than
200
A.
Charge Pump
The LTC1543 uses an internal capacitive charge pump to
generate VDD and VEE as shown in Figure 22. A voltage
doubler generates about 8V on VDD and a voltage inverter
generates about – 7.5V for VEE. Four 1F surface mounted
tantalum or ceramic capacitors are required for C1, C2, C3
and C4. The VEE capacitor C5 should be a minimum of
3.3
F.Allcapacitorsare16Vandshouldbeplacedasclose
as possible to the LTC1543 to reduce EMI.
Receiver Fail-Safe
All LTC1543/LTC1544 receivers feature fail-safe opera-
tion in all modes. If the receiver inputs are left floating or
shorted together by a termination resistor, the receiver
output will always be forced to a logic high.
impedance of the receiver is placed in parallel with the T
network termination, but does not affect the overall input
impedance significantly.
The generator differential impedance must be 50
to
150
and the impedance between shorted terminals (A
and B) and ground C must be 150
±15. For the
generator termination, switches S1 and S2 are both on and
the top side of the center resistor is brought out to a pin so
it can be bypassed with an external capacitor to reduce
common mode noise as shown in Figure 21.
Any mismatch in the driver rise and fall times or skew in
the driver propagation delays will force current through
the center termination resistor to ground, causing a high
frequency common mode spike on the A and B terminals.
The common mode spike can cause EMI problems that are
reduced by capacitor C1 which shunts much of the com-
mon mode energy to ground rather than down the cable.
V.35 DRIVER
A
B
C
51.5
S2
ON
S1
ON
1543 F21
51.5
LTC1344A
124
C1
100pF
Figure 21. V.35 Driver Using the LTC1344A
28
27
26
25
1543 F22
3
2
1
4
C3
1
F
C4
1
F
5V
C1
1
F
C2
1
F
C5
3.3
F
LTC1543
VDD
C1+
C1
VCC
C2+
C2
VEE
GND
+
Figure 22. Charge Pump
相關PDF資料
PDF描述
LTC1544IG#TRPBF IC TXRX SOFTWARE SELECTBL 28SSOP
LTC1545CG IC TXRX SOFTWARE SELECTBL 36SSOP
LTC1590IS#TRPBF IC D/A CONV 12BIT DUAL 16-SOIC
LTC1592AIG#TRPBF IC D/A CONV 16BIT SOFTSPAN16SSOP
LTC1595AIN8 IC D/A CONV 16BIT MULTPLYNG 8DIP
相關代理商/技術參數
參數描述
LTC1544CG 功能描述:IC TXRX SOFTWARE SELECTBL 28SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LTC1544CG#PBF 功能描述:IC TXRX SOFTWARE SELECTBL 28SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:1 系列:- 類型:線路收發器 驅動器/接收器數:5/3 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:Digi-Reel® 產品目錄頁面:918 (CN2011-ZH PDF) 其它名稱:296-25096-6
LTC1544CG#TR 功能描述:IC TXRX SFTWR SEL DTE/DCE 28SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LTC1544CG#TRPBF 功能描述:IC TXRX SOFTWARE SELECTBL 28SSOP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:27 系列:- 類型:收發器 驅動器/接收器數:3/3 規程:RS232,RS485 電源電壓:4.75 V ~ 5.25 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC(0.295",7.50mm 寬) 供應商設備封裝:28-SOIC 包裝:管件
LTC1544IG 功能描述:IC TXRX SFTWR SEL DTE/DCE 28SSOP RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器,接收器,收發器 系列:- 標準包裝:250 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)