參數資料
型號： LTC1479
廠商： Linear Technology Corporation
英文描述： PowerPath Controller for Dual Battery Systems(雙電池系統電源通路控制器)
中文描述： PowerPath控制器的雙電池系統（雙電池系統電源通路控制器）
文件頁數： 14/24頁
文件大小： 374K
代理商： LTC1479
14
LTC1479
be high enough to withstand the maximum battery or
charger output voltage. In most cases, this will allow the
use of 20V MOSFET switches in the charger path, while
30V switches are used in the main power path.
Inrush Current Sense Resistor, R
SENSE
A small valued sense resistor (current shunt) is used by
the three main switch pair drivers to measure and limit the
inrush current flowing through the conducting switch
pair.
It should be noted that the inrush limiting circuit is not
intended to provide short-circuit protection; but rather, is
designed to limit the large peak currents which flow into or
out of the large power supply capacitors and the battery
packs during power supply switch-over transitions. The
inrush current limit should be set at approximately 2
×
or
3
×
the maximum required DC/DC input current.
For example, if the maximum current required by the
DC/DC converter is 2A, an inrush current limit of 6A is set
by selecting a 0.033
sense resistor, R
SENSE
, using the
following formula:
R
SENSE
= (200mV)/I
INRUSH
Note that the voltage drop across the resistor in this
example is only 66mV under normal operating conditions.
Therefore, the power dissipated in the resistor is extremely
small (132mW), and a small 1/4W surface mount resistor
can be used in this application. A number of small valued,
surface mount resistors are available that have been
specifically designed for high efficiency current sensing
applications.
DC Input Monitor Resistor Divider
The DCDIV input continuously monitors the DC power
supply voltage via a two resistor divider network, R
DC1
and
R
DC2
, as shown in Figure 5. The threshold voltage of the
DC good comparator is 1.215V when the power supply
input voltage is rising. Approximately –35mV of hyster-
esis is provided to ensure clean switching of the compara-
tor when the DC supply voltage is falling.
To minimize errors due to the input bias current of the DC
good comparator, set R
DC1
= 12.1k so that approximately
100
μ
A flows through the resistor divider when the desired
APPLICATIO
S I
N
FOR
ATIO
U
W
U
Figure 5. DC Monitor Resistor Divider
LTC1479
DCIN
DCDIV
DC
SUPPLY
TO SW A/B
R
DC1
12.1k
1%
R
DC2
1.215V
DCINGOOD
1479 F05
–
+
BATSEL
BAT1
BAT2
LOBAT
LTC1479
1479 F06
1.215V
V
BAT
BDIV
R
121k
1%
R
B2
1%
–
+
SWITCH
CONTROL
LOGIC
threshold is reached. R
DC2
is then selected according to
the following formula:
)
R
DC2
= 12.1k
– 1
V
GOOD
1.215V
)
Battery Monitor Resistor Divider
A switch controlled by the BATSEL input connects one of
the two batteries to the V
BAT
pin and therefore to the top
of the battery resistor divider as shown in Figure 6. The
threshold voltage of the low-battery comparator is 1.215V
when the battery voltage is falling. Approximately +35mV
of hysteresis is provided to ensure clean switching of the
comparator when the battery voltage rises again.
To minimize errors due to the input bias current of the low
battery comparator, assume R
B1
= 121k so that approxi-
mately 10
μ
A flows through the resistor divider when the
threshold is reached. R
B2
is selected according to the
following formula:
Figure 6. Battery Monitor Resistor Divider
相關PDF資料
PDF描述
LTC1487 Ultra-Low Power RS485 with Low EMI, Shutdown and High Input Impedance
LTC1487CN8 Ultra-Low Power RS485 with Low EMI, Shutdown and High Input Impedance
LTC1487CS8 Ultra-Low Power RS485 with Low EMI, Shutdown and High Input Impedance
LTC1520 Dual, Micropower, LinCMOS(TM) Voltage Comparator 8-PDIP -40 to 85
LTC1520CS 50Mbps Precision Quad Line Receiver
相關代理商/技術參數
參數描述
LTC1479CG 功能描述:IC CTRLR DUAL BATT SYS 36-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR)
LTC1479CG#PBF 功能描述:IC CTRLR DUAL BATT SYS 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2
LTC1479CG#TR 功能描述:IC CTRLR POWERPATH BATT 36SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR)
LTC1479CG#TRPBF 功能描述:IC CTRLR DUAL BATT SYS 36-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR)
LTC1479IG 功能描述:IC CNTRLR FORDUAL BATTSYS 36SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR)
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*