- 您現在的位置：買賣IC網 > PDF目錄385504 > LTC1473 (Linear Technology Corporation) Dual Power Management Switch Driver(雙電源管理開關驅動器) PDF資料下載
參數資料
| 型號： | LTC1473 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Dual Power Management Switch Driver(雙電源管理開關驅動器) |
| 中文描述： | 雙電源管理開關驅動器（雙電源管理開關驅動器） |
| 文件頁數： | 8/16頁 |
| 文件大?。?/td> | 199K |
| 代理商： | LTC1473 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
8
LTC1473
After the transition period, the V
GS
of both MOSFETs in the
selected switch pair rises to approximately 5.6V. The gate
drive is set at 5.6V to provide ample overdrive for standard
logic-level MOSFET switches without exceeding their
maximum V
GS
rating.
In the event of a fault condition the current limit loop will
limit the inrush current into the short. At the instant the
MOSFET switch is in current limit, i.e., when the voltage
drop across R
SENSE
is
±
200mV, a fault timer will start
timing. It will continue to time as long as the MOSFET
switch is in current limit. Eventually the preset time will
lapse and the MOSFET switch will latch off. The latch is
reset by deselecting the gate drive input. Fault time-out is
programmed by an external capacitor connected between
the TIMER pin and ground.
POWER PATH SWITCHING CONCEPTS
Power Source Selection
The LTC1473 drives low-loss switches to direct power in
the main power path of a single or dual rechargeable
battery system, the type found in many notebook comput-
ers and other portable equipment.
Figure 3 is a conceptual block diagram that illustrates the
main features of an LTC1473 dual battery power manage-
ment system starting with the three main power sources
and ending at the output load (i.e.: system DC/DC
regulator).
Switches SW A1/B1 and SW A2/B2 direct power from
either batteries to the input of the DC/DC switching regu-
lator. Each of the switches is controlled by a TTL/CMOS
compatible input that can interface directly with a power
management system
μ
P.
Using Tantalum Capacitors
The inrush (and “outrush”) current of the system DC/DC
regulator input capacitor is limited by the LTC1473, i.e.,
the current flowing both in and out of the capacitor during
transitions from one input power source to another is
limited. In many applications, this inrush current limiting
makes it feasible to use smaller tantalum surface mount
capacitors in place of larger aluminum electrolytics.
Note: The capacitor manufacturer should be consulted for
specific inrush current specifications and limitations and
some experimentation may be required to ensure compli-
ance with these limitations under all possible operating
conditions.
Back-to-Back Switch Topology
The simple SPST switches shown in Figure 3 actually
consist of two back-to-back N-channel switches. These
low-loss N-channel switch pairs are housed in 8-pin SO
and SSOP packaging and are available from a number of
manufacturers. The back-to-back topology eliminates the
problems associated with the inherent body diodes in
power MOSFET switches and allows each switch pair to
APPLICATIO
S I
FOR
ATIO
U
W
U
U
Figure 3. LTC1473 PowerPath Conceptual Diagram
BAT1
BAT2
INRUSH
CURRENT
LIMITING
SW A1/B1
SW A2/B2
+
HIGH
EFFICIENCY
DC/DC
SWITCHING
REGULATOR
5V
3.3V
1473 F03
12V
C
IN
DCIN
POWER
MANAGEMENT
μ
P
OUTPUT LOAD
LTC1473
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1474 | Low Quiescent Current High Efficiency Step-Down Converters(低靜態電流，高效率步降轉換器) |
| LTC1475 | Low Quiescent Current High Efficiency Step-Down Converters(低靜態電流，高效率步降轉換器) |
| LTC1479 | PowerPath Controller for Dual Battery Systems(雙電池系統電源通路控制器) |
| LTC1487 | Ultra-Low Power RS485 with Low EMI, Shutdown and High Input Impedance |
| LTC1487CN8 | Ultra-Low Power RS485 with Low EMI, Shutdown and High Input Impedance |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1473CGN | 功能描述:IC SWITCH DVR PWRPATH DUAL16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 標準包裝:1,000 系列:- 應用:電池備份，工業/汽車，大電流開關 FET 型:- 輸出數:5 內部開關:是 延遲時間 - 開啟:100ns 延遲時間 - 關閉:- 電源電壓:3 V ~ 5.5 V 電流 - 電源:250µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| LTC1473CGN#PBF | 功能描述:IC SWITCH DVR PWRPATH DUAL16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 標準包裝:1,000 系列:- 應用:電池備份，工業/汽車，大電流開關 FET 型:- 輸出數:5 內部開關:是 延遲時間 - 開啟:100ns 延遲時間 - 關閉:- 電源電壓:3 V ~ 5.5 V 電流 - 電源:250µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| LTC1473CGN#TR | 功能描述:IC DRIVER SWITCH DUAL 16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 標準包裝:1,000 系列:- 應用:電池備份，工業/汽車，大電流開關 FET 型:- 輸出數:5 內部開關:是 延遲時間 - 開啟:100ns 延遲時間 - 關閉:- 電源電壓:3 V ~ 5.5 V 電流 - 電源:250µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| LTC1473CGN#TRPBF | 功能描述:IC SWITCH DVR PWRPATH DUAL16SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 標準包裝:1,000 系列:- 應用:電池備份，工業/汽車，大電流開關 FET 型:- 輸出數:5 內部開關:是 延遲時間 - 開啟:100ns 延遲時間 - 關閉:- 電源電壓:3 V ~ 5.5 V 電流 - 電源:250µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
| LTC1473IGN | 功能描述:IC SWITCH DVR PWRPATH DUAL16SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - O 圈控制器 系列:PowerPath™ 標準包裝:1,000 系列:- 應用:電池備份，工業/汽車，大電流開關 FET 型:- 輸出數:5 內部開關:是 延遲時間 - 開啟:100ns 延遲時間 - 關閉:- 電源電壓:3 V ~ 5.5 V 電流 - 電源:250µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:16-SOIC N 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。