- 您現在的位置：買賣IC網 > PDF目錄10674 > LTC1400IS8#PBF (Linear Technology)IC A/D CONV 12BIT W/SHTDN 8-SOIC PDF資料下載
參數資料
| 型號： | LTC1400IS8#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 18/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC A/D CONV 12BIT W/SHTDN 8-SOIC |
| 標準包裝： | 100 |
| 位數： | 12 |
| 采樣率（每秒）： | 400k |
| 數據接口： | MICROWIRE?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 160mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個單端，單極；1 個單端，雙極 |
| 產品目錄頁面： | 1346 (CN2011-ZH PDF) |
LTC1400
7
1400fa
APPLICATIO S I FOR ATIO
W
U
Conversion Details
The LTC1400 uses a successive approximation algorithm
and an internal sample-and-hold circuit to convert an
analog signal to a 12-bit serial output based on a preci-
sion internal reference. The control logic provides easy
interface to microprocessors and DSPs through 3-wire
connections.
A rising edge on the CONV input starts a conversion. At
the start of a conversion the successive approximation
register (SAR) is reset. Once a conversion cycle has begun
it cannot be restarted.
During conversion, the internal 12-bit capacitive DAC
output is sequenced by the SAR from the most signicant
bit (MSB) to the least signicant bit (LSB). Referring to
Figure 1, the AIN input connects to the sample-and-hold
capacitor during the acquired phase and the comparator
offset is nulled by the feedback switch. In this acquire
phase, it typically takes 200ns for the sample-and-hold
capacitor to acquire the analog signal. During the convert
phase, the comparator feedback switch opens, putting the
comparator into the compare mode. The input switches
connect CSAMPLE to ground, injecting the analog input
charge onto the summing junction. This input charge is
successively compared with the binary-weighted charges
supplied by the capacitive DAC. Bit decisions are made by
the high speed comparator. At the end of a conversion,
the DAC output balances the AIN input charge. The SAR
contents (a 12-bit data word) which represent the input
voltage, are output through the serial pin DOUT.
1400 F01
SAMPLE
DOUT
CDAC
VDAC
DAC
AIN
CSAMPLE
–
+
COMP
S
A
R
SAMPLE
S1
HOLD
Figure 1. AIN Input
Dynamic Performance
TheLTC1400hasexcellenthighspeedsamplingcapability.
FFT (Fast Fourier Transform) test techniques are used to
test the ADC’s frequency response, distortion and noise
at the rated throughput. By applying a low distortion
sine wave and analyzing the digital output using an FFT
algorithm, the ADC’s spectral content can be examined for
frequencies outside the fundamental. Figure 2a shows a
typical LTC1400 FFT plot.
Signal-to-Noise Ratio
The signal-to-noise plus distortion ratio [S/(N + D)] is the
ratio between the RMS amplitude of the fundamental input
frequency to the RMS amplitude of all other frequency
components at the A/D output. The output is band limited
to frequencies from DC to half the sampling frequency.
Figure 2a shows a typical spectral content with a 400kHz
sampling rate and a 100kHz input. The dynamic perfor-
mance is excellent for input frequencies up to the Nyquist
limit of 200kHz as shown in Figure 2b.
FREQUENCY (kHz)
0
40
80 100
140
180
20
60
120
160
200
AMPLITUDE
(dB)
1400 F02a
0
–10
–20
–30
–40
–50
–60
–70
–80
–90
–100
–110
–120
fSAMPLE = 400kHz
fIN = 94.824kHz
SINAD = 72.5dB
THD = –82dB
Figure 2a. LTC1400 Nonaveraged, 4096 Point FFT
Plot with 100kHz Input Frequency in Bipolar Mode
Effective Number of Bits
The effective number of bits (ENOBs) is a measurement
of the effective resolution of an ADC and is directly related
to the S/(N + D) by the equation:
N
S N D
=
+
(
)
/
– .
.
1 76
6 02
相關PDF資料 |
PDF描述 |
|---|---|
| LTC2440CGN#PBF | IC ADC DIFFER 24-BIT HS 16-SSOP |
| LTC2225IUH#PBF | IC ADC 12-BIT 10MSPS 3V 32-QFN |
| AD7322BRUZ | IC ADC 12BIT+ SAR 2CHAN 14TSSOP |
| AD7942BRMZ | IC ADC 14BIT 250KSPS 10-MSOP |
| ISL4223EIRZ | IC TXRX 2TX/2RX 3V RS-232 20-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1401CS8 | 功能描述:IC A/D CONV 12BIT W/SHTDN 8-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC1401CS8#PBF | 功能描述:IC A/D CONV 12BIT W/SHTDN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
| LTC1401CS8#TR | 功能描述:IC ADC 12BIT 200KSPS SHTDN 8SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC1401CS8#TRPBF | 功能描述:IC A/D CONV 12BIT W/SHTDN 8-SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率（每秒）:15 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:1 功率耗散（最大）:480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN（5x7） 包裝:帶卷 (TR) 輸入數目和類型:16 個單端，雙極；8 個差分，雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| LTC1401CS8PBF | 制造商:Linear Technology 功能描述:ADC,LTC1401 12bit 200kSPS SPI SOIC |
發布緊急采購，3分鐘左右您將得到回復。