- 您現在的位置：買賣IC網 > PDF目錄11022 > LTC1164-5CN#PBF (Linear Technology)IC FILTR 8TH ORDER LOWPASS 14DIP PDF資料下載
參數資料
| 型號： | LTC1164-5CN#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 16/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC FILTR 8TH ORDER LOWPASS 14DIP |
| 標準包裝： | 25 |
| 濾波器類型： | 巴特沃斯或貝塞爾低通 |
| 頻率 - 截止或中心： | 20kHz |
| 濾波器數： | 1 |
| 濾波器階數： | 8th |
| 電源電壓： | 4.75 V ~ 16 V，±2.375 V ~ 8 V |
| 安裝類型： | 通孔 |
| 封裝/外殼： | 14-DIP（0.300"，7.62mm） |
| 供應商設備封裝： | 14-PDIP |
| 包裝： | 管件 |
LTC1164-5
9
11645fc
1k
1164-5 F03
–
+
LT1056
Figure 3. Buffer for Filter Output
PI FU CTIO S
UU
U
Butterworth/Bessel (Pin 10)
The DC level at Pin 10 determines the ratio of the clock
frequency to the cutoff frequency of the filter. Pin 10 at V
+
gives a 50:1 ratio and a Butterworth response (pins 1 to 13
are shorted for 50:1 only). Pin 10 at V
– gives a 100:1
Butterworth response. Pin 10 at ground gives a Bessel
response and a ratio of 140:1. For single supply operation
the ratio is 50:1 when Pin 10 is at V
+ (Pins 1 to 13 shorted),
100:1 when Pin 10 is at ground, and 140:1 when at 1/2
supply. When Pin 10 is not tied to ground, it should be
bypassed to analog ground with a 0.1
F capacitor. If the
DC level at Pin 10 is switched mechanically or electrically
at slew rates greater than 1V/
s while the device is
operating, a 10k resistor should be connected between
Pin 10 and the DC source.
Filter Input (Pin 2)
The input pin is connected internally through a 100k
resistor tied to the inverting input of an op amp.
Filter Output (Pins 9, 6)
Pin 9 is the specified output of the filter; it can typically
source or sink 1mA. Driving coaxial cables or resistive
loads less than 20k will degrade the total harmonic distor-
tion of the filter. When evaluating the device’s distortion an
output buffer is required. A noninverting buffer, Figure 3,
can be used provided that its input common mode range
is well within the filter’s output swing. Pin 6 is an interme-
diate filter output providing an unspecified 6th order
lowpass filter. Pin 6 should not be loaded.
External Connection (Pins 7, 14 and 1, 13)
Pins 7 and 14 should be connected together. In a printed
circuit board the connection should be done under the IC
package through a short trace surrounded by the analog
ground plane. When the clock to cutoff frequency ratio is
set at 50:1, Pin 1 should be shorted to Pin 13; if not, the
passband will exhibit 1dB of gain peaking and it will deviate
from a Butterworth response. Pin 1 is the inverting input
of an internal op amp and it should preferably be 0.2 inches
away from any other circuit trace.
NC (Pin 8)
Pin 8 is not connected to any internal circuit point on the
device and should be preferably tied to analog ground.
Table 2. Output Clock Feedthrough
VS
50:1
100:1
±2.5V
60
VRMS
60
VRMS
±5V
100
VRMS
200
VRMS
±7.5V
150
VRMS
500
VRMS
Note: The clock feedthrough at
±2.5V supplies is imbedded in the
wideband noise of the filter. The clock waveform is a square wave.
APPLICATIO S I FOR ATIO
WU
U
Clock Feedthrough
Clock feedthrough is defined as, the RMS value of the
clock frequency and its harmonics that are present at the
filter’s output pin (Pin 9). The clock feedthrough is tested
with the input pin (Pin 2) grounded and, it depends on PC
board layout and on the value of the power supplies. With
proper layout techniques the values of the clock feedthrough
are shown in Table 2.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1164-6CN#PBF | IC FILTR 8TH ORDER LOWPASS 14DIP |
| LTC6602CUF#TRPBF | IC FILTER BANDPASS/LOWPASS 24QFN |
| LTC1061CSW#TRPBF | IC FILTR BUILDNG BLK TRPL 20SOIC |
| LTC1061CSW#TR | IC BUILDING BLK TRPL FLTR 20SOIC |
| LTC1061CSW#PBF | IC FILTR BUILDNG BLK TRPL 20SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1164-5CS | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Low Power 8th Order Pin Selectable Butterworth or Bessel Lowpass Filter |
| LTC1164-5CSW | 功能描述:IC FILTR 8TH ORDR LOWPASS 16SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
| LTC1164-5CSW#PBF | 功能描述:IC FILTER 8TH ORD LOWPASS 16SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
| LTC1164-5CSW#TR | 功能描述:IC FILTER LP 8TH ORDER 16SOIC RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
| LTC1164-5CSW#TRPBF | 功能描述:IC FILTR 8TH ORDR LOWPASS 16SOIC RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。