- 您現在的位置：買賣IC網 > PDF目錄299419 > LTC1061AM (Linear Technology Corporation) High Performance Triple Universal Filter Building Block PDF資料下載
參數資料
| 型號： | LTC1061AM |
| 廠商： | Linear Technology Corporation |
| 英文描述： | High Performance Triple Universal Filter Building Block |
| 中文描述： | 三高性能通用濾波器積木 |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 352K |
| 代理商： | LTC1061AM |
12
LTC1061
ODES OF OPERATIO
W
U
Mode 2 – This is a combination of Mode 1 and Mode 3,
Figure 20. With Mode 2, the clock-to-center frequency
ratio, fCLK/fO, is always less than 50:1 or 100:1. When
compared to Mode 3 and for applications requiring 2nd
order section with fCLK/fO slightly less than 100 or 50:1,
Mode 2 provides less sensitivity to resistor tolerances. As
in Mode 1, Mode 2 has a notch output which directly
depends on the clock frequency and therefore the notch
frequency is always less than the center frequency, fO, of
the 2nd order section.
fIN (kHz)
1
0
V
OUT
/V
IN
(dB)
–90
–50
–30
–10
10
100
1061 F19
–80
–70
–60
–40
–20
4
STANDARD 1%
RESISTOR VALUES
R11 = 30.9k
R31 = 16.2k
Rh1 = 45.3k
R22 = 10.5k
R42 = 10k
Rl2 = 15.8k
R33 = 28.7k
Rh3 = 95.3k
Rg = 28k
R21 = 10k
R41 = 26.7k
Rl1 = 19.6k
R32 = 100k
Rh2 = 52.3k
R23 = 10k
R43 = 12.7k
Rl3 = 10k
NOTE: ADD A CAPACITOR C ACROSS Rg TO CREATE A 7TH ORDER
LOWPASS SUCH AS (1/2
πRgC) = (CUTOFF FREQUENCY) × 0.38
fCLK
200kHz
fCLK
500kHz
fCLK
1MHz
Figure 18 shows the plotted amplitude responses of a 6th
order notch filter operating again with a clock-to-center
notch frequency ratio of 250:1. The theoretical notch
depth is 70dB and when the notch is centered at 1kHz its
width is 50Hz. Two small, noncritical capacitors were used
across the R21 and R22 resistors of Figure 16, to band-
limit the first two highpass outputs such that the practical
notch depth will approach the theoretical value. With these
two fixed capacitors, the notch frequency can be swept
within a 3:1 range.
When the circuit of Figure 16 is used to realize lowpass
elliptic filters, a capacitor across Rg raises the order of the
filter and at the same time eliminates any small clock
feedthrough. This is shown in Figure 19 where the ampli-
tude response of the filter is plotted for 3 different cutoff
frequencies. When the clock frequency equals or exceeds
1MHz, the stopband notches lose their depth due to the
finite bandwidth of the internal op amps and to the small
crosstalk between the different sides of the LTC1061. The
lowpass filter, however, does not lose its passband accu-
racy and it maintains nearly all of its attenuation slope. The
theoretical performance of the 7th order lowpass filter of
Figure 19 is 0.2dB passband ripple, 1.5:1 stopband-to-
cutoff frequency ratio, and 73dB stopband attenuation.
Without any tuning, the obtained results closely approxi-
mate the textbook response.
fIN (kHz)
0
V
OUT
/V
IN
(dB)
–10
1.6
1061 F18
–30
–60
–70
0.2
0.8
1.2
2.0
–50
–40
–20
0
fCLK = 250kHz
0.4 0.6
1.0
1.4
1.8
STANDARD 1%
RESISTOR VALUES
R11 = 84.5k
R31 = 31.6k
Rh1 = 48.7k
R22 = 10k
R42 = 97.6k
Rl2 = 66.5k
R33 = 300k
Rh3 = 10.2k
Rg = 210k
R21 = 10.2k
R41 = 63.4k
Rl1 = 287k
R32 = 232k
Rh2 = 10.2k
R23 = 20k
R43 = 80.6k
l3 = 63.4k
NOTE: CONNECT 39pF AND
100pF ACROSS R21 AND R22
RESPECTIVELY.
Figure 19. Frequency Responses of a 7th Order Lowpass Elliptic
Filter Realized with Figure 16 Topology.
+
Σ
∫
AGND
R1
N
BP
LP
VIN
1061 F20
+
–
S
R2
R3
R4
fO =
; fn =
; Q =
HOLP =
; HOBP = –
HON1 (f → 0) =
; HON2
= –
fCLK
100(50)
R2
R1
R3
R2
–R2/R1
1 + (R2/R4)
R3
R1
fCLK
2
f
→
()
√1+ R2
R4
fCLK
100(50)
√1+ R2
R4
–R2/R1
1 + (R2/R4)
–
Figure 18. 6th Order Band Reject Filter Operating with a Clock-
to-Center Notch Frequency Ratio of 250:1. The Ratio of 0dB to
the – 65dB Notch Width is 8:1.
Figure 20. Mode 2: 2nd Order Filter Providing
Notch, Bandpass, Lowpass.
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1061C | High Performance Triple Universal Filter Building Block |
| LTC1061M | High Performance Triple Universal Filter Building Block |
| LTC1061CS | High Performance Triple Universal Filter Building Block |
| LTC1061S | High Performance Triple Universal Filter Building Block |
| LTC1062CJ8 | 5th Order Lowpass Filter |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LTC1061AMJ | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Performance Triple Universal Filter Building Block |
| LTC1061C | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Performance Triple Universal Filter Building Block |
| LTC1061CJ | 制造商:Linear Technology 功能描述:Active Filter Triple SW-CAP UNIV 6th Order 35kHz 20-Pin CDIP |
| LTC1061CN | 功能描述:IC FILTER BUILDNG BLK TRPL 20DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
| LTC1061CN#PBF | 功能描述:IC FILTER BUILDNG BLK TRPL 20DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 濾波器 - 有源 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 濾波器類型:連續時間，帶通低通 頻率 - 截止或中心:150kHz 濾波器數:4 濾波器階數:8th 電源電壓:4.74 V ~ 11 V，±2.37 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:28-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:28-SOIC W 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。