- 您現在的位置：買賣IC網 > PDF目錄44987 > LT6660HCDC-10#PBF (LINEAR TECHNOLOGY CORP) 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 10 V, PSSO3 PDF資料下載
參數資料
| 型號： | LT6660HCDC-10#PBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 10 V, PSSO3 |
| 封裝： | 2 X 2 MM, 0.75 MM, LEAD FREE, PLASTIC, MO-229W-TBD, DFN-3 |
| 文件頁數： | 7/12頁 |
| 文件大小： | 400K |
| 代理商： | LT6660HCDC-10#PBF |
LT6660
4
6660fa
OUTPUT CURRENT (mA)
0
OUTPUT
VOLTAGE
CHANGE
(mV)
20
40
60
80
100
120
1
2
3
4
–55
°C
6660 G03
5
125
°C
25
°C
OUTPUT CURRENT (mA)
0.1
–2.0
OUTPUT
VOLTAGE
CHANGE
(mV) –1.0
0
1
10
100
6660 G02
–3.0
–2.5
–1.5
–0.5
–3.5
–4.0
–55
°C
25
°C
125
°C
INPUT-OUTPUT VOLTAGE (V)
0
0.1
OUTPUT
CURRENT
(mA) 10
125
°C
25
°C
100
0.5
1.0
1.5
2.0
2.5
6660 G01
1
–55
°C
Characteristic curves are similar for all voltage
options of the LT6660. Curves from the LT6660-2.5 and the LT6660-10 represent the extremes of the voltage options. Characteristic
curves for other output voltages fall between these curves, and can be estimated based on their voltage output.
TYPICAL PERFOR A CE CHARACTERISTICS
U
W
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: The LT6660 is guaranteed functional over the operating
temperature range of –40°C to 85°C.
Note 3: If the parts are stored outside of the specied temperature range,
the output may shift due to hysteresis.
Note 4: Temperature coefcient is measured by dividing the change in
output voltage by the specied temperature range. Incremental slope is
also measured at 25°C.
Note 5: Load regulation is measured on a pulse basis from no load to the
specied load current. Output changes due to die temperature change
must be taken into account separately.
Note 6: Thermal regulation is caused by die temperature gradients created
by load current or input voltage changes. This effect must be added to
normal line or load regulation. This parameter is not 100% tested.
Note 7: Excludes load regulation errors.
Note 8: Peak-to-peak noise is measured with a single pole highpass lter
at 0.1Hz and 2-pole lowpass lter at 10Hz. The unit is enclosed in a still-air
environment to eliminate thermocouple effects on the leads. The test time
is 10 sec. RMS noise is measured with a single pole highpass lter at
10Hz and a 2-pole lowpass lter at 1kHz. The resulting output is full wave
rectied and then integrated for a xed period, making the nal reading an
average as opposed to RMS. A correction factor of 1.1 is used to convert
from average to RMS and a second correction of 0.88 is used to correct
for the nonideal bandpass of the lters.
Note 9: Long-term stability typically has a logarithmic characteristic
and therefore, changes after 1000 hours tend to be much smaller than
before that time. Total drift in the second thousand hours is normally less
than one third that of the rst thousand hours with a continuing trend
toward reduced drift with time. Long-term stability will also be affected by
differential stresses between the IC and the board material created during
board assembly.
Note 10: Hysteresis in output voltage is created by package stress that
differs depending on whether the IC was previously at a higher or lower
temperature. Output voltage is always measured at 25°C, but the IC
is cycled to 70°C or 0°C before successive measurements. Hysteresis
is roughly proportional to the square of the temperature change. For
instruments that are stored at well-controlled temperatures (within 20 or
30 degrees of operational temperature) hysteresis is not a problem.
ELECTRICAL CHARACTERISTICS
2.5V Minimum Input-Output
Voltage Differential
2.5V Load Regulation, Sourcing
2.5V Load Regulation, Sinking
相關PDF資料 |
PDF描述 |
|---|---|
| LT6660JCDC-10#TRPBF | 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 10 V, PSSO3 |
| LT8415IDDB#PBF | 0.03 A SWITCHING REGULATOR, PDSO12 |
| LT8415EDDB#TRMPBF | 0.03 A SWITCHING REGULATOR, PDSO12 |
| LT8415IDDB#TRPBF | 0.03 A SWITCHING REGULATOR, PDSO12 |
| LTC1043MD/883B | SPECIALTY ANALOG CIRCUIT, CDIP18 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT6660HCDC-2.5 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Tiny Micropower Precision Series References in 2mm × 2mm DFN |
| LT6660HCDC-2.5#PBF | 制造商:Linear Technology 功能描述:IC SM VOLT REF 2.5V 制造商:Linear Technology 功能描述:IC, SM, VOLT REF, 2.5V |
| LT6660HCDC-2.5#TR | 制造商:Linear Technology 功能描述:SC-Refs/Series, 2.5V Low Cost uP Prec Series Ref. |
| LT6660HCDC-2.5#TRMPBF | 功能描述:IC VREF SERIES PREC 2.5V 3-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電壓基準 系列:- 標準包裝:3,000 系列:- 基準類型:旁路，精度 輸出電壓:3V 容差:±0.5% 溫度系數:100ppm/°C 輸入電壓:- 通道數:1 電流 - 陰極:82µA 電流 - 靜態:- 電流 - 輸出:15mA 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-TSSOP（5 引線），SC-88A，SOT-353 供應商設備封裝:SC-70-5 包裝:帶卷 (TR) 其它名稱:296-20888-2 |
| LT6660HCDC-2.5#TRPBF | 功能描述:IC VREF SERIES PREC 2.5V 3-DFN RoHS:是 類別:集成電路 (IC) >> PMIC - 電壓基準 系列:- 產品培訓模塊:Voltage Reference Basics 標準包裝:100 系列:- 基準類型:旁路，精度 輸出電壓:4.096V 容差:±0.075% 溫度系數:50ppm/°C 輸入電壓:- 通道數:1 電流 - 陰極:1µA 電流 - 靜態:- 電流 - 輸出:10mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。