- 您現在的位置：買賣IC網 > PDF目錄44986 > LT3652HVEDD#TRPBF (LINEAR TECHNOLOGY CORP) BATTERY CHARGE CONTROLLER, PDSO12 PDF資料下載
參數資料
| 型號： | LT3652HVEDD#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | BATTERY CHARGE CONTROLLER, PDSO12 |
| 封裝： | 3 X 3 MM, LEAD FREE, PLASTIC, DFN-12 |
| 文件頁數： | 4/24頁 |
| 文件大?。?/td> | 250K |
| 代理商： | LT3652HVEDD#TRPBF |
LT3652HV
12
3652hvf
Bulk capacitance is a function of desired input ripple volt-
age (ΔVIN), and follows the relation:
CIN(BULK) = ICHG(MAX) (VBAT/VIN) / ΔVIN (μF)
Input ripple voltages above 0.1V are not recommended.
10μF is typically adequate for most charger applica-
tions.
Charge Current Programming
The LT3652HV charger is configurable to charge at aver-
age currents as high as 2A. Maximum charge current is
set by choosing an inductor sense resistor (RSENSE) such
that the desired maximum average current through that
sense resistor creates a 100mV drop, or:
RSENSE = 0.1 / ICHG(MAX)
where ICHG(MAX) is the maximum average charge current.
A 2A charger, for example, would use a 0.05Ω sense
resistor.
BOOST Supply
The BOOST bootstrapped supply rail drives the internal
switch and facilitates saturation of the switch transistor.
Operating range of the BOOST pin is 0V to 8.5V, as refer-
enced to the SW pin. Connect a 1μF or greater capacitor
from the BOOST pin to the SW pin.
The voltage on the decoupling capacitor is refreshed
through a diode, with the anode connected to either the
battery output voltage or an external source, and the
cathode connected to the BOOST pin. Rate the diode
average current greater than 0.1A, and reverse voltage
greater than VIN(MAX).
To refresh the decoupling capacitor with a rectifying diode
from the battery with battery float voltages higher than
8.4V, a >100mA Zener diode can be put in series with
the rectifying diode to prevent exceeding the BOOST pin
operating voltage range.
APPLICATIONS INFORMATION
Figure 1. Programming Maximum Charge
Current Using RSENSE
SW
BOOST
SENSE
BAT
RSENSE
LT3652HV
3652 F01
Figure 2. Zener Diode Reduces Refresh
Voltage for BOOST Pin
SW
BOOST
SENSE
BAT
LT3652HV
3652 F02
VIN / BOOST Start-Up Requirement
The LT3652HV operates with a VIN range of 4.95V to 34V,
however, a start-up voltage requirement exists due to
the nature of the non-synchronous step-down switcher
topology used for the charger. If there is no BOOST supply
available, the internal switch requires (VIN – VSW) ≥ 3.3V
to reliably operate. This requirement does not exist if the
BOOST supply is available and (VBOOST – VSW) > 2V.
When an LT3652HV charger is not switching, the SW pin
is at the same potential as the battery, which can be as
high as VBAT(FLT). As such, for reliable start-up, the VIN
supply must be at least 3.3V above VBAT(FLT). Once switch-
ing begins and the BOOST supply capacitor gets charged
such that (VBOOST – VSW) > 2V, the VIN requirement no
longer applies.
相關PDF資料 |
PDF描述 |
|---|---|
| LT3663EMS8E-3.3#PBF | 2.5 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PDSO8 |
| LT3663IMS8E-3.3#PBF | 2.5 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PDSO8 |
| LT3663IMS8E#TRPBF | 2.5 A SWITCHING REGULATOR, 1650 kHz SWITCHING FREQ-MAX, PDSO8 |
| LT3663HMS8E-3.3#TRPBF | 2.5 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PDSO8 |
| LT3663HMS8E-3.3#PBF | 2.5 A SWITCHING REGULATOR, 1100 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT3652HVEMSE#PBF | 功能描述:IC BATTERY CHARGER 2A 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 其它有關文件:STC3100 View All Specifications 特色產品:STC3100 - Battery Monitor IC 標準包裝:4,000 系列:- 功能:燃料，電量檢測計/監控器 電池化學:鋰離子（Li-Ion） 電源電壓:2.7 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-MiniSO 包裝:帶卷 (TR) 其它名稱:497-10526-2 |
| LT3652HVEMSE#PBF | 制造商:Linear Technology 功能描述:BATTERY CHARGER IC LEAD ACID LI-ION L 制造商:Linear Technology 功能描述:IC, BATTERY CHARGER, LITHIUM, 2A, MSOP12 |
| LT3652HVEMSE#TRPBF | 功能描述:IC BATTERY CHARGER 2A 12-MSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 電池管理 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 功能:電池監控器 電池化學:堿性，鋰離子，鎳鎘，鎳金屬氫化物 電源電壓:1 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:帶卷 (TR) |
| LT3652HVEMSE-PBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power Tracking 2A Battery Charger |
| LT3652HVEMSE-TRPBF | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Power Tracking 2A Battery Charger |
發布緊急采購，3分鐘左右您將得到回復。