參數資料
型號： LT3507AEFE#PBF
廠商： LINEAR TECHNOLOGY CORP
元件分類： 穩壓器
英文描述： SWITCHING REGULATOR, PDSO38
封裝： 4.40 MM, LEAD FREE, PLASTIC, TSSOP-38
文件頁數： 26/28頁
文件大小： 372K
代理商： LT3507AEFE#PBF
LT3507A
7
3507af
PIN FUNCTIONS
BIAS: The BIAS pin supplies the current to the LT3507A’s
internal regulator. This pin should be tied to the lowest
available voltage source above 3V (either VIN, VOUT or any
other available supply). The LDO pass transistor’s base
current is supplied from the BIAS pin if it is at least 0.8V
above the LDO DRIVE output.
BOOST1, BOOST2, BOOST3: The BOOST pins are used
to provide drive voltages, higher than the input voltage,
to the internal bipolar NPN power switches. These pins
must be tied through a diode from VOUT, VIN or another
supply greater than 2.5V.
DRIVE: The DRIVE pin provides the base drive for an
external NPN transistor used for the LDO regulator.
FB1, FB2, FB3: The FB pins are the negative inputs of the
error amplifiers. The LT3507A regulates each feedback pin
to the lesser of 0.8V or the TRK/SS pin voltage. Connect
the feedback resistor divider taps to these pins.
FB4: The FB4 pin is the negative input to the LDO error
amplifier. It is regulated to 0.8V through the LDO feedback
resistor divider.
GND: Ground. The underside exposed pad metal of the
package provides both electrical contact to ground and
good thermal contact to the printed circuit board. The
exposed pad must be soldered to a grounded pad on the
circuit board for proper operation.
OVLO:TheLT3507Agoesintoovervoltageshutdownwhen
this pin goes above 1.2V. If unused, the OVLO pin should
be tied to GND.
PGOOD1, PGOOD2, PGOOD3: The PGOOD pins are the
open-collector outputs of an internal comparator. PGOOD
remains low until the FB pin is within 10% of the final
regulation voltage. As well as indicating output regulation,
the PGOOD pins can sequence the switching regulators.
Thesepinsmustbeleftunconnectedifunused.ThePGOOD
outputs are valid when VIN is greater than 3.5V and any of
the RUN pins are high. They are not valid when all RUN
pins are low.
RT/SYNC: The RT/SYNC pin requires a resistor to ground
or a clock signal to set the operating frequency of the
LT3507A.
RUN1, RUN2, RUN3: The RUN pins are used to shut down
the individual switching regulators. When all three RUN
pins are low, the LT3507A shuts down and draws less
than 1A from VIN1.
SW1, SW2, SW3: The SW pins are the outputs of the
internal power switches. Connect these pins to the induc-
tors and switching diodes.
TRK/SS1,TRK/SS2,TRK/SS3,TRK/SS4:TheTRK/SSpins
allow a regulator to track the output of another regulator.
When the TRK/SS pin is below 0.8V, the FB pin regulates
to the TRK/SS voltage. This pin souces 1.25A and can
be used as a soft-start by connecting a capacitor from
TRK/SS to ground. The TRK/SS pins should be left open
if neither feature is used.
UVLO: The LT3507A goes into undervoltage shutdown
when this pin drops below 1.2V. If unused, the UVLO pin
should be tied to VINSW.
VC1, VC2, VC3: The VC pins are the outputs of the internal
error amps. The voltages on these pins control the peak
switch currents. These pins are normally used to com-
pensate the control loops. Each switching regulator can
be shut down by pulling its respective VC pin to ground
with an NMOS or NPN transistor.
VIN1: The VIN1 pins supply power to the internal switch of
the 2.7A regulator and to the LT3507A’s internal reference
andstart-upcircuitry.Thesepinsmustbelocallybypassed.
VIN2/VIN3: The VIN2 and VIN3 pins supply power to the
internal switches of the 1.8A converters. These pins must
be locally bypassed.
VINSW: The VINSW pin is a switched VIN1 for the user pro-
grammable undervoltage and overvoltage detection. It is
connectedtoVIN1whenanyoftheRUNpinsarepulledhigh,
and high impedance when all RUN pins are low or open.
相關PDF資料
PDF描述
LT3507AHUHF#PBF SWITCHING REGULATOR, PQCC38
LT3507AEUHF#TRPBF SWITCHING REGULATOR, PQCC38
LT3507AIFE#TRPBF SWITCHING REGULATOR, PDSO38
LT3507AEUHF#PBF SWITCHING REGULATOR, PQCC38
LT3508IUF#TR 3.2 A DUAL SWITCHING CONTROLLER, 1060 kHz SWITCHING FREQ-MAX, PQCC24
相關代理商/技術參數
參數描述
LT3507AEUHF#PBF 功能描述:IC REG QD BUCK/LINEAR 38QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LT3507AEUHF#TRPBF 功能描述:IC REG QD BUCK/LINEAR 38QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LT3507AHFE#PBF 功能描述:IC REG QD BUCK/LINEAR 38TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LT3507AHFE#TRPBF 功能描述:IC REG QD BUCK/LINEAR 38TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
LT3507AHUHF#PBF 功能描述:IC REG QD BUCK/LINEAR 38QFN RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 + 切換式 系列:- 標準包裝:2,500 系列:- 拓?fù)?降壓（降壓）同步（3），線性（LDO）（2） 功能:任何功能 輸出數:5 頻率 - 開關:300kHz 電壓/電流 - 輸出 1:控制器 電壓/電流 - 輸出 2:控制器 電壓/電流 - 輸出 3:控制器 帶 LED 驅動器:無 帶監控器:無 帶序列發生器:是 電源電壓:5.6 V ~ 24 V 工作溫度:-40°C ~ 85°C 安裝類型:* 封裝/外殼:* 供應商設備封裝:* 包裝:*
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*