- 您現在的位置：買賣IC網 > PDF目錄5306 > LT1994CMS8#TRPBF (Linear Technology)IC DIFF AMP/DRIVER LN 8-MSOP PDF資料下載
參數資料
| 型號： | LT1994CMS8#TRPBF |
| 廠商： | Linear Technology |
| 文件頁數： | 4/20頁 |
| 文件大小： | 0K |
| 描述： | IC DIFF AMP/DRIVER LN 8-MSOP |
| 標準包裝： | 2,500 |
| 放大器類型： | 差分 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 65 V/µs |
| 增益帶寬積： | 70MHz |
| 電流 - 輸入偏壓： | 18µA |
| 電壓 - 輸入偏移： | 3000µV |
| 電流 - 電源： | 14.8mA |
| 電流 - 輸出 / 通道： | 85mA |
| 電壓 - 電源，單路/雙路(±)： | 2.375 V ~ 12.6 V，±1.188 V ~ 6.3 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-TSSOP，8-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 8-MSOP |
| 包裝： | 帶卷 (TR) |
LT1994
12
1994fb
VICM is dened as the average of the two input voltages,
VINP and VINM (also called the input common mode
voltage):
VV
V
ICM
INP
INM
=+
()
1
2
and VINDIFF is dened as the difference of the input
voltages:
VINDIFF = VINP – VINM
When the feedback ratios mismatch (
Δβ), common mode
to differential conversion occurs.
Setting the differential input to zero (VINDIFF = 0), the de-
gree of common mode to differential conversion is given
by the equation:
VV
V
VV
V
OUTDIFF
OUT
ICM
OCM
AVG
INDIFF
–
0
In general, the degree of feedback pair mismatch is a source
of common mode to differential conversion of both signals
and noise. Using 1% resistors or better will provide about
28dB of common mode rejection. Using 0.1% resistors
will provide about 48dB of common mode rejection. A low
impedance ground plane should be used as a reference
for both the input signal source and the VOCM pin. A direct
short of VOCM to this ground plane or bypassing the VOCM
with a high quality 0.1μF ceramic capacitor to this ground
plane will further mitigate against common mode signals
from being converted to differential.
Input Impedance and Loading Effects
The input impedance looking into the VINP or VINM input
of Figure 1 depends on whether or not the sources VINP
and VINM are fully differential. For balanced input sources
(VINP = –VINM), the input impedance seen at either input
is simply:
RINP = RINM = RI
For single-ended inputs, because of the signal imbalance
at the input, the input impedance actually increases over
the balanced differential case. The input impedance looking
into either input is:
RR
R
RR
INP
INM
I
F
IF
==
+
1
2
–
Input signal sources with non-zero output impedances can
also cause feedback imbalance between the pair of feedback
networks. For the best performance, it is recommended
that the source’s output impedance be compensated for.
If input impedance matching is required by the source,
R1 should be chosen (see Figure 3):
R
RR
INM
S
INM
S
1
=
According to Figure 3, the input impedance looking into
the differential amp (RINM)reectsthesingle-endedsource
case, thus:
R
RR
INM
I
F
IF
=
+
1
2
–
R2 is chosen to balance R1||RS:
R
RR
S
2
1
=
+
Figure 3. Optimal Compensation for Signal-Source Impedance
1994 F03
RI
RF
RS
VS
+
–
+
LT1994
RI
RF
R2 = RS || R1
R1 CHOSEN SO THAT R1 || RINM = RS
R2 CHOSEN TO BALANCE R1 || RS
R1
RINM
APPLICATIONS INFORMATION
相關PDF資料 |
PDF描述 |
|---|---|
| TA35-C2F4F050C0 | CIRCUIT BRKR THERMAL 5A 1POLE |
| 8564-4500PL | CONN SOCKET PCB VERT 64POS .1" |
| LTC6244CDD#TRPBF | IC OP AMP DUAL R-R 8-DFN |
| 0459844113 | CONN RCPT R/A 4PWR 12SGL 1.57MM |
| LTC6244CMS8#TRPBF | IC OP AMP DUAL R-R 8-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1994HDD#PBF | 功能描述:IC DIFF AMP/DRIVER LN-LD 8-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LT1994HDD#TR | 制造商:Linear Technology 功能描述:DIFF-AMPLIFIER, 70MHZ, 65V/US, DFN-8, No. of Amplifiers:1, Input Offset Voltage:2mV, Bandwidth:70MHz, Amplifier Case Style:DFN, No. of Pins:8, Supply Voltage Range:2.375V to 12.6V, Slew Rate:65V/s, Supply Current:14.8mA, MSL:- , RoHS Compliant: No |
| LT1994HDD#TRPBF | 功能描述:IC DIFF AMP/DRIVER LN-LD 8-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源，單路/雙路(±):1.8 V ~ 5.25 V，±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:10-MSOP 包裝:管件 |
| LT1994IDD | 制造商:Linear Technology 功能描述:SP Amp DIFF AMP Single R-R O/P ±6.3V/12.6V 8-Pin DFN EP |
| LT1994IDD#PBF | 功能描述:IC DIFF AMP/DRIVER LN 8-DFN RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
發布緊急采購，3分鐘左右您將得到回復。