- 您現在的位置：買賣IC網 > PDF目錄3434 > LT1970IFE#TR (Linear Technology)IC OPAMP ADJ PREC 500MA 20TSSOP PDF資料下載
參數資料
| 型號： | LT1970IFE#TR |
| 廠商： | Linear Technology |
| 文件頁數： | 15/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP ADJ PREC 500MA 20TSSOP |
| 標準包裝： | 2,500 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 轉換速率： | 1.6 V/µs |
| 增益帶寬積： | 3.6MHz |
| 電流 - 輸入偏壓： | 160nA |
| 電壓 - 輸入偏移： | 200µV |
| 電流 - 電源： | 7mA |
| 電流 - 輸出 / 通道： | 800mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 36 V，±2.5 V ~ 18 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬）裸露焊盤 |
| 供應商設備封裝： | 20-TSSOP-EP |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
LT1970
22
1970fc
APPLICATIONS INFORMATION
For motor speed control without using a tachometer, the
circuit in Figure 14 shows an approach. Using the en-
able feature of the LT1970, the drive to the motor can be
removed periodically. With no drive applied, the spinning
motor presents a back EMF voltage proportional to its
rotational speed. The LT1782 is a tiny rail-to-rail amplier
with a shutdown pin. The amplier is enabled during this
interval to sample the back EMF voltage across the motor.
This voltage is then buffered by one-half of an LT1638 dual
op amp and used to provide the feedback to the LT1970
integrator. When re-enabled the LT1970 will adjust the drive
to the motor until the speed feedback voltage, compared
to the speed-set input voltage, settles the output to a xed
value. A 0V to 5V signal for the motor speed input controls
both rotational speed and direction.
The other half of the LT1638 is used as a simple pulse
oscillator to control the periodic sampling of the motor
back EMF.
Figure 15 shows how easy it is to boost the output current
of the LT1970. This ±5A power stage uses complementary
external N- and P-channel MOSFETs to provide the ad-
ditional current. The output stage power supply inputs,
V+ and V–, are used to provide gate drive as needed. With
higher output currents, the sense resistor RCS, is reduced
in value to maintain the same easy current limit control.
This Class B power stage is intended for DC and low
frequency, <1kHz, applications as crossover distortion
becomes evident at higher frequencies.
Figure 15 shows some optional resistor dividers between
the output connections and the current sense inputs. They
are required only if the load of this power stage is removed
or at a very low current level. Large power devices with
no load on them can saturate and pull the output voltage
very close to the power supply rails. The current sense
ampliers operate properly with input voltages at least
1V away from the VCC and VEE supply rails. In boosted
current applications, it may be necessary to attenuate the
maximum output voltage levels by 1V before connecting
to the sense input pins. This only slightly deceases the
current limit thresholds.
相關PDF資料 |
PDF描述 |
|---|---|
| 77317-112-20LF | BERGSTIK |
| MCP601-E/P | IC OPAMP CMOS SGL 2.7V 8-DIP |
| 78207-120 | FRICTION LATCH HEADER DR R/A |
| 1-1761685-0 | IDC LOW PRO HDR 30P VERT SHT LAT |
| 3793-6003 | CONN HEADER 10POS STR NO LATCH |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1976 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:Monolithic Dual Tracking 3A Step-Down Switching |
| LT1976B | 制造商:LINER 制造商全稱:Linear Technology 功能描述:High Voltage 1.5A, 200kHz Step-Down Switching Regulator with 100μA Quiescent Current |
| LT1976BEFE | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 2.4V to 60V 16-Pin TSSOP EP |
| LT1976BEFE#PBF | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
| LT1976BEFE#TRPBF | 功能描述:IC REG BUCK ADJ 1.5A 16TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V，1.5V，1.8V，2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP，10-MSOP（0.118"，3.00mm 寬）裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤 |
發布緊急采購，3分鐘左右您將得到回復。