- 您現在的位置：買賣IC網 > PDF目錄6029 > LT1970CFE#PBF (Linear Technology)IC OPAMP ADJ CURR LIMIT 20-TSSOP PDF資料下載
參數資料
| 型號： | LT1970CFE#PBF |
| 廠商： | Linear Technology |
| 文件頁數： | 8/26頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP ADJ CURR LIMIT 20-TSSOP |
| 標準包裝： | 74 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 轉換速率： | 1.6 V/µs |
| 增益帶寬積： | 3.6MHz |
| 電流 - 輸入偏壓： | 160nA |
| 電壓 - 輸入偏移： | 200µV |
| 電流 - 電源： | 7mA |
| 電流 - 輸出 / 通道： | 800mA |
| 電壓 - 電源，單路/雙路(±)： | 5 V ~ 36 V，±2.5 V ~ 18 V |
| 工作溫度： | 0°C ~ 70°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬）裸露焊盤 |
| 供應商設備封裝： | 20-TSSOP-EP |
| 包裝： | 管件 |
| 產品目錄頁面： | 1320 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁
LT1970
16
1970fc
APPLICATIONS INFORMATION
Figure 6 shows the LT1970 driving an inductive load with
a controlled amount of current. This load is shown as
a generic magnetic transducer, which could be used to
create and modulate a magnetic eld. Driving the current
limit control inputs directly forces a current through the
load that could range up to 2MHz in modulation. Biasing
the input stage to the midpoint of the modulation signal
allows symmetrical bidirectional current ow through
the load. Clamp diodes are added to protect the LT1970
output from large inductive yback potentials caused by
rapid di/dt changes.
Abrupt Load Short Protection
An abrupt short-circuit connection, often referred to as
screwdriver or crowbar short, to ground or other supply
potentials is the worst-case load condition for the LT1970.
The current limit sense amplier normally operates with
an input voltage differential equal to the voltage across the
sense resistor, which is only 500mV maximum in a typical
application. During an abrupt load short to ground, the
load end of the sense resistor is immediately connected to
ground while the amplier output remains at the normal
output voltage. This can impose a large differential voltage
to the sense amplier inputs for a brief period. If this delta
V can be greater than ±2V, it is benecial to add clamps
between the current limit sense amplier inputs. These
clamps ensure a smooth transition from the main amplier
control to the current limit amplier control under all load
short conditions that may arise.
Figure 7 shows the connection of these back-to-back
clamp diodes between the FILTER pin and the SENSE+ pin.
With this connection, the internal 1k resistor between the
SENSE– pin and the FILTER pin limits the diode current. The
BAV99 diodes are small SOT-23 packaged general purpose
silicon diodes. The maximum current limit sense voltage
is now the diode voltage drop, determined by the voltage
across the sense resistor and the 1k internal resistor. As
the diode begins to conduct current, with a voltage drop
of around 300mV, an error in the expected current limit
level at the high end of the control becomes apparent, as
Figure 6. Current Modulation of a Magnetic Transducer
Figure 7. Adding Protection for Abrupt Load Shorts
4
5
1k
100Ω*
SENSE+
OUT
FILTER
SENSE–
*OPTIONAL—SEE TEXT
SENSE+
FILTER
12
3
RSENSE
BAV99
LOAD
2N3904
1970 F07
HIGHER CLAMP VOLTAGE
ALTERNATIVE
2N3904
1nF TO 10nF
–
+
6
3
MAIN
AMPLIFIER
CURRENT
LIMIT SENSE
AMPLIFIER
VCSRC
COMMON
VEE
VCSNK
V–
FILTER
V+
12V
EN
VCC
ISNK
ISRC
SENSE–
SENSE+
TSD
OUT
D2
1N4001
C1
500pF
R1
95.3K
LT1634-2.5
+IN
5V
VIN
0V
LT1970
–12V
–IN
12V
2.5V
RS
1Ω
±500mA
MAGNETIC
TRANSDUCER
1970 F06
D1
1N4001
相關PDF資料 |
PDF描述 |
|---|---|
| PEC01DBEN | CONN HEADER .100 DUAL R/A 2POS |
| PEC02DAGN | CONN HEADER .100 DUAL STR 4POS |
| PEC11DABN | CONN HEADER .100 DUAL STR 22POS |
| PBC20SBAN | CONN HEADER .100 SINGL R/A 20POS |
| AD746JRZ | IC OPAMP BIFET 13MHZ DUAL 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1970IFE | 功能描述:IC OP AMP 500MA ADJ 20-TSSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| LT1970IFE#PBF | 功能描述:IC OP AMP 500MA ADJ 20-TSSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| LT1970IFE#PBF | 制造商:Linear Technology 功能描述:OP-AMP PRECISION 3.6MHZ 1.6 制造商:Linear Technology 功能描述:OP-AMP, PRECISION, 3.6MHZ, 1.6V/uS, TSSO |
| LT1970IFE#TR | 功能描述:IC OPAMP ADJ PREC 500MA 20TSSOP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
| LT1970IFE#TRPBF | 功能描述:IC OP AMP 500MA ADJ 20-TSSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。