- 您現在的位置：買賣IC網 > PDF目錄384632 > LT1950 (Linear Technology Corporation) Single Switch PWM Controller with Auxiliary Boost Converter PDF資料下載
參數資料
| 型號： | LT1950 |
| 廠商： | Linear Technology Corporation |
| 英文描述： | Single Switch PWM Controller with Auxiliary Boost Converter |
| 中文描述： | 單開關PWM控制器，帶有輔助升壓轉換器 |
| 文件頁數： | 7/20頁 |
| 文件大?。?/td> | 285K |
| 代理商： | LT1950 |
LT1950
7
sn1950 1950fs
BLANK (Pin 9):
The BLANK pin is used to adjust the
leading edge blanking period of the current sense amplifier
during FET turn-on. Shorting the BLANK pin to ground
provides a default blanking period of approximately 110ns.
A resistor from the BLANK pin to ground increases the
blanking period up to 290ns for R
BLANK
= 75k.
I
SENSE
(Pin 10):
The I
SENSE
pin is the current sense input
for the control loop. Connect this pin to the sense resistor
in the source of the external power MOSFET.
V
IN2
(Pin 11):
The V
IN2
pin is the supply pin for the
MOSFET gate drive circuit. Power can be supplied to this
pin by an external supply such as V
IN
, and must exceed 8V
(the undervoltage lockout threshold for the gate driver
supply). For low V
IN
supply voltages an internal boost
regulator can be used to generate as much as 11V at the
V
IN2
pin. This allows the LT1950 to run with V
IN
supply
voltages down to 3V while still supplying enough gate
drive for standard level MOSFETs.
GATE (PIN 12):
The GATE pin is the output of a high current
gate drive circuit used to drive an external MOSFET. The
output is actively clamped to a max voltage of 13V if V
IN2
is supplied by a high voltage.
PGND (Pin 13):
This is the ground connection for the high
current gate driver stage. See the Applications Informa-
tion section for recommendations on ground connec-
tions.
PIU
BOOST (Pin 14):
The BOOST pin is the NPN collector
output of the internal boost converter which can be used
to generate an 11V supply for the MOSFET gate driver
circuit. The boost converter runs with a fixed off-time of
0.5
μ
s and a current limit of 125mA. The converter runs
until the V
IN2
voltage exceeds 11V and then turns off until
the V
IN2
voltage drops below 10V. If the V
IN2
voltage is
supplied externally, the BOOST pin should be shorted to
ground or left open.
V
IN
(Pin 15):
The V
IN
pin is the main supply pin for the
LT1950. This pin must be closely bypassed to ground. If
V
IN2
is generated using the BOOST pin then the LT1950
will be fully functional, internal V
REF
will be active and the
gate output will be enabled with a V
IN
voltage as low as 3V.
An internal undervoltage lockout threshold exists at ap-
proximately 2.6V on the V
IN
pin. Undervoltage lockout
voltages greater than 3V can be programmed using a
voltage divider on the SHDN pin.
V
SEC
(Pin 16):
The V
SEC
pin is used to program the
maximum duty cycle of the gate driver circuit. The maxi-
mum duty cycle will be equal to (105/V
SEC
)% for V
SEC
between 1.4V and 2.8V. This is a useful function to limit the
flyback voltage in a forward converter. If the maximum
duty cycle function is not used then the V
SEC
pin should be
tied to ground.
相關PDF資料 |
PDF描述 |
|---|---|
| LT1950EGN | Single Switch PWM Controller with Auxiliary Boost Converter |
| LT1950IGN | Single Switch PWM Controller with Auxiliary Boost Converter |
| LT60400-1 | Class T Fuse Blocks - 300 and 600 Volt |
| LT60600-1 | Class T Fuse Blocks - 300 and 600 Volt |
| LT60030-1 | Class T Fuse Blocks - 300 and 600 Volt |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1950EGN | 功能描述:IC REG CTRLR PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LT1950EGN#PBF | 功能描述:IC REG CTRLR PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LT1950EGN#TR | 功能描述:IC REG CTRLR PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LT1950EGN#TRPBF | 功能描述:IC REG CTRLR PWM CM 16-SSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
| LT1950IGN | 功能描述:IC REG CTRLR PWM CM 16-SSOP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 切換控制器 系列:- 標準包裝:2,500 系列:- PWM 型:電流模式 輸出數:1 頻率 - 最大:500kHz 占空比:96% 電源電壓:4 V ~ 36 V 降壓:無 升壓:是 回掃:無 反相:無 倍增器:無 除法器:無 Cuk:無 隔離:無 工作溫度:-40°C ~ 125°C 封裝/外殼:24-WQFN 裸露焊盤 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。