• <li id="pcolj"><form id="pcolj"></form></li>
  • <var id="pcolj"><input id="pcolj"></input></var>
  • <thead id="pcolj"><acronym id="pcolj"></acronym></thead>
  • <table id="pcolj"></table>
  • 參數資料
    型號: LT1701-7DFB1
    廠商: POWER-ONE INC
    元件分類: 電源模塊
    英文描述: 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE
    封裝: CASE T01, MODULE
    文件頁數: 32/33頁
    文件大?。?/td> 838K
    代理商: LT1701-7DFB1
    T Series
    AC-DC Converters >100 Watt
    Rugged Environment
    Edition 4/4.99
    8/33
    MELCHER
    The Power Partners.
    Hold-up Time (Rectifier Version)
    The hold-up time depends upon the output voltage at the
    time of failure, the minimum acceptable output voltage and
    the load according to the following formula:
    Uo2 – Uo2 min u
    thold = –––––––––––– (Co + Cext)
    2
    Po
    where:
    Uo
    = Output voltage at the moment of mains failure
    Uo min u = Minimum acceptable output voltage
    Po
    = Average output power during hold up time
    Co
    = Internal output capacitance
    Cext
    = External output capacitance (e.g. on backplane)
    Examples of
    t hold are given in the table below:
    Table 5: Hold-up time thold for T1701
    Uo = 54 V
    Uo min u
    Unit
    Po [W]
    46 V
    43 V
    40 V
    38 V
    100
    164
    219
    270
    302
    ms
    200
    82
    109
    135
    151
    300
    55
    73
    90
    101
    400
    41
    55
    67
    75
    500
    33
    44
    54
    60
    550
    30
    40
    49
    55
    Output voltage regulation (Rectifier Version)
    The output voltage of rectifier models is adjusted to a fixed
    value
    Uo set. It relates to the output current and the input
    voltage which ensures automatic current sharing operation
    without further precautions when several units are con-
    nected in parallel. Rising output current and falling input
    voltage lead to a decrease of the output voltage, according
    to the formula:
    Uo
    ≈ U
    o set tol + (0.5 – Io/Ionom) DUo l + (Ui - Ui nom)/100 V
    DUo U
    Fig. 7
    Typical output voltage versus input voltage and output
    current of LT 1701
    Note: Units with different output voltage regulation charac-
    teristics (e.g. less output current dependency) are available
    upon request.
    Output power limitation (Rectifier Version)
    Especially for power systems with an output voltage of 48V
    and more, the rectifier models T 1701/1702 feature an out-
    put power limitation mode. The output power is kept con-
    stant down to an output voltage of approximately 38 V. This
    provides improved start-up capabilities of power systems
    including switched mode power supplies connected to the
    DC bus (e.g. Melcher CQ units). At maximum load there is
    no need for a special start-up procedure.
    The maximum input current is limited to
    I i L. At lower input
    voltage
    Ui red the maximum output power is limited to:
    Po
    ≈ h U
    i red Ii L
    (
    h = efficiency
    ≈ 90%)
    The T 1201 types have no output power limitation charac-
    teristic.
    Output Overvoltage Protection (Rectifier Version)
    A slight output voltage overshoot may occur at turn on, in-
    hibit release or during fast load changes. A second, inde-
    pendent control loop interrupts operation above
    Uo L indi-
    cated by the red LED. The output voltage remains below
    60 V (SELV) under all operating conditions.
    Note: There is no specific built-in protection against exter-
    nally applied overvoltages or transient sources like e.g.
    motors. Never apply voltages
    >60 V (>35 V) to the output.
    Otherwise the unit may be damaged.
    2%
    1%
    0
    –1%
    –2%
    0.01
    0.5
    1
    Io/Io nom
    Uo set
    U
    o
    Load
    regulation
    05081
    Output current limitation (Rectifier Version)
    The output of the T units is fully protected against continu-
    ous short circuit. The maximum constant current is limitted
    to
    Io L (see table: Electrical output data). As the LEDs indi-
    cating the system status are driven from the output voltage,
    in short circuit mode all LEDs switch off.
    Io [A]
    0
    Uo [V]
    48
    04027
    11
    14.5
    38
    54.5
    10
    Fig. 8
    Typical output voltage versus output current of UT/LT 1701/
    1702
    Io [A]
    0
    Uo [V]
    05048
    16
    24
    Fig. 9
    Typical output voltage versus output current of UT/LT 1201
    相關PDF資料
    PDF描述
    LT1702-7DB1 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE
    LT1740-7ZGB1 1-OUTPUT AC-DC REG PWR SUPPLY MODULE
    LT1730-7P 1-OUTPUT AC-DC REG PWR SUPPLY MODULE
    LT1730-7PG 1-OUTPUT AC-DC REG PWR SUPPLY MODULE
    LT1730-7ZGB1 1-OUTPUT AC-DC REG PWR SUPPLY MODULE
    相關代理商/技術參數
    參數描述
    LT1702-7 功能描述:AC-DC BATTERY CHARGER 48V 11A RoHS:否 類別:電源 - 外部/內部(非板載) >> AC DC 轉換器 系列:* 產品培訓模塊:MP Modular-Configurable AC-DC Power Supply 特色產品:Configurable Power Supplies 標準包裝:1 系列:MP
    LT170A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Linear Hall-Effect Sensor
    LT170E2 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LT170E2 |Data Sheet
    LT170Z 制造商:SEOUL 制造商全稱:Seoul Semiconductor 功能描述:GREEN OVAL LAMP LED
    LT171 制造商:SEOUL 制造商全稱:Seoul Semiconductor 功能描述:RED LAMP LED