<dl id="umckd"><menuitem id="umckd"><dfn id="umckd"></dfn></menuitem></dl>
<em id="umckd"><sup id="umckd"></sup></em>
  • 參數資料
    型號: LT1636IDD#TRPBF
    廠商: Linear Technology
    文件頁數: 2/16頁
    文件大?。?/td> 0K
    描述: IC OP AMP SGL R-R IN/OUT 8-DFN
    標準包裝: 2,500
    系列: Over-The-Top®
    放大器類型: 通用
    電路數: 1
    輸出類型: 滿擺幅
    轉換速率: 0.075 V/µs
    增益帶寬積: 220kHz
    電流 - 輸入偏壓: 4nA
    電壓 - 輸入偏移: 125µV
    電流 - 電源: 50µA
    電流 - 輸出 / 通道: 30mA
    電壓 - 電源,單路/雙路(±): 2.7 V ~ 44 V,±1.35 V ~ 22 V
    工作溫度: -40°C ~ 85°C
    安裝類型: 表面貼裝
    封裝/外殼: 8-WFDFN 裸露焊盤
    供應商設備封裝: 8-DFN-EP(3x3)
    包裝: 帶卷 (TR)
    10
    LT1636
    1636fc
    TYPICAL PERFOR A CE CHARACTERISTICS
    UW
    CHANGE
    IN
    INPUT
    OFFSET
    VOLTAGE
    (100
    V/DIV)
    Open-Loop Gain
    0V
    10V
    OUTPUT VOLTAGE (5V/DIV)
    A
    B
    C
    1636 G24
    VS = ±15V
    AV = –1
    1636 G25
    A: RL = 2k
    B: RL = 10k
    C: RL = 50k
    Large-Signal Response
    VS = ±15V
    AV = 1
    1636 G26
    Small-Signal Response
    APPLICATIONS INFORMATION
    WU
    U
    cause the voltage at which operation switches from the
    PNP stage to the NPN stage to move towards V+. The input
    offset voltage of the NPN stage is untrimmed and is
    typically 600
    V.
    A Schottky diode in the collector of each NPN transistor of
    the NPN input stage allows the LT1636 to operate with
    either or both of its inputs above V+. At about 0.3V above
    V+ the NPN input transistor is fully saturated and the input
    bias current is typically 3
    A at room temperature. The
    input offset voltage is typically 600
    V when operating
    above V+. The LT1636 will operate with its input 44V above
    Vregardless of V+.
    The inputs are protected against excursions as much as
    22V below V by an internal 1k resistor in series with each
    input and a diode from the input to the negative supply.
    There is no output phase reversal for inputs up to 5V below
    V . There are no clamping diodes between the inputs and
    the maximum differential input voltage is 44V.
    Output
    The output voltage swing of the LT1636 is affected by in-
    put overdrive as shown in the typical performance curves.
    When monitoring voltages within 100mV of V+, gain
    should be taken to keep the output from clipping.
    The output of the LT1636 can be pulled up to 27V beyond
    V+ with less than 1nA of leakage current, provided that V+
    is less than 0.5V.
    Supply Voltage
    The positive supply pin of the LT1636 should be bypassed
    with a small capacitor (about 0.01
    F) within an inch of the
    pin. When driving heavy loads an additional 4.7
    F electro-
    lytic capacitor should be used. When using split supplies,
    the same is true for the negative supply pin.
    The LT1636 is protected against reverse battery voltages
    up to 27V. In the event a reverse battery condition occurs,
    the supply current is less than 1nA.
    When operating the LT1636 on total supplies of 20V or
    more, the supply must not be brought up faster than 1
    s.
    This is especially true if low ESR bypass capacitors are
    used. A series RLC circuit is formed from the supply lead
    inductance and the bypass capacitor. 5
    of resistance in
    the supply or the bypass capacitor will dampen the tuned
    circuit enough to limit the rise time.
    Inputs
    The LT1636 has two input stages, NPN and PNP (see
    Simplified Schematic), resulting in three distinct operat-
    ing regions as shown in the Input Bias Current vs Common
    Mode typical performance curve.
    For input voltages about 0.8V or more below V+, the PNP
    input stage is active and the input bias current is typically
    – 4nA. When the input voltage is about 0.5V or less from
    V+, the NPN input stage is operating and the input bias
    current is typically 10nA. Increases in temperature will
    A
    B
    –10V
    VS = ±15V
    相關PDF資料
    PDF描述
    LT1638CDD IC OPAMP R-R IN/OUT DUAL 8DFN
    LT1677IS8#PBF IC OPAMP R-R I/O SGL LN 8SOIC
    LT1678IS8 IC OPAMP R-R I/O DUAL LN 8SOIC
    LT1724CS#TRPBF IC PREC OPAMP 200MHZ QUAD 14SOIC
    LT1782HS6#TRMPBF IC OPAMP R-R IN/OUT SOT23-6
    相關代理商/技術參數
    參數描述
    LT1636IMS8 制造商:Linear Technology 功能描述:OP Amp Single GP R-R I/O ±22V/44V 8-Pin MSOP
    LT1636IMS8#PBF 功能描述:IC OPAMP R-R IN/OUT 220KHZ 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:Over-The-Top® 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤,CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT
    LT1636IMS8#TRPBF 功能描述:IC OPAMP R-R IN/OUT 220KHZ 8MSOP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:Over-The-Top® 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源,單路/雙路(±):1.8 V ~ 5.25 V,±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件
    LT1636IN8 功能描述:IC OPAMP R-R IN/OUT 220KHZ 8-DIP RoHS:否 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:Over-The-Top® 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 16.5 V,±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC(0.154",3.90mm 寬) 供應商設備封裝:14-SOIC 包裝:帶卷 (TR)
    LT1636IN8#PBF 功能描述:IC OPAMP R-R IN/OUT 220KHZ 8-DIP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:Over-The-Top® 標準包裝:1,000 系列:- 放大器類型:電壓反饋 電路數:4 輸出類型:滿擺幅 轉換速率:33 V/µs 增益帶寬積:20MHz -3db帶寬:30MHz 電流 - 輸入偏壓:2nA 電壓 - 輸入偏移:3000µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:30mA 電壓 - 電源,單路/雙路(±):4.5 V ~ 16.5 V,±2.25 V ~ 8.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC(0.154",3.90mm 寬) 供應商設備封裝:14-SOIC 包裝:帶卷 (TR)