- 您現在的位置：買賣IC網 > PDF目錄385501 > LT1613CS5 (LINEAR TECHNOLOGY CORP) 1.4MHz, Single Cell DC/DC Converter in 5-Lead SOT-23 PDF資料下載
參數資料
| 型號： | LT1613CS5 |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 1.4MHz, Single Cell DC/DC Converter in 5-Lead SOT-23 |
| 中文描述： | SWITCHING REGULATOR, 1800 kHz SWITCHING FREQ-MAX, PDSO5 |
| 封裝： | PLASTIC, SOT-23, 5 PIN |
| 文件頁數： | 6/12頁 |
| 文件大小： | 257K |
| 代理商： | LT1613CS5 |
6
LT1613
OPERATIOU
Table 1 lists several inductors that will work with the
LT1613, although this is not an exhaustive list. There are
many magnetics vendors whose components are suitable
for use.
Diodes
A Schottky diode is recommended for use with the LT1613.
The Motorola MBR0520 is a very good choice. Where the
input to output voltage differential exceeds 20V, use the
MBR0530 (a 30V diode). If cost is more important than
efficiency, the 1N4148 can be used, but only at low current
loads.
Capacitors
The input bypass capacitor must be placed physically
close to the input pin. ESR is not critical and in most cases
an inexpensive tantalum is appropriate.
The choice of output capacitor is far more important. The
quality of this capacitor is the greatest determinant of the
output voltage ripple. The output capacitor must have
enough capacitance to satisfy the load under transient
conditions and it must shunt the switched component of
current coming through the diode. Output voltage ripple
results when this switched current passes through the
finite output impedance of the output capacitor. The
capacitor should have low impedance at the 1.4MHz
switching frequency of the LT1613. At this frequency, the
impedance is usually dominated by the capacitor’s equiva-
lent series resistance (ESR). Choosing a capacitor with
lower ESR will result in lower output ripple.
Ceramic capacitors can be used with the LT1613 provided
loop stability is considered. A tantalum capacitor has
some ESR and this causes an “ESR zero” in the regulator
loop. This zero is beneficial to loop stability. The internally
compensated LT1613 does not have an accessible com-
pensation node, but other circuit techniques can be em-
ployed to counteract the loss of the ESR zero, as detailed
in the next section.
Some capacitor types appropriate for use with the LT1613
are listed in Table 2.
OPERATION WITH CERAMIC CAPACITORS
Because the LT1613 is internally compensated, loop sta-
bility must be carefully considered when choosing an
output capacitor. Small, low cost tantalum capacitors
have some ESR, which aids stability. However, ceramic
capacitors are becoming more popular, having attractive
characteristics such as near-zero ESR, small size and
reasonable cost. Simply replacing a tantalum output ca-
pacitor with a ceramic unit will decrease the phase margin,
in some cases to unacceptable levels. With the addition of
a phase lead capacitor (C
PL
) and isolating resistor (R3),
the LT1613 can be used successfully with ceramic output
capacitors as described in the following figures.
A boost converter, stepping up 2.5V to 5V, is shown in
Figure 5. Tantalum capacitors are used for the input and
output (the input capacitor is not critical and has little
Table 1. Inductor Vendors
VENDOR
Sumida
PHONE
(847) 956-0666
URL
www.sumida.com
PART
CLS62-22022
CD43-220
LQH3C-220
LQH3C-100
LQH3C-4R7
CTX20-1
COMMENT
22
μ
H Coupled
22
μ
H
22
μ
H, 2mm Height
10
μ
H
4.7
μ
H
20
μ
H Coupled, Low DCR
Murata
(404) 436-1300
www.murata.com
Coiltronics
(407) 241-7876
www.coiltronics.com
Table 2. Capacitor Vendors
VENDOR
Taiyo Yuden
AVX
PHONE
(408) 573-4150
(803) 448-9411
URL
www.t-yuden.com
www.avxcorp.com
PART
Ceramic Caps
Ceramic Caps
Tantalum Caps
Ceramic Caps
COMMENT
X5R Dielectric
Murata
(404) 436-1300
www.murata.com
相關PDF資料 |
PDF描述 |
|---|---|
| LT1620 | Controlled Current Battery Charging(控制電流的電池充電器) |
| LT1622 | Low Input Voltage Current Mode Step-Down DC/DC Controller(低輸入電壓，電流模式步降DC/DC控制器) |
| LT1632 | 45MHz, 45V/us, Dual/Quad Rail-to-Rail Input and Output Precision Op Amps |
| LT1632CN8 | 45MHz, 45V/us, Dual/Quad Rail-to-Rail Input and Output Precision Op Amps |
| LT1632CS8 | 45MHz, 45V/us, Dual/Quad Rail-to-Rail Input and Output Precision Op Amps |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1613CS5#PBF | 制造商:Linear Technology 功能描述:1 34V 1.1V to 10V TSOT-23-5 制造商:Linear Technology 功能描述:DC/DC 1.1VIN MIN 1.4MHZ 34V 5SOT23 制造商:Linear Technology 功能描述:DC/DC, 1.1VIN MIN, 1.4MHZ, 34V, 5SOT23 制造商:Linear Technology 功能描述:IC, DC/DC CONVERTER, 5-SOT-23; Primary Input Voltage:10V; No. of Outputs:1; Output Voltage:34V; Output Current:200mA; No. of Pins:5; Operating Temperature Min:0C; Operating Temperature Max:70C; MSL:MSL 1 - Unlimited ;RoHS Compliant: Yes |
| LT1613CS5#PBF | 制造商:Linear Technology 功能描述:IC DC/DC CONVERTER 5-SOT-23 制造商:Linear Technology 功能描述:IC, DC/DC CONVERTER, 5-SOT-23 |
| LT1613CS5#TR | 功能描述:IC REG BST FLYBACK SEPIC TSOT23 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:500 系列:- 類型:切換式電容器（充電泵），反相 輸出類型:固定 輸出數:1 輸出電壓:-3V 輸入電壓:2.3 V ~ 5.5 V PWM 型:Burst Mode? 頻率 - 開關:900kHz 電流 - 輸出:100mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型，TSOT-23-6 包裝:帶卷 (TR) 供應商設備封裝:TSOT-23-6 其它名稱:LTC1983ES6-3#TRMTR |
| LT1613-CS5#TR | 制造商:Linear Technology 功能描述: |
| LT1613CS5#TRM | 功能描述:IC REG BST FLYBACK SEPIC TSOT23 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:500 系列:- 類型:切換式電容器（充電泵），反相 輸出類型:固定 輸出數:1 輸出電壓:-3V 輸入電壓:2.3 V ~ 5.5 V PWM 型:Burst Mode? 頻率 - 開關:900kHz 電流 - 輸出:100mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 細型，TSOT-23-6 包裝:帶卷 (TR) 供應商設備封裝:TSOT-23-6 其它名稱:LTC1983ES6-3#TRMTR |
發布緊急采購，3分鐘左右您將得到回復。