PIN FUN
參數資料
型號: LT1399IS#TR
廠商: Linear Technology
文件頁數: 16/16頁
文件大小: 0K
描述: IC CURRNT FEEDBK AMP TRPL 16SOIC
標準包裝: 2,500
放大器類型: 電流反饋
電路數: 3
轉換速率: 800 V/µs
-3db帶寬: 300MHz
電流 - 輸入偏壓: 10µA
電壓 - 輸入偏移: 1500µV
電流 - 電源: 4.6mA
電流 - 輸出 / 通道: 80mA
電壓 - 電源,單路/雙路(±): 4 V ~ 12 V,±2 V ~ 6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 16-SOIC(0.154",3.90mm 寬)
供應商設備封裝: 16-SO
包裝: 帶卷 (TR)
其它名稱: LT1399ISTR
9
LT1398/LT1399/LT1399HV
sn13989 13989fas
PIN FUNCTIONS
UU
U
LT1399, LT1399HV
– IN R (Pin 1): Inverting Input of R Channel Amplifier.
+ IN R (Pin 2): Noninverting Input of R Channel Amplifier.
GND (Pin 3): Ground. Not connected internally.
– IN G (Pin 4): Inverting Input of G Channel Amplifier.
+ IN G (Pin 5): Noninverting Input of G Channel Amplifier.
GND (Pin 6): Ground. Not connected internally.
+ IN B (Pin 7): Noninverting Input of B Channel Amplifier.
– IN B (Pin 8): Inverting Input of B Channel Amplifier.
EN B (Pin 9): B Channel Enable Pin. Logic low to enable.
OUT B (Pin 10): B Channel Output.
V (Pin 11): Negative Supply Voltage, Usually – 5V.
OUT G (Pin 12): G Channel Output.
EN G (Pin 13): G Channel Enable Pin. Logic low to enable.
V + (Pin 14): Positive Supply Voltage, Usually 5V.
OUT R (Pin 15): R Channel Output.
EN R (Pin 16): R Channel Enable Pin. Logic low to enable.
Take care to minimize the stray capacitance between the
output and the inverting input. Capacitance on the invert-
ing input to ground will cause peaking in the frequency
response (and overshoot in the transient response).
Capacitive Loads
The LT1398/LT1399/LT1399HV can drive many capaci-
tive loads directly when the proper value of feedback
resistor is used. The required value for the feedback
resistor will increase as load capacitance increases and as
closed-loop gain decreases. Alternatively, a small resistor
(5
to 35) can be put in series with the output to isolate
the capacitive load from the amplifier output. This has the
advantage that the amplifier bandwidth is only reduced
when the capacitive load is present. The disadvantage is
that the gain is a function of the load resistance.
U
S
A
O
PPLICATI
WU
U
I FOR ATIO
Feedback Resistor Selection
The small-signal bandwidth of the LT1398/LT1399/
LT1399HV is set by the external feedback resistors and the
internal junction capacitors. As a result, the bandwidth is
a function of the supply voltage, the value of the feedback
resistor, the closed-loop gain and the load resistor. The
LT1398/LT1399 have been optimized for
±5V supply
operation and have a – 3dB bandwidth of 300MHz at a gain
of 2. The LT1399HV provides performance similar to the
LT1399. Please refer to the resistor selection guide in the
Typical AC Performance table.
Capacitance on the Inverting Input
Current feedback amplifiers require resistive feedback
from the output to the inverting input for stable operation.
LT1398
– IN A (Pin 1): Inverting Input of A Channel Amplifier.
+ IN A (Pin 2): Noninverting Input of A Channel Amplifier.
GND (Pins 3, 4, 5, 6): Ground. Not connected internally.
+ IN B (Pin 7): Noninverting Input of B Channel Amplifier.
– IN B (Pin 8): Inverting Input of B Channel Amplifier.
EN B (Pin 9): B Channel Enable Pin. Logic low to enable.
OUT B (Pin 10): B Channel Output.
V (Pin 11): Negative Supply Voltage, Usually – 5V.
GND (Pins 12, 13): Ground. Not connected internally.
V + (Pin 14): Positive Supply Voltage, Usually 5V.
OUT A (Pin 15): A Channel Output.
EN A (Pin 16): A Channel Enable Pin. Logic low to enable.
相關PDF資料
PDF描述
SMBJ5.0A/54 TVS J-LEAD 600W 5V UNI-DIR SMD
SF-1206S700-2 FUSE SLOW 24VDC 7A 1206
SF-1206S150-2 FUSE SLOW 63VDC 1.5A 1206
SMBJ7.5A/54 TVS 600W 7.5V UNIDR SMD J-LEAD
SF-1206S500-2 FUSE SLOW 24VDC 5A 1206
相關代理商/技術參數
參數描述
LT13AG2831 制造商:Laird Technologies Inc 功能描述:CLO,STR,BF,DLN,CTL / .070X.210X.200X11.970IN / UOM=EA
LT13AG3211 制造商:Laird Technologies Inc 功能描述:
LT13E-Q35-LU0X3-H1141 制造商:TURCK Inc 功能描述:LT13E-Q35-LU0X3-H1141
LT140 制造商:SHARP 制造商全稱:Sharp Electrionic Components 功能描述:Hall Voltage 160mV Thin-Type Package GaAs Hall Device
LT1406EIS825PBF 制造商:Linear Technology 功能描述: