- 您現在的位置：買賣IC網 > PDF目錄44982 > LT1201-7DB1 (POWER-ONE INC) 1-OUTPUT 400 W AC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | LT1201-7DB1 |
| 廠商： | POWER-ONE INC |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 400 W AC-DC REG PWR SUPPLY MODULE |
| 封裝： | CASE T01, MODULE |
| 文件頁數： | 32/33頁 |
| 文件大小： | 838K |
| 代理商： | LT1201-7DB1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁當前第32頁第33頁
T Series
AC-DC Converters >100 Watt
Rugged Environment
Edition 4/4.99
8/33
MELCHER
The Power Partners.
Hold-up Time (Rectifier Version)
The hold-up time depends upon the output voltage at the
time of failure, the minimum acceptable output voltage and
the load according to the following formula:
Uo2 – Uo2 min u
thold = –––––––––––– (Co + Cext)
2
Po
where:
Uo
= Output voltage at the moment of mains failure
Uo min u = Minimum acceptable output voltage
Po
= Average output power during hold up time
Co
= Internal output capacitance
Cext
= External output capacitance (e.g. on backplane)
Examples of
t hold are given in the table below:
Table 5: Hold-up time thold for T1701
Uo = 54 V
Uo min u
Unit
Po [W]
46 V
43 V
40 V
38 V
100
164
219
270
302
ms
200
82
109
135
151
300
55
73
90
101
400
41
55
67
75
500
33
44
54
60
550
30
40
49
55
Output voltage regulation (Rectifier Version)
The output voltage of rectifier models is adjusted to a fixed
value
Uo set. It relates to the output current and the input
voltage which ensures automatic current sharing operation
without further precautions when several units are con-
nected in parallel. Rising output current and falling input
voltage lead to a decrease of the output voltage, according
to the formula:
Uo
≈ U
o set tol + (0.5 – Io/Ionom) DUo l + (Ui - Ui nom)/100 V
DUo U
Fig. 7
Typical output voltage versus input voltage and output
current of LT 1701
Note: Units with different output voltage regulation charac-
teristics (e.g. less output current dependency) are available
upon request.
Output power limitation (Rectifier Version)
Especially for power systems with an output voltage of 48V
and more, the rectifier models T 1701/1702 feature an out-
put power limitation mode. The output power is kept con-
stant down to an output voltage of approximately 38 V. This
provides improved start-up capabilities of power systems
including switched mode power supplies connected to the
DC bus (e.g. Melcher CQ units). At maximum load there is
no need for a special start-up procedure.
The maximum input current is limited to
I i L. At lower input
voltage
Ui red the maximum output power is limited to:
Po
≈ h U
i red Ii L
(
h = efficiency
≈ 90%)
The T 1201 types have no output power limitation charac-
teristic.
Output Overvoltage Protection (Rectifier Version)
A slight output voltage overshoot may occur at turn on, in-
hibit release or during fast load changes. A second, inde-
pendent control loop interrupts operation above
Uo L indi-
cated by the red LED. The output voltage remains below
60 V (SELV) under all operating conditions.
Note: There is no specific built-in protection against exter-
nally applied overvoltages or transient sources like e.g.
motors. Never apply voltages
>60 V (>35 V) to the output.
Otherwise the unit may be damaged.
2%
1%
0
–1%
–2%
0.01
0.5
1
Io/Io nom
Uo set
U
o
Load
regulation
05081
Output current limitation (Rectifier Version)
The output of the T units is fully protected against continu-
ous short circuit. The maximum constant current is limitted
to
Io L (see table: Electrical output data). As the LEDs indi-
cating the system status are driven from the output voltage,
in short circuit mode all LEDs switch off.
Io [A]
0
Uo [V]
48
04027
11
14.5
38
54.5
10
Fig. 8
Typical output voltage versus output current of UT/LT 1701/
1702
Io [A]
0
Uo [V]
05048
16
24
Fig. 9
Typical output voltage versus output current of UT/LT 1201
相關PDF資料 |
PDF描述 |
|---|---|
| LT1701-7DF | 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE |
| LT1240-7DF | 1-OUTPUT 400 W AC-DC REG PWR SUPPLY MODULE |
| LT1740-7DFB1 | 1-OUTPUT 550 W AC-DC REG PWR SUPPLY MODULE |
| LT1840-7 | 1-OUTPUT 450 W AC-DC REG PWR SUPPLY MODULE |
| LT1240-7DB1 | 1-OUTPUT 400 W AC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1202CN | 制造商:Linear Technology 功能描述: |
| LT1203 | 制造商:LINER 制造商全稱:Linear Technology 功能描述:650MHz Gain of 2 Triple 2:1Video Multiplexer |
| LT1203CN8 | 制造商:Linear Technology 功能描述:Analog Multiplexer/Amp Single 2:1 8-Pin PDIP N |
| LT1203CN8#PBF | 功能描述:IC VIDEO MULTIPLEXER SPDT 8DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 模擬開關，多路復用器，多路分解器 系列:- 應用說明:Ultrasound Imaging Systems Application Note 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:250 系列:- 功能:開關 電路:單刀單擲 導通狀態電阻:48 歐姆 電壓電源:單電源 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V 電流 - 電源:5µA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:48-LQFP 供應商設備封裝:48-LQFP（7x7） 包裝:托盤 |
| LT1203CS8 | 制造商:Linear Technology 功能描述:Analog Multiplexer/Amp Single 2:1 8-Pin SOIC N |
發布緊急采購，3分鐘左右您將得到回復。