參數資料
型號: LT1172HVIQ#TRPBF
廠商: LINEAR TECHNOLOGY CORP
元件分類: 穩壓器
英文描述: 3.5 A SWITCHING REGULATOR, 115 kHz SWITCHING FREQ-MAX, PSSO5
封裝: LEAD FREE, PLASTIC, D2PAK-5
文件頁數: 20/24頁
文件大小: 225K
代理商: LT1172HVIQ#TRPBF
LT1170/LT1171/LT1172
5
117012fg
SYMBOL PARAMETER
CONDITIONS
MIN
TYP
MAX
UNITS
DCMAX
Maximum Switch Duty Cycle
l
85
92
97
%
Shutdown Mode
Supply Current
3V ≤ VIN ≤ VMAX
VC = 0.05V
100
250
μA
Shutdown Mode
Threshold Voltage
3V ≤ VIN ≤ VMAX
l
100
50
150
250
300
mV
Flyback Sense Delay Time (Note 5)
1.5
μs
ELECTRICAL CHARACTERISTICS The l denotes the specifications which apply over the full operating
temperature range, otherwise specifications are at TA = 25°C. VIN = 15V, VC = 0.5V, VFB = VREF, output pin open, unless otherwise noted.
Note 1: Stresses beyond those listed under Absolute Maximum Ratings
may cause permanent damage to the device. Exposure to any Absolute
Maximum Rating condition for extended periods may affect device
reliability and lifetime.
Note 2: Minimum effective switch “on” time for the LT1170/LT1171/
LT1172 (in current limit only) is ≈ 0.6μs. This limits the maximum safe
input voltage during an output shorted condition. Buck mode and inverting
mode input voltage during an output shorted condition is limited to:
VIN (max, output shorted) = 15V
+
R
(
) IL
(
)+Vf
t
(
) f()
buck and inverting mode
R = Inductor DC resistance
IL = 10A for LT1170, 5A for LT1171, and 2.5A for LT1172
Vf = Output catch diode forward voltage at IL
t = 0.6μs, f = 100kHz switching frequency
Maximum input voltage can be increased by increasing R or Vf.
External current limiting such as that shown in AN19, Figure 39, will
provide protection up to the full supply voltage rating. C1 in Figure 39
should be reduced to 200pF.
Transformer designs will tolerate much higher input voltages because
leakage inductance limits rate of rise of current in the switch. These
designs must be evaluated individually to assure that current limit is well
controlled up to maximum input voltage.
Boost mode designs are never protected against output shorts because
the external catch diode and inductor connect input to output.
Note 3: Measured with VC in hi clamp, VFB = 0.8V. ISW = 4A for LT1170,
2A for LT1171, and 1A for LT1172.
Note 4: For duty cycles (DC) between 50% and 80%, minimum guaranteed
switch current is given by ILIM = 3.33 (2 – DC) for the LT1170, ILIM = 1.67
(2 – DC) for the LT1171, and ILIM = 0.833 (2 – DC) for the LT1172.
Note 5: Minimum input voltage for isolated flyback mode is 7V. VMAX = 55V
for HV grade in fully isolated mode to avoid switch breakdown.
相關PDF資料
PDF描述
LT1171CT#FLOW-06PBF 5.5 A SWITCHING REGULATOR, 115 kHz SWITCHING FREQ-MAX, PZFM5
LT1236CCN8-5#TRPBF 1-OUTPUT THREE TERM VOLTAGE REFERENCE, 5 V, PDIP8
LT1240-7Z 1-OUTPUT 500 W AC-DC REG PWR SUPPLY MODULE
LT1840-7Z 1-OUTPUT 500 W AC-DC REG PWR SUPPLY MODULE
LT1740-7Z 1-OUTPUT 500 W AC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
LT1172I 制造商:LINER 制造商全稱:Linear Technology 功能描述:100kHz, 5A, 2.5A and 1.25A High Efficiency Switching Regulators
LT1172IN8 功能描述:IC REG MULTI CONFIG ADJ 8DIP RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:2,500 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V,1.5V,1.8V,2.5V 輸入電壓:2.7 V ~ 20 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:50mA 同步整流器:是 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬)裸露焊盤 包裝:帶卷 (TR) 供應商設備封裝:10-MSOP 裸露焊盤
LT1172IN8#PBF 功能描述:IC REG MULTI CONFIG ADJ 8DIP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓(降壓) 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON(1.45x1) 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2
LT1172IN8#PBF 制造商:Linear Technology 功能描述:IC, SWITCHING REGULATOR, 8-DIP
LT1172IN8#TRPBF 制造商:Linear Technology 功能描述:Conv DC-DC Single Non-Inv/Inv/Step Up/Step Down 3V to 40V 8-Pin PDIP N T/R