- 您現在的位置：買賣IC網 > PDF目錄385498 > LT1171 (Linear Technology Corporation) 500kHz and 1MHz High Efficiency 1.5A Switching Regulators; Package: SO; No of Pins: 8; Temperature Range: -40?°C to 85?°C PDF資料下載
參數資料
| 型號： | LT1171 |
| 廠商： | Linear Technology Corporation |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 500kHz and 1MHz High Efficiency 1.5A Switching Regulators; Package: SO; No of Pins: 8; Temperature Range: -40?°C to 85?°C |
| 中文描述： | 射頻放大器 |
| 文件頁數： | 9/20頁 |
| 文件大小： | 275K |
| 代理商： | LT1171 |
9
LT1170/LT1171/LT1172
Temperature rise in a plastic miniDIP would be 130
°
C/W
times 0.34W, or approximately 44
°
C. The maximum am-
bient temperature would be limited to 100
°
C (commercial
temperature limit) minus 44
°
C, or 56
°
C.
In most applications, full load current is used to calculate
die temperature. However, if overload conditions must
also be accounted for, four approaches are possible. First,
if loss of regulated output is acceptable under overload
conditions, the internal thermal limitof the LT1172 will
protect the die in most applications by shutting off switch
current. Thermal limit is not a tested parameter however,
and should be considered only for noncritical applications
with temporary overloads. A second approach is to use the
larger TO-220 (T) or TO-3 (K) package which, even without
a heat sink, may limit die temperatures to safe levels under
overload conditions. In critical situations, heat sinking of
these packages is required; especially if overload condi-
tions must be tolerated for extended periods of time.
The third approach for lower current applications is to
leave the second switch emitter (miniDIP only) open. This
increases switch “on” resistance by 2:1, but reduces
switch current limit by 2:1 also, resulting in a net 2:1
reduction in I
2
R switch dissipation under current limit
conditions.
The fourth approach is to clamp the V
C
pin to a voltage less
than its internal clamp level of 2V. The LT1172 switch
current limit is zero at approximately 1V on the V
C
pin and
2A at 2V on the V
C
pin. Peak switch current can be
externally clamped between these two levels with a diode.
See AN19 for details.
Synchronizing with Bipolar Transistor
LT1170/LT1171/LT1172 Synchronizing
The LT1170/LT1171/LT1172 can be externally synchro-
nized in the frequency range of 120kHz to 160kHz. This is
accomplished as shown in the accompanying figures.
Synchronizing occurs when the V
C
pin is pulled to ground
with an external transistor. To avoid disturbing the DC
characteristics of the internal error amplifier, the width of
the synchronizing pulse should be under 0.3
μ
s. C2 sets
the pulse width at
0.2
μ
s. The effect of a synchronizing
pulse on the LT1170/LT1171/LT1172 amplifier offset can
be calculated from:
KT= 26mV at 25
°
C
q
t
S
= pulse width
f
S
= pulse frequency
I
C
= V
C
source current (
≈
200
μ
A)
V
C
= operating V
C
voltage (1V to 2V)
R3 = resistor used to set mid-frequency “zero” in
frequency compensation network.
With t
S
= 0.2
μ
s, f
S
= 150kHz, V
C
= 1.5V, and R3 = 2k, offset
voltage shift is
≈
3.8mV. This is not particularly bother-
some, but note that high offsets could result if R3 were
reduced to a much lower value. Also, the synchronizing
transistor must sink higher currents with low values of R3,
so larger drives may have to be used. The transistor must
be capable of pulling the V
C
pin to within 200mV of ground
to ensure synchronizing.
Synchronizing with MOS Transistor
V
KT
q
t
f
I
V
R
I
OS
S
S
C
C
3
C
=
( )( )
+
1170/1/2 OP01
C2
39pF
R1
3k
R2
2.2k
LT1170
GND
V
IN
V
C
C1
R3
2N2369
FROM 5V
LOGIC
1170/1/2 OP02
D1
1N4158
R2
2.2k
LT1170
GND
V
IN
V
C
C1
R3
FROM 5V
LOGIC
C2
100pF
D2
1N4158
* SILICONIX OR EQUIVALENT
VN2222*
OPERATIOU
相關PDF資料 |
PDF描述 |
|---|---|
| LT1172 | 500kHz and 1MHz High Efficiency 1.5A Switching Regulators; Package: SO; No of Pins: 8; Temperature Range: -40?°C to 85?°C |
| LT1173 | Micropower DC/DC Converter Adjustable and Fixed 5V, 12V(微功耗，固定輸出12V或5V及可調輸出，DC/DC變換器（工作于步升和步降兩種模式）) |
| LT1175 | 500mA Negative Low Dropout Micropower Regulator(500mA,F負輸出，低壓差，微功耗穩壓器) |
| LT1187IN8 | Low Power Video Difference Amplifi er |
| LT1188 | 10-bit Bus Interface Flip-Flops With 3-State Outputs 24-SOIC 0 to 70 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1171C | 制造商:LINER 制造商全稱:Linear Technology 功能描述:100kHz, 5A, 2.5A and 1.25A High Efficiency Switching Regulators |
| LT1171CK | 制造商:LINER 制造商全稱:Linear Technology 功能描述:100kHz, 5A, 2.5A and 1.25A High Efficiency Switching Regulators |
| LT1171CQ | 功能描述:IC REG MULTI CONFIG ADJ D2PAK RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1171CQ#PBF | 功能描述:IC REG MULTI CONFIG ADJ D2PAK RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
| LT1171CQ#TR | 功能描述:IC REG MULTI CONFIG ADJ D2PAK RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
發布緊急采購，3分鐘左右您將得到回復。