The gain therefore is 1 + CF/C" />
  • <big id="zwyue"><dl id="zwyue"></dl></big>
  • <form id="zwyue"><meter id="zwyue"></meter></form>
    <dfn id="zwyue"></dfn>
    <menuitem id="zwyue"><label id="zwyue"><legend id="zwyue"></legend></label></menuitem>
    <dfn id="zwyue"><pre id="zwyue"></pre></dfn>
  • <dfn id="zwyue"><input id="zwyue"></input></dfn>
    <form id="zwyue"></form>
    <dd id="zwyue"></dd>
  • 參數資料
    型號: LT1113CS8#PBF
    廠商: Linear Technology
    文件頁數: 2/16頁
    文件大?。?/td> 0K
    描述: IC PREC OP-AMP JFET DUAL 8SOIC
    標準包裝: 100
    放大器類型: J-FET
    電路數: 2
    轉換速率: 3.9 V/µs
    增益帶寬積: 5.6MHz
    電流 - 輸入偏壓: 320pA
    電壓 - 輸入偏移: 500µV
    電流 - 電源: 5.3mA
    電壓 - 電源,單路/雙路(±): ±4.5 V ~ 20 V
    工作溫度: 0°C ~ 70°C
    安裝類型: 表面貼裝
    封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
    供應商設備封裝: 8-SO
    包裝: 管件
    產品目錄頁面: 1317 (CN2011-ZH PDF)
    10
    LT1113
    1113fb
    U
    S
    A
    O
    PPLICATI
    WU
    U
    I FOR ATIO
    The gain therefore is 1 + CF/CS. For unity gain, CF should
    equal the transducer capacitance plus the input capaci-
    tance of the LT1113 and RF should equal RS. In the
    noninverting mode example, the transducer current is
    converted to a change in voltage by the transducer capaci-
    tance; this voltage is then buffered by the LT1113 with a
    gain of 1 + R1/R2. A DC path is provided by RS, which is
    either the transducer impedance or an external resistor.
    Since RS is usually several orders of magnitude greater
    than the parallel combination of R1 and R2, RB is added to
    balance the DC offset caused by the noninverting input
    bias current and RS. The input bias currents, although
    small at room temperature, can create significant errors
    over increasing temperature, especially with transducer
    resistances of up to 100M or more. The optimum value for
    RB is determined by equating the thermal noise (4kTRS) to
    the current noise (2qIB) times RS2. Solving for RS results
    in RB = RS = 2VT/IB
    V
    kT
    q
    mV at
    C
    T ==
    °
    26
    25
    .
    A parallel capacitor, CB, is used to cancel the phase shift
    caused by the op amp input capacitance and RB.
    Reduced Power Supply Operation
    The LT1113 can be operated from
    ±5V supplies for lower
    power dissipation resulting in lower IB and noise at the
    expense of reduced dynamic range. To illustrate this
    benefit, let’s look at the following example:
    An LT1113CS8 operates at an ambient temperature of
    25
    °C with ±15V supplies, dissipating 318mW of power
    (typical supply current = 10.6mA for the dual). The SO-8
    package has a
    θJA of 190°C/W, which results in a die
    temperature increase of 60.4
    °C or a room temperature die
    operating temperature of 85.4
    °C. At ±5V supplies, the die
    temperature increases by only one third of the previous
    amount or 20.1
    °C resulting in a typical die operating
    temperature of only 45.1
    °C. A 40 degree reduction of die
    temperature is achieved at the expense of a 20V reduction
    in dynamic range. If no DC correction resistor is used at
    the input, the input referred offset will be the input bias
    current at the operating die temperature times the trans-
    ducer resistance (refer to Input Bias and Offset Currents vs
    Chip Temperature graph in Typical Performance Charac-
    teristics section). A 100mV input VOS is the result of a 1nA
    IB (at 85°C) dropped across a 100M transducer resis-
    tance; at
    ±5V supplies, the input offset is only 28mV (IB at
    45
    °C is 280pA). Careful selection of a DC correction
    +
    R2
    OUTPUT
    RB
    CB
    R1
    CS
    RS
    CB CS
    RB = RS
    RS > R1 OR R2
    TRANSDUCER
    +
    OUTPUT
    CF
    CB
    RB
    CB = CFCS
    RB = RFRS
    RF
    CS
    RS
    TRANSDUCER
    1113 F02
    Q = CV;
    dQ
    dt
    = I = C
    dV
    dt
    Figure 2. Noninverting and Inverting Gain Configurations
    相關PDF資料
    PDF描述
    LTC1152CS8#PBF IC OPAMP 0-DRFT R-R IN/OUT 8SOIC
    0791081005 CONN RCPT 2MM GOLD DL 12CKT
    LT1361CN8#PBF IC OP-AMP HI-SPD 50MHZ DUAL 8DIP
    LT1639CS#PBF IC OPAMP R-R IN/OUT QUAD 14SOIC
    M80-5402042 CONN HDR 2MM R/A W/SCREW 20POS
    相關代理商/技術參數
    參數描述
    LT1113M 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual Low Noise, Precision, JFET Input Op Amps
    LT1113MJ8 制造商:Linear Technology 功能描述:OP Amp Dual GP 20V 8-Pin CDIP
    LT1114 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual/Quad Low Power Precision, Picoamp Input Op Amps
    LT1114AC 制造商:LINER 制造商全稱:Linear Technology 功能描述:Dual/Quad Low Power Precision, Picoamp Input Op Amps
    LT1114ACJ 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage-Feedback Operational Amplifier