- 您現在的位置：買賣IC網 > PDF目錄30765 > LT1054IN8#TRPBF (LINEAR TECHNOLOGY CORP) SWITCHED CAPACITOR REGULATOR, 40 kHz SWITCHING FREQ-MAX, PDIP8 PDF資料下載
參數資料
| 型號： | LT1054IN8#TRPBF |
| 廠商： | LINEAR TECHNOLOGY CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHED CAPACITOR REGULATOR, 40 kHz SWITCHING FREQ-MAX, PDIP8 |
| 封裝： | 0.300 INCH, LEAD FRE, PLASTIC, DIP-8 |
| 文件頁數： | 12/16頁 |
| 文件大小： | 264K |
| 代理商： | LT1054IN8#TRPBF |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁
LT1054/LT1054L
5
1954lfg
TYPICAL PERFORMANCE CHARACTERISTICS
Regulated Output Voltage
Reference Voltage Temperature
Coefficient
TEMPERATURE (°C)
–50
–12.6
OUTPUT
VOLTAGE
(V)
–12.4
–12.0
–11.8
–11.6
–4.7
–5.0
0
50
75
LT1054 TPC09
–12.2
–4.9
–4.8
–5.1
–25
25
100 125
TEMPERATURE (°C)
–50
–100
REFERENCE
VOLTAGE
CHANGE
(mV)
–80
–40
–20
0
100
40
0
50
75
LT1054 TPC10
–60
60
80
20
–25
25
100 125
VREF AT 0 = 2.500V
PIN FUNCTIONS
FB/SHDN (Pin 1): Feedback/Shutdown Pin. This pin has
two functions. Pulling Pin 1 below the shutdown threshold
(≈0.45V) puts the device into shutdown. In shutdown the
reference/regulator is turned off and switching stops. The
switchesaresetsuchthatbothCINandCOUTaredischarged
through the output load. Quiescent current in shutdown
drops to approximately 100A (see Typical Performance
Characteristics). Any open-collector gate can be used to
put the LT1054 into shutdown. For normal (unregulated)
operation the device will start back up when the external
gate is shut off. In LT1054 circuits that use the regulation
feature, the external resistor divider can provide enough
pull-down to keep the device in shutdown until the output
capacitor (COUT) has fully discharged. For most applica-
tions where the LT1054 would be run intermittently, this
does not present a problem because the discharge time
of the output capacitor will be short compared to the off-
time of the device. In applications where the device has
to start up before the output capacitor (COUT) has fully
discharged, a restart pulse must be applied to Pin 1 of
the LT1054. Using the circuit of Figure 5, the restart signal
can be either a pulse (tp > 100s) or a logic high. Diode
coupling the restart signal into Pin 1 will allow the output
voltage to come up and regulate without overshoot. The
resistor divider R3/R4 in Figure 5 should be chosen to
provide a signal level at pin 1 of 0.7V to 1.1V.
Pin 1 is also the inverting input of the LT1054’s error
amplifier and as such can be used to obtain a regulated
output voltage.
CAP+/CAP– (Pin 2/Pin 4): Pin 2, the positive side of the
input capacitor (CIN), is alternately driven between V+
and ground. When driven to V+, Pin 2 sources current
from V+. When driven to ground Pin 2 sinks current to
ground. Pin 4, the negative side of the input capacitor, is
driven alternately between ground and VOUT. When driven
to ground, Pin 4 sinks current to ground. When driven to
VOUT Pin 4 sources current from COUT. In all cases current
flowintheswitchesisunidirectionalasshouldbeexpected
using bipolar switches.
VOUT (Pin 5): In addition to being the output pin this pin
is also tied to the substrate of the device. Special care
must be taken in LT1054 circuits to avoid pulling this
pin positive with respect to any of the other pins. Pulling
Pin5 positive with respect to Pin 3 (GND) will forward
bias the substrate diode which will prevent the device from
starting. This condition can occur when the output load
driven by the LT1054 is referred to its positive supply (or
to some other positive voltage). Note that most op amps
present just such a load since their supply currents flow
from their V+ terminals to their V– terminals. To prevent
start-up problems with this type of load an external
相關PDF資料 |
PDF描述 |
|---|---|
| LT1054MJ8#TRPBF | SWITCHED CAPACITOR REGULATOR, 40 kHz SWITCHING FREQ-MAX, CDIP8 |
| LT1076HVCT#TRPBF | 3.2 A SWITCHING REGULATOR, 125 kHz SWITCHING FREQ-MAX, PZFM7 |
| LT1076IT-5#TR | 3.2 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5 |
| LT1076HVIT-5#TRPBF | 3.2 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5 |
| LT1076HVCT-5#TR | 3.2 A SWITCHING REGULATOR, 120 kHz SWITCHING FREQ-MAX, PZFM5 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1054IP | 功能描述:電荷泵 Switched-Capacitor Voltage Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| LT1054IP | 制造商:Texas Instruments 功能描述:Voltage Regulator IC Package/Case:8-PDIP |
| LT1054IPE4 | 功能描述:電荷泵 Switched-Capacitor Voltage Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 輸出電壓:- 1.5 V to - 5.5 V, 3 V to 11 V 輸出電流:100 mA 電源電流:1 mA 最大工作溫度:+ 70 C 封裝 / 箱體:SOIC-8 Narrow 封裝:Tube |
| LT1054IS8 | 功能描述:IC REG SWITCHD CAP DBL INV 8SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 設計資源:Design Support Tool 標準包裝:1 系列:- 類型:升壓（升壓） 輸出類型:固定 輸出數:1 輸出電壓:3V 輸入電壓:0.75 V ~ 2 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:100mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 包裝:剪切帶 (CT) 供應商設備封裝:TSOT-23-5 其它名稱:AS1323-BTTT-30CT |
| LT1054IS8#PBF | 功能描述:IC REG SWITCHD CAP DBL INV 8SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 標準包裝:250 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:1.2V 輸入電壓:2.05 V ~ 6 V PWM 型:電壓模式 頻率 - 開關:2MHz 電流 - 輸出:500mA 同步整流器:是 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 包裝:帶卷 (TR) 供應商設備封裝:6-SON（1.45x1） 產品目錄頁面:1032 (CN2011-ZH PDF) 其它名稱:296-25628-2 |
發布緊急采購，3分鐘左右您將得到回復。