參數資料
型號: LSM-2.5/16-D12
廠商: CD TECHNOLOGIES INC
元件分類: 電源模塊
英文描述: 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
封裝: SMT-6
文件頁數: 9/12頁
文件大?。?/td> 902K
代理商: LSM-2.5/16-D12
LSM-16A D12 Series
N O N - I S O L A T E D , 1 3 - 8 0 W S M T D C / D C C O N V E R T E R S
6
Figure 7.Trim Connections Using Fixed Resistors
Figure 6.Trim Connections Using a Trimpot
Trim Equations
Note: Resistor values are in k
. Accuracy of adjustment is subject to
tolerances of resistors and factory-adjusted, initial output accuracy.
VO = desired output voltage. VO
NOM = nominal output voltage.
Note: Install either a xed trim-up resistor
or a xed trim-down resistor depending upon
desired output voltage.
“T” Model LSM-T/16-D12
This version of the LSM 16A series offers a special output voltage trimming
feature which is fully compatible with competitive units. The output voltage
may be varied from 0.75 to 5 Volts using a single external trim-up resis-
tor connected from the Trim input to Output Common. If no trim resistor is
attached (Trim pin open), the output is 0.7525 Volts.
The trim may also be adjusted using an external reference voltage connected
to the Trim input.
As with other trim adjustments, use a 1% metal lm precision resistor with
low temperature coefcient (±100 ppm/°C or less) mounted close to the
converter with short leads. Also be aware that the output accuracy is ±2%
(typical) therefore you may need to vary this resistance slightly to achieve
your desired output setting.
The resistor trim up equation for the LSM-T/16-D12 is as follows:
10500
RTUP (
) = ___________ –1000
VO – 0.7525
Where VO is the desired output voltage.
The LSM-T/16-D12 xed resistance values to set the output values are:
VO
0.7525V
1.0V
1.2V
1.5V
1.8V
2.5V
3.3V
5.0V
RT (k
) Open 41.424 22.46 13.05 9.024 5.009 3.122 1.472
CAUTION: To retain proper regulation, do not exceed the 5 Volt output.
Voltage Trim
The LSM-T/16-D12 may also be trimmed using an external voltage applied
between the Trim input and Output Common. Be aware that the internal
“l(fā)oad” impedance looking into trim pin is approximately 5k
. Therefore, you
may have to compensate for this in the source resistance of your external
voltage reference.
The equation for this voltage adjustment is:
VTRIM = 0.7 –(0.0667 x (VO – 0.7525))
The LSM-T/16-D12 xed trim voltages to set the output voltage are:
VO
0.7525V 1.0V
1.2V
1.5V
1.8V
2.5V
3.3V
5.0V
VT (V) Open
0.6835 0.670 0.650 0.630 0.583 0.530 0.4166
相關PDF資料
PDF描述
LSM-1/16-D12 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
LSM-5/16-D12 1-OUTPUT 80 W DC-DC REG PWR SUPPLY MODULE
LSM-T/16-D12 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
LSM-2/16-D12 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
LSM-1/16-D12 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
LSM271M2D---2225S 制造商:Surge Components Inc 功能描述:CAP ALUM 270UF 200V ?20% 3000LHRS 22 X 25 - Bulk
LSM271M2E---2235S 制造商:Surge Components Inc 功能描述:CAP ALUM 270UF 250V ?20% 3000LHRS 22 X 35 - Bulk
LSM271M2E---2525S 制造商:Surge Components Inc 功能描述:CAP ALUM 270UF 250V ?20% 3000LHRS 25 X 25 - Bulk
LSM271M2G---2550S 制造商:Surge Components Inc 功能描述:CAP ALUM 270UF 400V ?20% 3000LHRS 25 X 50 - Bulk
LSM271M2G---3040S 制造商:Surge Components Inc 功能描述:CAP ALUM 270UF 400V ?20% 3000LHRS 30 X 40 - Bulk