參數資料
        型號: LS1601-7PDDB1
        元件分類: 電源模塊
        英文描述: 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE
        封裝: METAL, CASE S02, MODULE
        文件頁數: 13/25頁
        文件大小: 591K
        代理商: LS1601-7PDDB1
        Cassette Style
        100 Watt AC-DC (DC-DC) Converters
        S Series
        Edition 01/01.2001
        20/25
        E Inrush Current Limitation
        The converters may be supplemented by an electronic cir-
        cuit (option E, replacing the standard built-in NTC) to
        achieve an enhanced inrush current limiting function.
        Table 17: Inrush current characteristics with option E
        Characteristics
        LS
        Unit
        Ui = 230 V AC
        typ
        max
        Iinr p
        Peak inrush current
        25.3
        A
        tinr
        Inrush current duration
        35
        50
        ms
        Input
        Filter
        Control
        Converter
        FET
        Ci
        RI
        RS
        Rectifier
        PFC
        -
        Control
        1
        1001
        Fig. 27
        Option E block diagram
        Fig. 30
        Paralleling of single output units using option T with the
        sense lines connected at the load
        1 Leads should have equal length and cross sections and should
        run in the same cable loom.
        2 Diodes recommended in redundant operation only
        3 DC common point
        Precaution: Subsequent switch-on cycles at start-up
        are limited to max. 10 cycles during the rst 20 seconds
        (cold unit) and at continuing on/off (
        TC =95°C) max. 1
        cycle every 8 sec.
        Vo+
        Vo–
        Vo+
        Vo–
        Load
        Vo+
        Vo–
        11003
        T Current Sharing
        This option ensures that the output currents are approxi-
        mately shared between all paralleled modules and in-
        creases system reliability. To use this facility, simply inter-
        connect the T pins of all modules and make sure, that
        pins 14, the S– pin (LS 1000) or the Vo1– pins (LS 2000)
        are also connected together. The load leads should have
        equal length and cross section to ensure equal voltage
        drops. Not more than 5 units should be connected in paral-
        lel. If output voltage adjustment is requested we strongly
        recommend to use the R-input instead of option P, as with
        Fig. 29
        An example of poor wiring for connection in parallel
        15
        Ii [A]
        10
        5
        0
        –5
        –10
        –15
        0
        20
        40
        60
        80
        t [ms]
        tinr
        LS type
        Ui = 230 V AC
        Po = Po nom
        Capacitor Ci
        fully charged
        Normal operation
        (FET fully conducting)
        20
        10059
        Fig. 28
        Inrush current with option E
        Load
        1
        2
        3
        LS 1000
        S+
        Vo+
        Vo–
        S–
        N
        P
        T
        LS 1000
        N
        P
        S+
        Vo+
        Vo–
        S–
        T
        1
        max. 5 units connected in parallel
        11041
        Load
        max. 5 units in parallel connection
        +
        Power bus
        Module
        Vo2–
        Vo2+
        Vo1–
        Vo1+
        T
        Module
        Vo2–
        Vo2+
        Vo1–
        Vo1+
        T
        11037
        Fig. 31
        Paralleling of double output units using option T with
        power bus.
        option P the required setting accuracy is difcult to achieve.
        The output voltages must be individually set prior to paral-
        leling to within a tolerance of 1...2% or the R pins should be
        connected together.
        相關PDF資料
        PDF描述
        LS1601-7RD4B2 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE
        LS1601-9PD7B2 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE
        LS1601-9RD8TB2 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE
        LS2320-7ERD0TB2 2-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE
        LS2320-7PD8B2 2-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE
        相關代理商/技術參數
        參數描述
        LS1601-7R 功能描述:線性和開關式電源 Euro-Cassette 100W (24V) RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓(通道 1):20 V 輸出電流(通道 1):40 A 商用/醫用: 輸出電壓(通道 2): 輸出電流(通道 2): 安裝風格:Rack 長度: 寬度: 高度:
        LS1601-9ER 制造商:Power-One 功能描述:ACDC - Bulk
        LS1601-9ERB1 制造商:Power-One 功能描述:AC-DC 100 WATT PFC CONVERTER -40 TO 71 C COOL PLATE STD CASE - Bulk
        LS1601-9R 制造商:Power-One 功能描述:100W,AC,DC, 24V OUT, RUGGED - Bulk
        LS1608 制造商:ICE 制造商全稱:ice Components, Ins. 功能描述:Surface Mount Power Inductors