- 您現在的位置：買賣IC網 > PDF目錄44741 > LS1001-9RD2B2 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | LS1001-9RD2B2 |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE |
| 封裝： | METAL, CASE S02, MODULE |
| 文件頁數： | 20/25頁 |
| 文件大?。?/td> | 591K |
| 代理商： | LS1001-9RD2B2 |
Cassette Style
100 Watt AC-DC (DC-DC) Converters
S Series
Edition 01/01.2001
4/25
Static Input Current Characteristic
2
345
6
1
1.00
Ui DC
_______
Ui min DC
Ii (A)
3.00
0.40
04048
Fig. 4
Input current versus relative input voltage
Input Fuse
A fuse mounted inside the converter protects the module
against severe defects. If operated from a DC source this
fuse may not fully protect the module when the input volt-
age exceeds 200 V DC! In applications where the convert-
ers operate at source voltages above 200 V DC an external
fuse or a circuit breaker at system level should be installed!
Table 3: Fuse Specification
Module
Fuse type
Fuse rating
LS 1
slow-blow
SPT
4 A, 250 V
1 Fuse size 5
× 20 mm
Input Under-/Overvoltage Lock-out
If the input voltage remains below approx. 0.8
Ui min or ex-
ceeds approx. 1.1
Ui max, an internally generated inhibit sig-
nal disables the output(s). When checking this function the
absolute maximum input voltage rating
Ui abs should be
considered! Between
Ui min and the undervoltage lock-out
level the output voltage may be below the value defined in
table:
Output data (see: Technical Information: Measuring
and Testing).
Inrush Current Limitation
The modules of the versions -7 incorporate an NTC resistor
in the input circuitry which – at initial turn on – reduces the
peak inrush current value by a factor of 5...10 to protect
connectors and switching devices from damage. Subse-
quent switch-on cycles within short periods will cause an
increase of the peak inrush current value due to the warm-
ing-up of the NTC resistor. (See also:
option E)
Input Transient Protection
A VDR together with the input fuse and a symmetrical input
filter form an effective protection against high input tran-
sient voltages.
Inrush Current Peak Value
The inrush current peak value (initial switch-on cycle) can
be determined by following calculation: (See also:
Input In-
rush Current Characteristic).
Ui source
Iinr p = ––––––––––––––––
(
Rs ext + Ri + RNTC)
Rs ext
Ri
RNTC
Iinr p
Ui source
+
Ci int
04040
Fig. 3
Equivalent circuit diagram for input impedance
Electrical Input Data
General Conditions
–
TA = 25
°C, unless T
C is specified.
– Pin 18 connected to pin 14,
Uo adjusted to Uo nom (option P); R input not connected.
– Sense line pins S+ and S– connected to Vo+ and Vo– respectively.
Table 2: Input data
Input
LS
Characteristics
Conditions
min
typ
max
Unit
Ui
Operating input voltage
Io = 0...Io nom
85
264
V AC
TC min...TC max
88
372
V DC
Ui nom Nominal input voltage
310
3
Ii
Input current
Ui nom, Io nom 1
0.4
A
Pi0
No-load input power
Ui min...Ui max
2.5
W
Pi inh
Idle input power
unit inhibited
1.5
Ri
Input resistance
TC = 25°C
480
m
RNTC
NTC resistance 2
3200
Ci
Input capacitance
210
400
F
Ui RFI
Conducted input RFI
EN 55022
B
Radiated input RFI
Ui nom, Io nom
B
Ui abs
Input voltage limits
–400
400
V DC
without damage
–400
400
Vp
1 With double output modules, both outputs
loaded with
Io nom
2 Valid for -7 versions with NTC, (-9 versions ex-
clude the NTC). Initial switch-on cycle. Sub-
sequent switch-on/off cycles increase the in-
rush current peak value.
3 LS types may also be operated in DC mode.
(See:
S Series, DC-DC Converters)
AC frequency range 47...440 Hz (440 Hz
for 115 V mains).
Above 70 Hz (at
Ui = 264 V AC) the earth
lekage current may exceed 3.5 mA, speci-
fied in IEC/EN 60950. The built-in Y ca-
pacitors are specified for
≤100 Hz. Above
350 Hz the input voltage may not exceed
200 V AC.
相關PDF資料 |
PDF描述 |
|---|---|
| LS1001-9RD6TB2 | 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE |
| LS1301-7EPD8TB2 | 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE |
| LS1301-9ERDDTB2 | 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE |
| LS1501-7EPD2TB2 | 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE |
| LS1501-7RD0TB2 | 1-OUTPUT 100 W AC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LS1001A-W1 | 制造商:Black Box Corporation 功能描述:1 YEAR WARRANTY FOR LS1001A |
| LS10020-8PP8 | 制造商:LOCKHD 功能描述: |
| LS10024 | 制造商:TDK-Lambda Corporation 功能描述:AC/DC Power Supply Single-OUT 24V 4.5A 5-Pin 制造商:TDK-Lambda Corporation 功能描述:SNGL OUT,GEN PURP PWR,24V,22-27.2V,4.5A,192MV/96MV,BULK - Bulk 制造商:TDK-Lambda Corporation 功能描述:AC-DC CONV ENCLOSED 1 O/P 1 制造商:TDK-Lambda Corporation 功能描述:AC-DC CONV, ENCLOSED, 1 O/P, 100W, 4.5A, 制造商:TDK-Lambda Corporation 功能描述:AC-DC CONV, ENCLOSED, 1 O/P, 100W, 4.5A, 24V; Power Supply Output Type:Adjustable, Fixed; Input Voltage VAC:88V to 264V; No. of Outputs:1; Output Voltage Nom.:24V; Output Current Max:4.5A; Output Power Max:100W; Height:38.1mm ;RoHS Compliant: Yes 制造商:TDK-Lambda 功能描述:AC/DC Power Supply Single-OUT 24V 4.5A 5-Pin |
| LS100-24 | 功能描述:線性和開關式電源 108W 24V 4.5A AC-DC 115-230VAC RoHS:否 制造商:TDK-Lambda 產品:Switching Supplies 開放式框架/封閉式:Enclosed 輸出功率額定值:800 W 輸入電壓:85 VAC to 265 VAC 輸出端數量:1 輸出電壓（通道 1）:20 V 輸出電流（通道 1）:40 A 商用/醫用: 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:Rack 長度: 寬度: 高度: |
| LS10024/BML | 制造商:TDK-Lambda Corporation 功能描述:AC-DC, 115-230VAC, OUTPUT 24V 4.5A, 108W - Bulk |
發布緊急采購，3分鐘左右您將得到回復。