- 您現在的位置：買賣IC網 > PDF目錄44729 > LPR503AL (STMICROELECTRONICS) SPECIALTY ANALOG CIRCUIT, PBGA16 PDF資料下載
參數資料
| 型號： | LPR503AL |
| 廠商： | STMICROELECTRONICS |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PBGA16 |
| 封裝： | 5 X 5 MM, 1.50 MM HEIGHT, ROHS COMPLIANT, PLASTIC, LGA-16 |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 218K |
| 代理商： | LPR503AL |
Application hints
LPR503AL
8/12
Doc ID 15810 Rev 2
4
Application hints
Figure 3.
LPR503AL electrical connections and external component values
Power supply decoupling capacitors (100 nF ceramic or polyester + 10 F Aluminum)
should be placed as near as possible to the device (common design practice).
The LPR503AL allows band limiting the output rate response through the use of an external
low pass filter (suggested) and/or high pass filter (optional) in addition to the embedded low
pass filter (ft = 140 Hz).
4xOUTX and 4xOUTY are respectively OUTX and OUTY amplified outputs lines, internally
buffered to ensure low output impedance.
If external high pass or low pass filtering is not applied it is mandatory to short-circuit
respectively pad 4 to pad 5 and pad 9 to pad 10 when amplified outputs are used.
When only not-amplified outputs are used (OUTX/Y), it is suggested to set pads 5 and 9 to
fixed reference voltage (GND/Vref).
When high pass filter is applied to not amplified output (OUTx), it is recommended to buffer
the line before entering ADC for performance optimization.
The LPR503AL IC includes a PLL (phase locked loop) circuit to synchronize driving and
sensing interfaces. Capacitors and resistors must be added at the FILTVDD and VCONT
pins (as shown in
Figure 3) to implement a low-pass filter.
100 nF
10kOhm
470nF
Vdd
GND
HP
Vref
4xOUTY
C2
R1
C1
GND
10 F
GND
Recomeded
Low-pass filter
LPR503AL
(Top View)
1
16
14
13
9
8
6
5
10nF
PD
ST
GND
Vref
4x
OU
T
X
Optional
High-pass filter
Vref
GND
Typical values:
C1
R1
C2
R2
C1
R1
C2
R2
R1 = 1MOhm
C1 = 4.7 F
R2 = 33kOhm
C2 = 2.2 F to 2.2 F
Not amplified
(TOP VIEW)
DIRECTION OF THE
DETECTABLE
ANGULAR RATES
filtered output Y
Not amplified
filtered output X
+
Y
+
X
相關PDF資料 |
PDF描述 |
|---|---|
| LPR5150ALTR | SPECIALTY ANALOG CIRCUIT, PBGA16 |
| LPR5150AL | SPECIALTY ANALOG CIRCUIT, PBGA16 |
| LPR550AL | SPECIALTY ANALOG CIRCUIT, PBGA16 |
| LPR550ALTR | SPECIALTY ANALOG CIRCUIT, PBGA16 |
| LPS24 | 1-OUTPUT 40 W AC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPR503ALTR | 功能描述:螺旋儀 MEMS 30 / 120 2.7V to 3.6V PS RoHS:否 制造商:Murata 傳感軸:Triple 靈敏度: 輸出類型:Digital 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:5 mA 封裝 / 箱體: |
| LPR504 | 制造商:MIC 制造商全稱:MIC GROUP RECTIFIERS 功能描述:PRESS FIT AUTOMOTIVE RECTIFIER (LUCAS) |
| LPR506 | 制造商:MIC 制造商全稱:MIC GROUP RECTIFIERS 功能描述:PRESS FIT AUTOMOTIVE RECTIFIER (LUCAS) |
| LPR510AL | 功能描述:螺旋儀 Dual 2.5 mV deg/s LGA-16 RoHS:否 制造商:Murata 傳感軸:Triple 靈敏度: 輸出類型:Digital 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:5 mA 封裝 / 箱體: |
| LPR510ALTR | 功能描述:螺旋儀 MEMS 100 / 400 2.7V to 3.6V PS RoHS:否 制造商:Murata 傳感軸:Triple 靈敏度: 輸出類型:Digital 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:5 mA 封裝 / 箱體: |
發布緊急采購，3分鐘左右您將得到回復。