參數資料
型號: LPC2888FET180
廠商: NXP SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface
中文描述: 32-BIT, FLASH, 60 MHz, RISC MICROCONTROLLER, PBGA180
封裝: 10 X 10 MM, 0.80 MM HEIGHT, PLASTIC, MO-195, SOT-640-1, TFBGA-180
文件頁數: 22/34頁
文件大小: 139K
代理商: LPC2888FET180
LPC2880_LPC2888_1
Koninklijke Philips Electronics N.V. 2006. All rights reserved.
Preliminary data sheet
Rev. 01 — 22 June 2006
22 of 34
Philips Semiconductors
LPC2880; LPC2888
16/32-bit ARM microcontrollers with external memory interface
Endpoints with small packet sizes can be handled by software via registers in the USB
controller. In particular, Control Endpoint 0 is always handled in this way.
6.17.1
Features
Fully compliant with USB 2.0 specification (HS and FS).
16 physical endpoints.
Supports Control, Bulk, Interrupt and Isochronous endpoints.
Endpoint type selection by software
Endpoint maximum packet size setting by software
Supports Soft Connect feature (requires an external 1.5 k
resistor connected to the
USB_RPU pad).
Supports bus-powered capability with low suspend current.
Four Read/Write DMA channels.
Supports Burst data transfers on the AHB.
Supports Retry and Split transactions on the AHB.
6.18 SD/MMC card interface
The Secure Digital and Multimedia Card Interface (MCI) is an interface between the
Advanced Peripheral Bus (APB) system bus and multimedia and/or secure digital memory
cards.
The interface provides all functions specific to the Secure Digital/MultiMedia memory
card, such as the clock generation unit, power management control, command, data
transfer, interrupt generation, and DMA request generation.
6.18.1
Features
Conformance to Multimedia Card Specification v2.11.
Conformance to Secure Digital Memory Card Physical Layer Specification, v0.96.
Use as a multimedia card bus or a secure digital memory card bus host. It can be
connected to several multimedia cards, or a single secure digital memory card.
DMA transfers are supported through the Simple DMA facility.
6.19 LCD interface
The LCD interface contains logic to interface to a 6800 or 8080 bus compatible LCD
controller. The LCD interface is compatible with the 6800 bus standard and the 8080 bus
standard, with one address pin (RS) for selecting the data or instruction register.
The LCD interface makes use of a configurable clock (programmed in the CGU) to adjust
the speed of the 6800/8080 bus to the speed of the connected peripheral.
6.19.1
Features
8-bit or 4-bit parallel interface mode: 6800-series, 8080-series.
Supports multiple frequencies for the bus, to support high and low speed LCD
controllers.
相關PDF資料
PDF描述
LPC2917 ARM9 microcontroller with CAN and LIN
LPC2919 ARM9 microcontroller with CAN and LIN
LPC3180 16/32-bit ARM microcontroller; hardware floating-point coprocessor, USB On-The-Go, and SDRAM memory interface
LPC61W26X Microcontroller
LPC61W49X Microcontroller
相關代理商/技術參數
參數描述
LPC2888FET180,551 功能描述:ARM微控制器 - MCU ARM7 1MF/64KR/USBH RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC2888FET180/01 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:16/32-bit ARM microcontrollers; 8 kB cache, up to 1 MB flash, Hi-Speed USB 2.0 device, and SDRAM memory interface
LPC2888FET180/01,5 功能描述:ARM微控制器 - MCU 16/32 bit micro RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT
LPC2888FET180/D,55 制造商:NXP Semiconductors 功能描述:PHALPC2888FET180/D.551 32BIT ARM7 HS USB
LPC2888FET180/D,551 制造商:NXP Semiconductors 功能描述: