- 您現在的位置：買賣IC網 > PDF目錄1932 > LPC11U14FET48/201, (NXP Semiconductors)IC MCU 32BIT 32K 48TFBGA PDF資料下載
參數資料
| 型號： | LPC11U14FET48/201, |
| 廠商： | NXP Semiconductors |
| 文件頁數： | 49/72頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC MCU 32BIT 32K 48TFBGA |
| 產品培訓模塊： | Code Density for LPC11xx |
| 標準包裝： | 490 |
| 系列： | LPC11Uxx |
| 核心處理器： | ARM? Cortex?-M0 |
| 芯體尺寸： | 32-位 |
| 速度： | 50MHz |
| 連通性： | I²C，Microwire，智能卡，SPI，SSP，UART/USART，USB |
| 外圍設備： | 欠壓檢測/復位，POR，WDT |
| 輸入/輸出數： | 40 |
| 程序存儲器容量： | 32KB（32K x 8） |
| 程序存儲器類型： | 閃存 |
| RAM 容量： | 6K x 8 |
| 電壓 - 電源 (Vcc/Vdd)： | 1.8 V ~ 3.6 V |
| 數據轉換器： | A/D 8x10b |
| 振蕩器型： | 內部 |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 48-TFBGA |
| 包裝： | 托盤 |
| 其它名稱： | 568-8578 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁當前第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
LPC11U1X
All information provided in this document is subject to legal disclaimers.
NXP Semiconductors N.V. 2014. All rights reserved.
Product data sheet
Rev. 2.2 — 11 March 2014
53 of 72
NXP Semiconductors
LPC11U1x
32-bit ARM Cortex-M0 microcontroller
For a bus-powered device, the VBUS signal does not need to be connected to the
USB_VBUS pin (see Figure 27). The USB_CONNECT function can additionally be
connected as shown in Figure 26 to prevent the USB from timing out when there is a
significant delay between power-up and handling USB traffic.
Remark: When a bus-powered circuit as shown in Figure 27 is used, configure the
PIO0_3/USB_VBUS pin for GPIO (PIO0_3) in the IOCON block to ensure that the
USB_CONNECT signal can still be controlled by software. For details on the soft-connect
feature, see the LPC11U1x user manual (Ref. 1).
Remark: When a self-powered circuit is used without connecting VBUS, configure the
PIO0_3/USB_VBUS pin for GPIO (PIO0_3) and provide software that can detect the host
presence through some other mechanism before enabling USB_CONNECT and the
soft-connect feature. Enabling the soft-connect without host presence will lead to USB
compliance failure.
11.2 XTAL input
The input voltage to the on-chip oscillators is limited to 1.8 V. If the oscillator is driven by a
clock in slave mode, it is recommended that the input be coupled through a capacitor with
Ci = 100 pF. To limit the input voltage to the specified range, choose an additional
capacitor to ground Cg which attenuates the input voltage by a factor Ci/(Ci + Cg). In slave
mode, a minimum of 200 mV(RMS) is needed.
Fig 27. USB interface on a bus-powered device
LPC1xxx
VDD
R1
1.5 kΩ
aaa-010179
USB-B
connector
USB_DP
USB_DM
VSS
RS = 33 Ω
REGULATOR
VBUS
相關PDF資料 |
PDF描述 |
|---|---|
| LPC11U24FBD64/401 | IC MCU USB 64LQFP |
| LPC1227FBD64/301,1 | MCU 32BIT 128K FLASH 8K 64-LQFP |
| LPC12D27FBD100/301 | MCU 32BIT ARM CORTEX-M0 100-LQFP |
| LPC1315FBD48,551 | IC MCU 32BIT 32KB FLASH 48LQFP |
| LPC1343FBD48,151 | IC MCU 32BIT 32KB FLASH 48LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LPC11U14FHI33.201 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; up to 32 kB flash; 6 kB SRAM; USB device; USART |
| LPC11U14FHI33/201 | 制造商:NXP Semiconductors 功能描述:MCU 32BIT ARM CORTEX M0 32HVQFN |
| LPC11U14FHI33/201, | 功能描述:ARM微控制器 - MCU 32-bit ARM Cortex-M0 MCU RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 處理器系列:STM32F373xx 數據總線寬度:32 bit 最大時鐘頻率:72 MHz 程序存儲器大小:256 KB 數據 RAM 大小:32 KB 片上 ADC:Yes 工作電源電壓:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LQFP-48 安裝風格:SMD/SMT |
| LPC11U14FHN201 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:32-bit ARM Cortex-M0 microcontroller; up to 32 kB flash; 6 kB SRAM; USB device; USART |
| LPC11U14FHN33 | 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-cost Cortex-M0 USB solutions with Smart Card interface |
發布緊急采購，3分鐘左右您將得到回復。