- 您現在的位置：買賣IC網 > PDF目錄299412 > LP8900TLE-AACB (NATIONAL SEMICONDUCTOR CORP) DUAL OUTPUT, FIXED POSITIVE LDO REGULATOR, PBGA6 PDF資料下載
參數資料
| 型號： | LP8900TLE-AACB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 固定正電壓多路輸出LDO穩壓器 |
| 英文描述： | DUAL OUTPUT, FIXED POSITIVE LDO REGULATOR, PBGA6 |
| 封裝： | 1.50 X 1.10 MM, LEAD FREE, SMD-6 |
| 文件頁數： | 2/14頁 |
| 文件大?。?/td> | 341K |
| 代理商： | LP8900TLE-AACB |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁
range, it would have to be larger in capacitance (which means
bigger and more costly) than a ceramic capacitor with the
same ESR value. It should also be noted that the ESR of a
typical tantalum will increase about 2:1 as the temperature
goes from 25°C down to -40°C, so some guard band must be
allowed.
ENABLE CONTROL
The LP8900 may be switched ON or OFF by a logic input at
the ENABLE pin.A high voltage at this pin will turn the device
on. When the enable pin is low, the regulator output is off and
the device typically consumes 3nA. However if the application
does not require the shutdown feature, the V
EN pin can be tied
to V
IN to keep the regulator permanantly on. To ensure fast
start-up is achieved, V
EN should be driven separately.
A 3M
pulldown resister ties the V
EN input to ground, this en-
sures that the device will remain off when the enable pin is
left open circuit. To ensure proper operation, the signal source
used to drive the V
EN input must be able to swing above and
below the specified turn-on/off voltage thresholds listed in the
Electrical Characteristics section under V
IL and VIH.
micro SMD MOUNTING
The micro SMD package requires specific mounting tech-
niques which are detailed in the National Semiconductor
Application Note (AN-1112). Referring to the section Surface
Mount Technology (SMT) Assenbly Considerations, it should
be noted that the pad style which must be used with the 6 pin
package is NSMD (non-solder mask defined) type.
For best results during assembly, alignment ordinals on the
PCB may be used to facilitate placement of the micro SMD
device.
micro SMD LIGHT SENSITIVITY
Exposing the micro SMD device to direct sunlight may cause
mis-operation of the device. Light sources such as halogen
lamps can affect the electrical performance if brought near to
the device.
The wavelengths which have most detrimental effect are reds
and infra-reds, which means that fluorescent lighting, used
inside most buildings will have little effect on performance.
www.national.com
10
LP8900
相關PDF資料 |
PDF描述 |
|---|---|
| LP8900TLX-3333 | DUAL OUTPUT, FIXED POSITIVE LDO REGULATOR, PBGA6 |
| LP8900TLX-AACB | DUAL OUTPUT, FIXED POSITIVE LDO REGULATOR, PBGA6 |
| LPD301-150-03-PM-100 | Analog IC |
| LPD301-150-03-PM-150 | Analog IC |
| LPD301-150-03-PM-200 | Analog IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP8900TLE-AAEB/NOPB | 功能描述:線性穩壓器 - 標準 RoHS:否 制造商:STMicroelectronics 輸出類型: 極性: 輸出電壓:1.8 V 輸出電流:150 mA 負載調節: 最大輸入電壓:5.5 V 線路調整率: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-323-5L |
| LP8900TLE-AAEC/NOPB | 功能描述:線性穩壓器 - 標準 RoHS:否 制造商:STMicroelectronics 輸出類型: 極性: 輸出電壓:1.8 V 輸出電流:150 mA 負載調節: 最大輸入電壓:5.5 V 線路調整率: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-323-5L |
| LP8900TLX_3333 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Ultra Low Noise, Dual 200mA Linear Regulator for RF/Analog Circuits |
| LP8900TLX_AAAH | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Ultra Low Noise, Dual 200mA Linear Regulator for RF/Analog Circuits |
| LP8900TLX_AACB | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Ultra Low Noise, Dual 200mA Linear Regulator for RF/Analog Circuits |
發布緊急采購，3分鐘左右您將得到回復。