- 您現在的位置：買賣IC網 > PDF目錄385493 > LP3947 (National Semiconductor Corporation) USB/AC Adaptor, Single Cell Li-Ion Battery Charger IC PDF資料下載
參數資料
| 型號： | LP3947 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | USB/AC Adaptor, Single Cell Li-Ion Battery Charger IC |
| 中文描述： | 的USB / AC適配器，單節鋰離子電池充電器IC |
| 文件頁數： | 10/14頁 |
| 文件大小： | 649K |
| 代理商： | LP3947 |
Application Notes
(Continued)
TABLE 2. LED Indicator Summary
RED LED
(CHG)
OFF
ON
OFF
OFF
OFF
OFF
ON
GREEN LED
(EOC)
OFF
OFF
ON
ON
ON
OFF
ON
Charger Off
Charging Li Ion Battery*
Maintenance Mode
Charging Li Ion Battery after Passing Maintenance Mode
EN Pin = LOW
LDO Mode
5.6 Hr Safety Timer Flag/Battery Temperature Violation
* Charging Li Ion battery for the first time after V
CHG-IN
insertion.
Ts PIN
The LP3947 continuously monitors the battery temperature
by measuring the voltage between the Ts pin and ground.
Charging stops if the battery temperature is outside the
permitted temperature range set by the battery’s internal
thermistor R
and the external bias resistor R
. A 1% preci-
sion resistor should be used for R
Acurve 2 type thermistor
is recommended for R
. The voltage across R
is propor-
tional to the battery temperature. If the battery temperature is
outside of the range during the charge cycle, the LP3947 will
suspend charging. As an example, for a temperature range
of 0C to 50C, a 10k
for the thermistor and a 4.1k
for R
s
should be used. When battery temperature returns to the
permitted range, charging resumes from the beginning of the
flow chart and the 5.6 hr safety timer is reset. Refer to
Figure
3
. LP3947 Charger Flow Chart for more information.
In absence of the thermistor, Ts pin will be pulled high to VT
and the LP3947 goes into LDO mode. In this mode, the
internal power FET provides up to 1.2 amp of current at the
BATT pin. The LDO output is set to 4.1V or 4.2V, depending
on the programmed battery regulation voltage. When oper-
ating at higher output currents, care must be taken not to
exceed the package power dissipation rating. See “Thermal
Performance of LLP Package” section for more detail.
Charger Status in Relation to Ts Voltage
Voltage on the Ts Pin
Ts
≥
2.7V
Charger Status
LDO Mode
Voltage on the Ts Pin
2.427v
≤
Ts
<
2.7V
0V
≤
Ts
≤
1.39V
1.39V
<
Ts
<
2.427V
Charger Status
Charger Off
Charger On
LDO MODE
The charger is in the LDO mode when the Ts pin is left
floating. This mode of operation is used primarily during
system level testing of the handset to eliminate the need for
battery insertion.
CAUTION:
battery may be damaged if
device is operating in LDO mode with battery connected.
The internal power FET provides up to 1.2 amp of current at
BATT pin in this mode. The LDO output is set to 4.1V. When
operating at higher output currents, care must be taken not
to exceed the package power dissipation rating. See “Ther-
mal Performance of LLP Package” section for more detail.
EN PIN
The Enable pin is used to enable/disable the charger, in both
the charger mode and the LDO mode, see
Figures 5, 6
. The
enable pin is internally pulled HIGH to the CHG-IN pin. When
the charger is disabled, it draws less than 4 μA of current.
L
www.national.com
10
相關PDF資料 |
PDF描述 |
|---|---|
| LP3963-1.8 | 3A Fast Ultra Low Dropout Linear Regulators |
| LP3966-1.8 | 3A Fast Ultra Low Dropout Linear Regulators |
| LP3966-ADJ | 3A Fast Ultra Low Dropout Linear Regulators |
| LP3970 | Power Management Unit for Advanced Application Processors |
| LP3972 | Power Management Unit for Advanced Application Processors |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP3947ISD-09 | 功能描述:電池管理 RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| LP3947ISD-09/NOPB | 功能描述:電池管理 RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| LP3947ISD-51 | 功能描述:電池管理 RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| LP3947ISD-51/NOPB | 功能描述:電池管理 RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| LP3947ISD-51EV | 功能描述:電源管理IC開發工具 LP3947 EVAL BOARD RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
發布緊急采購，3分鐘左右您將得到回復。