- 您現在的位置：買賣IC網 > PDF目錄44717 > LP3906SQ-TKXII (NATIONAL SEMICONDUCTOR CORP) SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, QCC24 PDF資料下載
參數資料
| 型號： | LP3906SQ-TKXII |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| 封裝： | 5 X 4 MM, 0.80 MM HEIGHT, LLP-24 |
| 文件頁數： | 10/40頁 |
| 文件大?。?/td> | 4200K |
| 代理商： | LP3906SQ-TKXII |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
POWER ON
EN_T assertion causes the LP3906 to emerge from Standby
mode to Full Operation mode at a preset timing sequence. By
default, the enables for the LDOs and Bucks are internally
pulled up, which causes the part to turn ON automatically. If
the user wishes to have a preset timing sequence to power
on the regulators, the external regulator enables must be tied
LOW. Otherwise, simply tie the enables of each specific reg-
ulator HIGH.
EN_T is edge triggered with rising edge signaling the chip to
power on. The EN_T input is deglitched and the default is set
at 1 ms. As shown in the next 2 diagrams, a rising EN_T edge
will start a power on sequence, while a falling EN_T edge will
start a shutdown sequence. If EN_T is high, toggling the ex-
ternal enables of the regulators will have no effect on the chip.
Default Power ON Sequence:
t
1 (ms)
t
2 (ms)
t
3 (ms)
t
4 (ms)
1.5
2.0
3
6
Note: LP3906 The default Power on delays can be reprogrammed at final
test or by using I2C registers to 1, 1.5, 2, 3, 6, or 11 ms.
The regulators can also be programmed through I2C to turn
on and off. By default, the I2C enables for the regulators are
ON.
The regulators are on following the pattern below:
Regulators on = (I2C enable) AND (External pin enable OR
EN_T high).
20197809
www.national.com
18
LP3906
相關PDF資料 |
PDF描述 |
|---|---|
| LP3906SQX-TKXII | SWITCHING REGULATOR, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| LP3906SQDJXI | 2 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| LP3906SQXJXXI | 2 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| LP3906SQXVPFP | 2 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
| LP3906SQXPPXP | 2 A DUAL SWITCHING CONTROLLER, 2000 kHz SWITCHING FREQ-MAX, QCC24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP3906SQ-TKXII/NOPB | 功能描述:低壓差穩壓器 - LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| LP3906SQ-VPFP | 制造商:Rochester Electronics LLC 功能描述: 制造商:Texas Instruments 功能描述: |
| LP3906SQ-VPFP S7002740 | 制造商:Texas Instruments 功能描述:- Tape and Reel 制造商:Texas Instruments 功能描述:Texas Instruments LP3906SQ-VPFP S7002740 |
| LP3906SQ-VPFP/NOPB | 功能描述:其他電源管理 RoHS:否 制造商:Texas Instruments 輸出電壓范圍: 輸出電流:4 mA 輸入電壓范圍:3 V to 3.6 V 輸入電流: 功率耗散: 工作溫度范圍:- 40 C to + 110 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-48 封裝:Reel |
| LP3906SQX-DJXI | 制造商:Texas Instruments 功能描述:Power Management Unit 24-Pin LLP EP T/R |
發布緊急采購，3分鐘左右您將得到回復。