- 您現在的位置：買賣IC網 > PDF目錄358922 > LP38691SDX-ADJ (NATIONAL SEMICONDUCTOR CORP) 500mA Low Dropout CMOS Linear Regulators with Adjustable Output / Stable with Ceramic Output Capacitors PDF資料下載
參數資料
| 型號： | LP38691SDX-ADJ |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 500mA Low Dropout CMOS Linear Regulators with Adjustable Output / Stable with Ceramic Output Capacitors |
| 中文描述： | 1.25 V-9 V ADJUSTABLE POSITIVE LDO REGULATOR, PDSO6 |
| 封裝： | LLP-6 |
| 文件頁數： | 5/15頁 |
| 文件大?。?/td> | 793K |
| 代理商： | LP38691SDX-ADJ |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁
Electrical Characteristics
Limits in standard typeface are for T
J
= 25C, and limits in
boldface type
apply
over the full operating temperature range. Unless otherwise specified: V
= V
+ 1V, C
IN
= C
OUT
= 10 μF, I
LOAD
= 10mA.
Min/Max limits are guaranteed through testing, statistical correlation, or design. (Continued)
Symbol
Parameter
Conditions
MIN
TYP
(Note 4)
MAX
Units
e
n
Output Noise
BW = 10Hz to 10kHz
V
O
= 3.3V
V
O
= V
O
(NOM) + 1V
@
10V
IN
Output = OFF
Output = ON, V
IN
= 4V
Output = ON, V
IN
= 6V
Output = ON, V
IN
= 10V
V
EN
= 0V or 10V, V
IN
= 10V
0.7
μV/
V
O
(LEAK)
V
EN
Output Leakage Current
Enable Voltage (LP38693 Only)
0.5
12
0.4
μA
V
1.8
3.0
4.0
-1
I
EN
Enable Pin Leakage (LP38693
Only)
0.001
1
μA
Note 1:
Absolute maximum ratings indicate limits beyond which damage to the component may occur. Operating ratings indicate conditions for which the device
is intended to be functional, but do not guarantee specific performance limits. For guaranteed specifications, see Electrical Characteristics. Specifications do not
apply when operating the device outside of its rated operating conditions.
Note 2:
At elevated temperatures, device power dissipation must be derated based on package thermal resistance and heatsink values (if a heatsink is used). The
junction-to-ambient thermal resistance (
θ
J-A
) for the TO-252 is approximately 90C/W for a PC board mounting with the device soldered down to minimum copper
area (less than 0.1 square inch). If one square inch of copper is used as a heat dissipator for the TO-252, the
θ
J-A
drops to approximately 50C/W. The SOT-223
package has a
θ
J-A
of approximately 125C/W when soldered down to a minimum sized pattern (less than 0.1 square inch) and approximately 70C/W when soldered
to a copper area of one square inch. The
θ
J-A
values for the LLP package are also dependent on trace area, copper thickness, and the number of thermal vias used
(refer to application note AN-1187). If power disspation causes the junction temperature to exceed specified limits, the device will go into thermal shutdown.
Note 3:
ESD is tested using the human body model which is a 100pF capacitor discharged through a 1.5k resistor into each pin.
Note 4:
Typical numbers represent the most likely parametric norm for 25C operation.
Note 5:
If used in a dual-supply system where the regulator load is returned to a negative supply, the output pin must be diode clamped to ground.
Note 6:
Output voltage line regulation is defined as the change in output voltage from nominal value resulting from a change in input voltage.
Note 7:
Output voltage load regulation is defined as the change in output voltage from nominal value as the load current increases from 1mA to full load.
Note 8:
Dropout voltage is defined as the minimum input to output differential required to maintain the output within 100mV of nominal value.
L
www.national.com
5
相關PDF資料 |
PDF描述 |
|---|---|
| LP38691SD-1.8 | 500mA Low Dropout CMOS Linear Regulators Stable with Ceramic Output Capacitors |
| LP38691SD-2.5 | 500mA Low Dropout CMOS Linear Regulators Stable with Ceramic Output Capacitors |
| LP38691SD-3.3 | 500mA Low Dropout CMOS Linear Regulators Stable with Ceramic Output Capacitors |
| LP38691SD-5.0 | Round, Jacketed, Discrete, Twisted Pair Cable, 3647B/36 28 AWG, |
| LP38691SDX-1.8 | Round, Jacket Mass-Terminated Cable, 3659/09 28 AWG, .050 (1.27) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LP38691SDX-ADJ/NOPB | 功能描述:低壓差穩壓器 - LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| LP38692 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:1A Low Dropout CMOS Linear Regulators |
| LP38692-ADJ | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:1A Low Dropout CMOS Linear Regulators with Adjustable Output Stable with Ceramic Output Capacitors |
| LP38692EVAL | 功能描述:電源管理IC開發工具 LP38692 EVAL BOARD RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| LP38692MP-1.8 | 功能描述:低壓差穩壓器 - LDO RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。