參數資料
型號: LOG2112AIDWE4
廠商: TEXAS INSTRUMENTS INC
元件分類: 模擬運算功能
英文描述: LOG OR ANTILOG AMPLIFIER, PDSO16
封裝: ROHS COMPLIANT, PLASTIC, MS-013AA, SOIC-16
文件頁數: 19/20頁
文件大?。?/td> 621K
代理商: LOG2112AIDWE4
LOG112, 2112
8
SBOS246D
www.ti.com
FIGURE 7. Precision Current Inverter/Current Source.
Figure 5 shows a low-level current source using a series
resistor. The low offset op amp reduces the effect of the
LOG112 and LOG2112’s input offset voltage.
FREQUENCY COMPENSATION
Frequency compensation for the LOG112 is obtained by
connecting a capacitor between pins 5 and 14. Frequency
compensation for the LOG2112 is obtained by connecting a
capacitor between pins 2 and 5, or 15 and 12. The size of the
capacitor is a function of the input currents, as shown in the
Typical Characteristic curves (
Minimum Value of Compensa-
tion Capacitor). For any given application, the smallest value
of the capacitor which may be used is determined by the
maximum value of I2 and the minimum value of I1. Larger
values of CC make the LOG112 and LOG2112 more stable,
but reduce the frequency response.
In an application, highest overall bandwidth can be achieved
by detecting the signal level at VOUT, then switching in
appropriate values of compensation capacitors.
NEGATIVE INPUT CURRENTS
The LOG112 and LOG2112 function only with positive input
currents (conventional current flows into input current pins).
In situations where negative input currents are needed, the
circuits in Figures 6, 7, and 8 may be used.
FIGURE 5. Current Source with Offset Compensation.
1M
+2.5mV
100k
–2.5V
+2.5V
OPA335
100
I
1 = 2.5nA to 1mA
I
2 = 2.5nA
V
LOGOUT
C
14
1
910
V–
LOG112
6
5
V+
8
V
REF
Chopper Op Amp
GND
FIGURE 6. Current Inverter/Current Source.
Q
B
National
LM394
I
IN
I
OUT
D
1
OPA703
D
2
Q
A
FREQUENCY RESPONSE
The frequency response curves seen in the Typical Charac-
teristic curves are shown for constant DC I1 and I2 with a
small-signal AC current on one input.
The 3dB frequency response of the LOG112 and LOG2112 are
a function of the magnitude of the input current levels and of the
value of the frequency compensation capacitor. See Typical
Characteristic curve,
3dB Frequency Response for details.
The transient response of the LOG112 and LOG2112 are
different for increasing and decreasing signals. This is due to
the fact that a log amp is a nonlinear gain element and has
different gains at different levels of input signals. Smaller
input currents require greater gain to maintain full dynamic
range, and will slow the frequency response of the LOG112
and LOG2112.
1.5k
Photodiode
10nA to 1mA
+5V
1k
+3.3V(1)
1/2
OPA2335
1/2
OPA2335
BSH203
TLV271 or 1/2 OPA2335
(+3.3V
Back Bias)
LOG112
Pin 1 or Pin 14
NOTE: (1) +3.3V bias is an arbitrary ac level < 5V that also
appears on the
IN through the op amp where it
applies a reverse bias to the photodiode.
相關PDF資料
PDF描述
LOG2112AIDW LOG OR ANTILOG AMPLIFIER, 1.4 MHz BAND WIDTH, PDSO16
LOG2112AIDWRE4 LOG OR ANTILOG AMPLIFIER, PDSO16
LOG112AIDE4 LOG OR ANTILOG AMPLIFIER, PDSO14
LOG112AID LOG OR ANTILOG AMPLIFIER, 1.4 MHz BAND WIDTH, PDSO14
LOG112AIDRE4 LOG OR ANTILOG AMPLIFIER, 1.4 MHz BAND WIDTH, PDSO14
相關代理商/技術參數
參數描述
LOG2112AIDWR 功能描述:對數放大器 Precision Log & Log Ratio Amp RoHS:否 制造商:Texas Instruments 通道數量:3 帶寬:3 dB 共模抑制比(最小值): 輸入補償電壓:+/- 7 mV 輸入電壓范圍(最大值):5.5 V 工作電源電壓:4.5 V to 5.5 V 電源電流:+/- 15 mA 工作溫度范圍:- 40 C to +85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-16 封裝:Reel
LOG2112AIDWRE4 功能描述:對數放大器 Precision Log & Log Ratio Amp RoHS:否 制造商:Texas Instruments 通道數量:3 帶寬:3 dB 共模抑制比(最小值): 輸入補償電壓:+/- 7 mV 輸入電壓范圍(最大值):5.5 V 工作電源電壓:4.5 V to 5.5 V 電源電流:+/- 15 mA 工作溫度范圍:- 40 C to +85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-16 封裝:Reel
LOGIC 制造商:SALEAE LLC 功能描述:8 Channel Logic Analyzer
LOGIC PCBA 制造商:Misc 功能描述:
LOGIC SIZE 11 制造商:DEWALT 功能描述:DEWALT LOGIC SIZE 11