- 您現在的位置：買賣IC網 > PDF目錄384603 > LMD18200T (NATIONAL SEMICONDUCTOR CORP) 3A, 55V H-Bridge PDF資料下載
參數資料
| 型號： | LMD18200T |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 外設及接口 |
| 英文描述： | 3A, 55V H-Bridge |
| 中文描述： | 6 A HB BASED PRPHL DRVR WITH PWM, ZFM11 |
| 封裝： | TO-220, 11 PIN |
| 文件頁數： | 8/13頁 |
| 文件大?。?/td> | 439K |
| 代理商： | LMD18200T |
Application Information
(Continued)
INTERNAL CHARGE PUMP AND USE OF BOOTSTRAP
CAPACITORS
To turn on the high-side (sourcing) DMOS power devices,
the gate of each device must be driven approximately 8V
more positive than the supply voltage. To achieve this an in-
ternal charge pump is used to provide the gate drive voltage.
As shown in Figure 5 an internal capacitor is alternately
switched to ground and charged to about 14V, then switched
to V supply thereby providing a gate drive voltage greater
than V supply. This switching action is controlled by a con-
tinuously running internal 300 kHz oscillator. The rise time of
this drive voltage is typically 20 μs which is suitable for oper-
ating frequencies up to 1 kHz.
For higher switching frequencies, the LMD18200 provides
for the use of external bootstrap capacitors. The bootstrap
principle is in essence a second charge pump whereby a
large value capacitor is used which has enough energy to
quickly charge the parasitic gate input capacitance of the
power device resulting in much faster rise times. The switch-
ing action is accomplished by the power switches them-
selves Figure 6 External 10 nF capacitors, connected from
the outputs to the bootstrap pins of each high-side switch
provide typically less than 100 ns rise times allowing switch-
ing frequencies up to 500 kHz.
INTERNAL PROTECTION DIODES
A major consideration when switching current through induc-
tive loads is protection of the switching power devices from
the large voltage transients that occur. Each of the four
switches in the LMD18200 have a built-in protection diode to
clamp transient voltages exceeding the positive supply or
ground to a safe diode voltage drop across the switch.
The reverse recovery characteristics of these diodes, once
the transient has subsided, is important. These diodes must
come out of conduction quickly and the power switches must
be able to conduct the additional reverse recovery current of
the diodes. The reverse recovery time of the diodes protect-
ing the sourcing power devices is typically only 70 ns with a
reverse recovery current of 1A when tested with a full 6A of
forward current through the diode. For the sinking devices
the recovery time is typically 100 ns with 4A of reverse cur-
rent under the same conditions.
Typical Applications
FIXED OFF-TIME CONTROL
This circuit controls the current through the motor by apply-
ing an average voltage equal to zero to the motor terminals
for a fixed period of time, whenever the current through the
motor exceeds the commanded current. This action causes
the motor current to vary slightly about an externally con-
trolled average level. The duration of the Off-period is ad-
justed by the resistor and capacitor combination of the
LM555. In this circuit the Sign/Magnitude mode of operation
is implemented (see Types of PWM Signals).
DS010568-6
FIGURE 5. Internal Charge Pump Circuitry
DS010568-7
FIGURE 6. Bootstrap Circuitry
L
www.national.com
8
相關PDF資料 |
PDF描述 |
|---|---|
| LMD18201 | 3A, 55V H-Bridge |
| LMD18201T | 3A, 55V H-Bridge |
| LMD18245 | 3A, 55V DMOS Full-Bridge Motor Driver |
| LMD18245T | 3A, 55V DMOS Full-Bridge Motor Driver |
| LMD18400 | Quad High Side Driver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LMD18200T | 制造商:Texas Instruments 功能描述:HALF BRIDGE 3A 55V 18200 SIL-11 |
| LMD18200T/HALF | 制造商:Texas Instruments 功能描述:HALF BRIDGE 3A 55V 18200 SIL-11 |
| LMD18200T/LB14 | 功能描述:馬達/運動/點火控制器和驅動器 RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| LMD18200T/LF14 | 功能描述:馬達/運動/點火控制器和驅動器 RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
| LMD18200T/NOPB | 功能描述:馬達/運動/點火控制器和驅動器 3A 55V H-Bridge RoHS:否 制造商:STMicroelectronics 產品:Stepper Motor Controllers / Drivers 類型:2 Phase Stepper Motor Driver 工作電源電壓:8 V to 45 V 電源電流:0.5 mA 工作溫度:- 25 C to + 125 C 安裝風格:SMD/SMT 封裝 / 箱體:HTSSOP-28 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。