- 您現在的位置：買賣IC網 > PDF目錄358869 > LM5071MT-80 (NATIONAL SEMICONDUCTOR CORP) Power Over Ethernet PD Controller with Auxiliary Power Power Over Ethernet PD Controller with Auxiliary Power PDF資料下載
參數資料
| 型號： | LM5071MT-80 |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | Power Over Ethernet PD Controller with Auxiliary Power Power Over Ethernet PD Controller with Auxiliary Power |
| 中文描述： | SWITCHING CONTROLLER, 665 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | PLASTIC, TSSOP-16 |
| 文件頁數： | 3/18頁 |
| 文件大?。?/td> | 857K |
| 代理商： | LM5071MT-80 |
Pin Descriptions
Pin
1
Name
VIN
Description
Application Information
System high potential input.
The diode “OR” of several lines entering the PD, it is the more
positive input potential.
Connect a resistor from V
IN
to this pin for signature detection. The
resistor is in parallel with the UVLO resistors and should be valued
accordingly.
Connect the classification programming resistor from this pin to V
EE
.
A resistor divider between the AUX voltage input to VEE programs
the startup levels with a 2.5V threshold. A high value (
>
300k
)
internal pull down resistor is present to pull the pin low if it is left
open. In practice, the divider voltage should be set well above 2.5V
by the programming resistors.
An external resistor divider from V
IN
to UVLORTN programs the
shutdown levels with a 2.00V threshold at the UVLO pin. Hysteresis
is set by a switched internal 10uA current source that forces
additional current into the resistor divider.
Connect the bottom resistor of the resistor divider between the
UVLO pin and this pin.
Diode “OR’d” to the RJ45 connector and PSE’s –48V supply, it is
the more negative input potential.
The drain of the internal current limiting power MOSFET which
connects V
EE
to the return path of the dc-dc converter.
DC-DC converter gate driver output with 800mA peak sink current
capability.
When the auxiliary transformer winding (if used) raises the voltage
on this pin above the regulation set point, the internal series pass
regulator will shutdown, reducing the controller power dissipation.
Inverting input of the internal error amplifier. The non-inverting input
is internally connected to a 1.25V reference.
COMP pull-up is provided by an internal 5K resistor which may be
used to bias an opto-coupler transistor.
Current sense input for current mode control and over-current
protection. Current limiting is accomplished using a dedicated
current sense comparator. If the CS pin voltage exceeds 0.5V the
OUT pin switches low for cycle-by-cycle current limiting. CS is held
low for 50ns after OUT switches high to blank leading edge current
spikes.
An external resistor connected from RT to ARTN sets the oscillator
frequency. This pin will also accept narrow ac-coupled
synchronization pulses from an external clock.
An external capacitor and an internal 10uA current source set the
soft-start ramp rate.
RTN for sensitive analog circuitry including the SMPS current limit
amplifier.
2
RSIG
Signature resistor pin.
3
4
RCLASS
AUX
Classification resistor pin.
Auxiliary input power startup pin.
5
UVLO
Line under-voltage lockout.
6
UVLORTN
Return for the external UVLO resistors.
7
VEE
System low potential input.
8
RTN
System return for the PWM converter.
9
OUT
Output of the PWM controller.
10
V
CC
Output of the internal high voltage
series pass regulator. Regulated output
voltage is nominally 7.8V.
Feedback signal.
11
FB
12
COMP
The output of the error amplifier and
input to the Pulse Width Modulator.
Current sense input.
13
CS
14
RT / SYNC Oscillator timing resistor pin and
synchronization input.
15
SS
Soft-start input.
16
ARTN
Analog PWM supply return.
L
www.national.com
3
相關PDF資料 |
PDF描述 |
|---|---|
| LM5071MTX-80 | Power Over Ethernet PD Controller with Auxiliary Power Power Over Ethernet PD Controller with Auxiliary Power |
| LM5071MTX-50 | Power Over Ethernet PD Controller with Auxiliary Power Power Over Ethernet PD Controller with Auxiliary Power |
| LM5071 | Power Over Ethernet PD Controller with Auxiliary Power Power Over Ethernet PD Controller with Auxiliary Power |
| LM50C | CABLE |
| LM50CIM3 | SOT-23 Single-Supply Centigrade Temperature Sensor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM5071MT-80/NOPB | 功能描述:熱插拔功率分布 80V Poe Combo Device RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| LM5071MT-80/NOPB | 制造商:Texas Instruments 功能描述:, Input Voltage Primary Max:60V, Control |
| LM5071MTX-50 | 功能描述:熱插拔功率分布 RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| LM5071MTX-50/NOPB | 功能描述:熱插拔功率分布 RoHS:否 制造商:Texas Instruments 產品:Controllers & Switches 電流限制: 電源電壓-最大:7 V 電源電壓-最小:- 0.3 V 工作溫度范圍: 功率耗散: 安裝風格:SMD/SMT 封裝 / 箱體:MSOP-8 封裝:Tube |
| LM5071MTX-80 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Power Over Ethernet PD Controller with Auxiliary Power Power Over Ethernet PD Controller with Auxiliary Power |
發布緊急采購，3分鐘左右您將得到回復。