參數資料
型號: LM5000-3MTCX/NOPB
廠商: NATIONAL SEMICONDUCTOR CORP
元件分類: 穩壓器
英文描述: 2.7 A SWITCHING REGULATOR, 840 kHz SWITCHING FREQ-MAX, PDSO16
封裝: TSSOP-16
文件頁數: 5/18頁
文件大?。?/td> 388K
代理商: LM5000-3MTCX/NOPB
OUTPUT VOLTAGE LIMITATIONS
The maximum output voltage of a boost regulator is the max-
imum switch voltage minus a diode drop. In a flyback regula-
tor, the maximum output voltage is determined by the turns
ratio, N, and the duty cycle, D, by the equation:
V
OUT ≈ N × VIN × D/(1 D)
The duty cycle of a flyback regulator is determined by the fol-
lowing equation:
Theoretically, the maximum output voltage can be as large as
desired—just keep increasing the turns ratio of the trans-
former. However, there exists some physical limitations that
prevent the turns ratio, and thus the output voltage, from in-
creasing to infinity. The physical limitations are capacitances
and inductances in the LM5000 switch, the output diode(s),
and the transformer—such as reverse recovery time of the
output diode (mentioned above).
INPUT LINE CONDITIONING
A small, low-pass RC filter should be used at the input pin of
the LM5000 if the input voltage has an unusually large amount
of transient noise. Additionally, the RC filter can reduce the
dissipation within the device when the input voltage is high.
Flyback Regulator Operation
The LM5000 is ideally suited for use in the flyback regulator
topology. The flyback regulator can produce a single output
voltage, or multiple output voltages.
The operation of a flyback regulator is as follows: When the
switch is on, current flows through the primary winding of the
transformer, T1, storing energy in the magnetic field of the
transformer. Note that the primary and secondary windings
are out of phase, so no current flows through the secondary
when current flows through the primary. When the switch
turns off, the magnetic field collapses, reversing the voltage
polarity of the primary and secondary windings. Now rectifier
D5 is forward biased and current flows through it, releasing
the energy stored in the transformer. This produces voltage
at the output.
The output voltage is controlled by modulating the peak
switch current. This is done by feeding back a portion of the
output voltage to the error amp, which amplifies the difference
between the feedback voltage and a 1.259V reference. The
error amp output voltage is compared to a ramp voltage pro-
portional to the switch current (i.e., inductor current during the
switch on time). The comparator terminates the switch on time
when the two voltages are equal, thereby controlling the peak
switch current to maintain a constant output voltage.
20031972
FIGURE 5. LM5000 Flyback Converter
13
www.national.com
LM5000
相關PDF資料
PDF描述
LM5010AHMH 1.5 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO14
LM5010AMHE 1.5 A SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO14
LM5021NA-2/NOPB 0.7 A SWITCHING CONTROLLER, 560 kHz SWITCHING FREQ-MAX, PDIP8
LM5041BSDX SWITCHING CONTROLLER, 685 kHz SWITCHING FREQ-MAX, DSO16
LM555H-MLS/NOPB PULSE; RECTANGULAR, TIMER, MBCY8
相關代理商/技術參數
參數描述
LM5000-3MYC 制造商:Texas Instruments 功能描述:
LM5000EP 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Enhanced Plastic High Voltage Switch Mode Regulator
LM5000EVAL 功能描述:電源管理IC開發工具 LM5000 EVAL UNIT RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V
LM5000EVAL/NOPB 功能描述:EVALUATION BOARD FOR LM5000 RoHS:是 類別:編程器,開發系統 >> 評估板 - DC/DC 與 AC/DC(離線)SMPS 系列:- 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:True Shutdown™ 主要目的:DC/DC,步升 輸出及類型:1,非隔離 功率 - 輸出:- 輸出電壓:- 電流 - 輸出:1A 輸入電壓:2.5 V ~ 5.5 V 穩壓器拓撲結構:升壓 頻率 - 開關:3MHz 板類型:完全填充 已供物品:板 已用 IC / 零件:MAX8969
LM5000SD-3 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT