
Electrical Characteristics (Notes 1, 2, 7) (Continued) The following specifications apply for V
DD = 5V, RL =4
, LC filter values as shown in Figure 1, unless otherwise specified.
Limits apply for T
A = 25C.
Symbol
Parameter
Conditions
LM4663
Units
Typical
Max
Min
A
VLAVR
Stereo Gain Tracking
1kHz, V
IN = 100mV, RL =4
0.1
dB
Headphone Amplifiers
P
O
Power Out Per Channel
THD+N
≤ 1%, R
L =32
,
f
IN = 1kHz
80
60
mW
THD+N
Distortion + Noise
P
O = 20mW, RL =32
,
f
IN = 1kHz
0.15
%
V
NOISE
Output Noise Voltage, RMS
R
IN =50
,C
IN = 1F,
BW = 8Hz to 22kHz
30
V
PSRR
Power Supply Rejection Ratio
(Referred to Input)
200mV, 1kHz, V
IN =0,RL =32
44
dB
A
V
Voltage Gain
1kHz, V
IN = 100mV, RL =32
5.5
dB
A
VLAVR
Stereo Gain Tracking
1kHz, V
IN = 100mV, RL =32
0.1
dB
Note 1: All voltages are measured with respect to the ground pin, unless otherwise specified.
Note 2: “Absolute Maximum Ratings” indicate limits beyond which damage to the device may occur. “Operating Ratings” indicate conditions for which the device
is functional, but do not guarantee specific performance limits. “Electrical Characteristics” state DC and AC electrical specifications under particular test conditions
which guarantee specific performance limits. This assumes that the device is within the Operating Ratings. Specifications are not guaranteed for parameters where
no limit is given, however, the typical value is a good indication of device performance.
Note 3: For operating at case temperatures above 25C, the device must be derated based on a 150C maximum junction temperature and a thermal resistance
of
θJA = 80C/W (junction to ambient).
Note 4: Human body model, 100pF discharged through a 1.5k
resistor.
Note 5: Machine Model 220pF240pF discharged through all pins.
Note 6: The operating junction temperature maximum is 150C.
Note 7: Limits are guaranteed to National’s AOQL (Average Outgoing Quality Level).
Typical Performance Characteristics
Efficiency vs Output Power
Power Dissipation vs Output Power
10126910
10126911
LM4663
www.national.com
3