- 您現在的位置：買賣IC網 > PDF目錄358854 > LM3915 (National Semiconductor Corporation) Dot/Bar Display Driver PDF資料下載
參數資料
| 型號： | LM3915 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | Dot/Bar Display Driver |
| 中文描述： | 點/酒吧顯示驅動程序 |
| 文件頁數： | 9/24頁 |
| 文件大?。?/td> | 602K |
| 代理商： | LM3915 |
Application Hints
(Continued)
Power dissipation, especially in bar mode should be given
consideration. For example, with a 5V supply and all LEDs
programmed to 20 mA the driver will dissipate over 600 mW.
In this case a 7.5
resistor in series with the LED supply will
cut device heating in half. The negative end of the resistor
should be bypassed with a 2.2 μF solid tantalum capacitor to
pin 2.
TIPS ON RECTIFIER CIRCUITS
The simplest way to display an AC signal using the LM3915
is to apply it right to pin 5 unrectified. Since the LED illumi-
nated represents the instantaneous value of the AC wave-
form, one can readily discern both peak and average values
of audio signals in this manner. The LM3915 will respond to
positive half-cycles only but will not be damaged by signals
up to
±
35V (or up to
±
100V if a 39k resistor is in series with
the input). It’s recommended to use dot mode and to run the
LEDs at 30 mA for high enough average intensity.
True average or peak detection requires rectification. If an
LM3915 is set up with 10V full scale across its voltage di-
vider, the turn-on point for the first LED is only 450 mV. A
simple silicon diode rectifier won’t work well at the low end
due to the 600 mV diode threshold. The half-wave peak de-
tector in Figure 1 uses a PNP emitter-follower in front of the
diode. Now, the transistor’s base-emitter voltage cancels out
the diode offset, within about 100 mV. This approach is usu-
ally satisfactory when a single LM3915 is used for a 30 dB
display.
Display circuits using two or more LM3915s for a dynamic
range of 60 dB or greater require more accurate detection. In
the precision half-wave rectifier of Figure 2 the effective di-
ode offset is reduced by a factor equal to the open-loop gain
of the op amp. Filter capacitor C2 charges through R3 and
discharges through R2 and R3, so that appropriate selection
of these values results in either a peak or an average detec-
tor. The circuit has a gain equal to R2/R1.
It’s best to capacitively couple the input. Audio sources fre-
quently have a small DC offset that can cause significant er-
ror at the low end of the log display. Op amps that slew
quickly, such as the LF351, LF353, or LF356, are needed to
faithfully respond to sudden transients. It may be necessary
to trim out the op amp DC offset voltage to accurately cover
a 60 dB range. Best results are obtained if the circuit is ad-
justed for the correct output when a low-level AC signal
(10 mV to 20 mV) is applied, rather than adjusting for zero
output with zero input.
For precision full-wave averaging use the circuit in Figure 3
Using 1% resistors for R1 through R4, gain for positive and
negative signal differs by only 0.5 dB worst case. Substitut-
ing 5% resistors increases this to 2 dB worst case. (A 2 dB
gain difference means that the display may have a
±
1 dB er-
ror when the input is a nonsymmetrical transient). The aver-
aging time constant is R5–C2. A simple modification results
in the precision full-wave detector of Figure 4 Since the filter
capacitor is not buffered, this circuit can drive only high im-
pedance loads such as the input of an LM3915.
DS005104-9
*
DC Couple
FIGURE 1. Half-Wave Peak Detector
DS005104-10
D1, D2: 1N914 or 1N4148
Average
1k
100k
Peak
100k
1k
R2
R3
R1 = R2 for A
= 1
R1 = R2/R10 for A
V
= 10
C1 = 10/R1
FIGURE 2. Precision Half-Wave Rectifier
L
www.national.com
9
相關PDF資料 |
PDF描述 |
|---|---|
| LM391N-100 | LM391 Audio Power Driver |
| LM3914VX | LED Display Driver |
| LM391 | LM391 Audio Power Driver |
| LM39301R-3.3 | 3A Low-Voltage Low-Dropout Regulator |
| LM393 | Dual Differential Comparators |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM3915J/A+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LED Display Driver |
| LM3915N | 制造商:Texas Instruments 功能描述: 制造商:Texas Instruments 功能描述:IC LED DISPLAY DRIVER 3915 DIP18 |
| LM3915N/A+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LED Display Driver |
| LM3915N/B+ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:LED Display Driver |
| LM3915N-1 | 功能描述:LED照明驅動器 RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
發布緊急采購，3分鐘左右您將得到回復。