- 您現在的位置：買賣IC網 > PDF目錄385481 > LM3519MKX-20 (NATIONAL SEMICONDUCTOR CORP) High Frequency Boost White LED Driver with High-Speed PWM Brightness Control PDF資料下載
參數資料
| 型號： | LM3519MKX-20 |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 顯示驅動器 |
| 英文描述： | High Frequency Boost White LED Driver with High-Speed PWM Brightness Control |
| 中文描述： | LED DISPLAY DRIVER, PDSO6 |
| 封裝： | SOT-23, 6 PIN |
| 文件頁數： | 5/14頁 |
| 文件大?。?/td> | 1385K |
| 代理商： | LM3519MKX-20 |
Circuit Description
The LM3519 is a step-up converter for white LED applica-
tions that uses a unique and proprietary pulse frequency
modulation (PFM) architecture to optimize high efficiency at
high frequency operation. Unlike most PFM architecture
implementations, the LM3519’s unique architectural imple-
mentation results in non-pulse skipping variable frequency
operation. The regulator is forced to operate at the edge of
Continous Conduction Mode (CCM). The error amplifier will
set the end of the on-time (I
PEAK
of inductor) based on the
load (LEDs) current. During this operation, the inductor cur-
rent ramps up and reaches a peak current at end of the
on-time. At this point, the internal power switch is turned off
until the inductor current reaches zero, and the cycle repeats
again. The switching frequency is set based on the charge
(on-time) and discharge(off-time) of the inductor current. The
frequency can range between 2MHz to 8MHz over the op-
erating input range.
The LM3519 operation can be best understood through an
examination of the block diagram in
Figure 2
. When LED
current is out of regulation, the LED_rtn voltage falls below
or rises above the internal reference voltage (VREF). The
error amplifier will output a signal to increase or decrease the
proper on-time duration of N1 power FET. This correction
allows the inductor’s stored energy to increase or decrease
to a sufficient level that when transferred to the load will bring
the LED_rtn current back into regulation.
During steady-state operation for a typical switching cycle,
the oscillator sets the driver logic and turns on N1 power
device. N1 conducts current through the inductor and re-
verse biases the external diode. The LED current is supplied
by the output capacitor when N1 is conducting. Once N1
on-time period is concluded, the internal power device is
turned off and the external diode is forward baised. The
inductor current then flows through the diode to the LED load
to replenish the output capacitor and keep the LED current
regulated at the trimmed target.
L
www.national.com
5
相關PDF資料 |
PDF描述 |
|---|---|
| LM3524DM | Regulating Pulse Width Modulator |
| LM3524 | Regulating Pulse Width Modulator |
| LM3524D | Regulating Pulse Width Modulator |
| LM3524DN | Regulating Pulse Width Modulator |
| LM2524 | Regulating Pulse Width Modulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM3519MKX-20/NOPB | 功能描述:LED照明驅動器 RoHS:否 制造商:STMicroelectronics 輸入電壓:11.5 V to 23 V 工作頻率: 最大電源電流:1.7 mA 輸出電流: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:SO-16N |
| LM3520 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Integrated White LED Driver with Organic LED Display Power Supply |
| LM3520_0509 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Integrated White LED Driver with Organic LED Display Power Supply |
| LM3520B WAF | 制造商:Texas Instruments 功能描述: |
| LM3520SD | 制造商:Texas Instruments 功能描述:WLED/OLED DRIVER POWERWISE LLP-14 |
發布緊急采購，3分鐘左右您將得到回復。