參數資料
型號: LM2930
廠商: National Semiconductor Corporation
英文描述: Octal Buffers/Drivers With 3-State Outputs 20-TSSOP -40 to 85
中文描述: 三端穩壓器正
文件頁數: 5/8頁
文件大小: 251K
代理商: LM2930
Typical Performance Characteristics
(Continued)
Definition of Terms
Dropout Voltage:
The input-output voltage differential at
which the circuit ceases to regulate against further reduction
in input voltage. Measured when the output voltage has
dropped 100 mV from the nominal value obtained at 14V in-
put, dropout voltage is dependent upon load current and
junction temperature.
Input Voltage:
The DC voltage applied to the input terminals
with respect to ground.
Input-Output Differential:
The voltage difference between
the unregulated input voltage and the regulated output volt-
age for which the regulator will operate.
Line Regulation:
The change in output voltage for a change
in the input voltage. The measurement is made under condi-
tions of low dissipation or by using pulse techniques such
that the average chip temperature is not significantly af-
fected.
Load Regulation:
The change in output voltage for a
change in load current at constant chip temperature.
Long Term Stability:
Output voltage stability under acceler-
ated life-test conditions after 1000 hours with maximum
rated voltage and junction temperature.
Output Noise Voltage:
The rms AC voltage at the output,
with constant load and no input ripple, measured over a
specified frequency range.
Quiescent Current:
That part of the positive input current
that does not contribute to the positive load current. The
regulator ground lead current.
Ripple Rejection:
The ratio of the peak-to-peak input ripple
voltage to the peak-to-peak output ripple voltage.
Temperature Stability of V
:
The percentage change in
output voltage for a thermal variation from room temperature
to either temperature extreme.
Peak Output Current
DS005539-23
Quiescent Current
DS005539-24
Quiescent Current
DS005539-25
Quiescent Current
DS005539-26
Ripple Rejection
DS005539-27
Ripple Rejection
DS005539-28
Maximum Power
Dissipation (TO-220)
DS005539-6
5
www.national.com
相關PDF資料
PDF描述
LM2931ACT-5.0 Octal Transparent D-Type Latches With 3-State Outputs 20-SOIC -40 to 85
LM2931D Octal Edge-Triggered D-Type Flip-Flops With 3-State Outputs 20-SOIC -40 to 85
LM2931ADT33 VERY LOW DROP VOLTAGE REGULATOR WITH INHIBIT FUNCTION
LM2931AV50 VERY LOW DROP VOLTAGE REGULATOR WITH INHIBIT FUNCTION
LM2931BV33 VERY LOW DROP VOLTAGE REGULATOR WITH INHIBIT FUNCTION
相關代理商/技術參數
參數描述
LM2930-5KC 制造商:Rochester Electronics LLC 功能描述:- Bulk
LM2930A 功能描述:低壓差穩壓器 - LDO 5.0V 0.4A Positive RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓(最大值):307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20
LM2930S-5.0 制造商:Texas Instruments 功能描述: 制造商:Texas Instruments 功能描述:V REG LDO +5.0V SMD 2930 TO2633
LM2930S-5.0 WAF 制造商:Texas Instruments 功能描述:
LM2930S-5.0 制造商:Texas Instruments 功能描述:V REG LDO +5.0V SMD 2930 TO2633