- 您現在的位置：買賣IC網 > PDF目錄44549 > LM2651MTC-1.8/NOPB (NATIONAL SEMICONDUCTOR CORP) 2.6 A SWITCHING REGULATOR, 345 kHz SWITCHING FREQ-MAX, PDSO16 PDF資料下載
參數資料
| 型號： | LM2651MTC-1.8/NOPB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | 2.6 A SWITCHING REGULATOR, 345 kHz SWITCHING FREQ-MAX, PDSO16 |
| 封裝： | TSSOP-16 |
| 文件頁數： | 10/11頁 |
| 文件大?。?/td> | 631K |
| 代理商： | LM2651MTC-1.8/NOPB |
Block Diagram
Operation
The LM2651 operates in a constant frequency (300 kHz),
current-mode PWM for moderate to heavy loads; and it
automatically switches to hysteretic mode for light loads. In
hysteretic mode, the switching frequency is reduced to keep
the efficiency high.
MAIN OPERATION
When the load current is higher than the sleep mode thresh-
old, the part is always operating in PWM mode. At the
beginning of each switching cycle, the high-side switch is
turned on, the current from the high-side switch is sensed
and compared with the output of the error amplifier (COMP
pin). When the sensed current reaches the COMP pin volt-
age level, the high-side switch is turned off; after 40 ns
(deadtime), the low-side switch is turned on. At the end of the
switching cycle, the low-side switch is turned off; and the
same cycle repeats.
The current of the top switch is sensed by a patented internal
circuitry. This unique technique gets rid of the external sense
resistor, saves cost and size, and improves noise immunity
of the sensed current. A feedforward from the input voltage is
added to reduce the variation of the current limit over the
input voltage range.
When the load current decreases below the sleep mode
threshold, the output voltage will rise slightly, this rise is
sensed by the hysteretic mode comparator which makes the
part go into the hysteretic mode with both the high and low
side switches off. The output voltage starts to drop until it hits
the low threshold of the hysteretic comparator, and the part
immediately goes back to the PWM operation. The output
voltage keeps increasing until it reaches the top hysteretic
threshold, then both the high and low side switches turn off
again, and the same cycle repeats.
PROTECTIONS
The cycle-by-cycle current limit circuitry turns off the high-
side MOSFET whenever the current in MOSFET reaches
2A.
Design Procedure
This section presents guidelines for selecting external com-
ponents.
10092503
FIGURE 1. LM2651 Block Diagram
LM2651
www.national.com
8
相關PDF資料 |
PDF描述 |
|---|---|
| LM2670-5.0MDC | 5.4 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, UUC |
| LM2670LDX-3.3 | 5.4 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO14 |
| LM2670LD-3.3 | 5.4 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO14 |
| LM2670LD-12 | 5.4 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO14 |
| LM2670LD-5.0 | 5.4 A SWITCHING REGULATOR, 280 kHz SWITCHING FREQ-MAX, PDSO14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM2651MTC-2.5 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:1.5A High Efficiency Synchronous Switching Regulator |
| LM2651MTC-2.5/NOPB | 功能描述:IC REG BUCK SYNC 2.5V 16-TSSOP RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - DC DC 開關穩壓器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 類型:降壓（降壓） 輸出類型:固定 輸出數:1 輸出電壓:3.3V 輸入電壓:4.5 V ~ 24 V PWM 型:- 頻率 - 開關:- 電流 - 輸出:125mA 同步整流器:無 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 包裝:Digi-Reel® 供應商設備封裝:SOT-6 其它名稱:MAX1836EUT33#TG16DKR |
| LM2651MTC-2.5/NOPB | 制造商:Texas Instruments 功能描述:DC/DC Converter (DC-DC) / Switching Regu |
| LM2651MTC-3.3 | 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LM2651MTC-3.3/NOPB | 功能描述:直流/直流開關轉換器 1.5A HIGH EFFICIENCY SWITCHING REG RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。