- 您現在的位置：買賣IC網 > PDF目錄98000 > LM2633MTDX/NOPB (NATIONAL SEMICONDUCTOR CORP) SWITCHING CONTROLLER, 275 kHz SWITCHING FREQ-MAX, PDSO48 PDF資料下載
參數資料
| 型號： | LM2633MTDX/NOPB |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | SWITCHING CONTROLLER, 275 kHz SWITCHING FREQ-MAX, PDSO48 |
| 封裝： | TSSOP-48 |
| 文件頁數： | 1/40頁 |
| 文件大?。?/td> | 1350K |
| 代理商： | LM2633MTDX/NOPB |
當前第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁
LM2633
Advanced Two-Phase Synchronous Triple Regulator
Controller for Notebook CPUs
General Description
The LM2633 is a feature-rich IC that combines three regu-
lator controllers - two current mode synchronous buck regu-
lator controllers and a linear regulator controller.
The two switching regulator controllers operate 180 out of
phase. This feature reduces the input ripple RMS current,
resulting in a smaller input filter.
The first switching controller (Channel 1) features an Intel
mobile CPU compatible precision 5-bit digital-to-analog con-
verter which programs the output voltage from 0.925V to
2.00V. It is also compatible with the dynamic VID require-
ments. The second switching controller (Channel 2) is ad-
justable between 1.25V to 6.0V.
Use of synchronous rectification and pulse-skip operation at
light load achieves high efficiency over a wide load range.
Fixed-frequency operation can be obtained by disabling the
pulse-skip mode.
Current-mode feedback control assures excellent line and
load regulation and a wide loop bandwidth for good re-
sponse to fast load transient events. Current mode control is
achieved through sensing the Vds of the top FET and thus
an external sense resistor is not necessary.
A power good signal is available to indicate the general
health of the output voltages.
A unique feature is the analog soft-start for the switching
controllers is independent of the slew rate of the input volt-
age. This will make the soft start behavior more predictable
and controllable. An internal 5V rail is available externally for
boot-strap circuitry (only) when no 5V is available from other
sources.
Current limit for either of the two switching channels is
achieved through sensing the top FET V
DS and the value is
adjustable. The two switching controllers have under-voltage
and over-voltage latch protections, and the linear regulator
has under-voltage latch protection. Under-voltage latch can
be disabled or delayed by a programmable amount of time.
The input voltage for the switching channels ranges from 5V
to 30V, which makes possible the choice of different battery
chemistries and options.
Features
GENERAL
n
Three regulated output voltages
n
4.5V to 30V input range
n
Power good function
n
Input under-voltage lockout
n
Thermal shutdown
n
Tiny TSSOP package
SWITCHING SECTION
n
Two channels operating 180 out of phase
n
Separate on/off control for each channel
n
Current mode control without sense resistor
n
Skip-mode operation available
n
Adjustable cycle-by-cycle current limit
n
Negative current limit
n
Analog soft start independent of input voltage slew rate
n
Power ground pins separate
n
Output UVP and OVP
n
Programmable output UVP delay
n
250kHz switching frequency (for Vin < 17V)
n
Channel 1 output from 0.925V to 2.00V
n ±
1.5% DAC accuracy from 0C to 125C
n ±
1.7% initial tolerance for Channel 2
n
Dynamic VID change ready
n
Power good flags VID changes
n
Channel 2 output from 1.3V to 6.0V
LINEAR SECTION
n
Output voltage adjustable
n
50mA maximum driving current
n
Output UVP
n ±
2% initial tolerance
Applications
n
Power supply for CPUs of notebook PCs that require
the SpeedStep technique
n
Power supply for information appliances
n
General low voltage DC/DC buck regulators
SpeedStep is a trademark of Intel Corporation.
August 2001
LM2633
Advanced
T
wo-Phase
Synchronous
T
riple
Regulator
Controller
for
Notebook
CPUs
2001 National Semiconductor Corporation
DS200008
www.national.com
相關PDF資料 |
PDF描述 |
|---|---|
| LM2635MX/NOPB | SWITCHING CONTROLLER, 350 kHz SWITCHING FREQ-MAX, PDSO20 |
| LM26480QSQX-CF/NOPB | 2.4 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, QCC24 |
| LM26480QSQ-CF/NOPB | 2.4 A SWITCHING REGULATOR, 2500 kHz SWITCHING FREQ-MAX, QCC24 |
| LM26480SQ-BF/NOPB | 2.4 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, QCC24 |
| LM26480SQX-BF/NOPB | 2.4 A SWITCHING REGULATOR, 2400 kHz SWITCHING FREQ-MAX, QCC24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM2635 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:5-Bit Programmable Synchronous Buck Regulator Controller |
| LM2635A WAF | 制造商:Texas Instruments 功能描述: |
| LM2635M | 制造商:Rochester Electronics LLC 功能描述: 制造商:Texas Instruments 功能描述: |
| LM2635M/NOPB | 功能描述:IC REG SYNCH BUCK 5-BIT 20-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 應用說明:Ultrasound Imaging Systems Application Note 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:37 系列:- 應用:醫療用超聲波成像，聲納 電流 - 電源:- 電源電壓:2.37 V ~ 6 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:56-WFQFN 裸露焊盤 供應商設備封裝:56-TQFN-EP（8x8） 包裝:管件 |
| LM2635MX | 功能描述:IC REG SYNCH BUCK 5-BIT 20-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - 電源管理 - 專用 系列:- 應用說明:Ultrasound Imaging Systems Application Note 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:37 系列:- 應用:醫療用超聲波成像，聲納 電流 - 電源:- 電源電壓:2.37 V ~ 6 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:56-WFQFN 裸露焊盤 供應商設備封裝:56-TQFN-EP（8x8） 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。