- 您現在的位置：買賣IC網 > PDF目錄358822 > LM2587S-12 (NATIONAL SEMICONDUCTOR CORP) CONNECTOR PDF資料下載
參數資料
| 型號： | LM2587S-12 |
| 廠商： | NATIONAL SEMICONDUCTOR CORP |
| 元件分類： | 穩壓器 |
| 英文描述： | CONNECTOR |
| 中文描述： | 5 A SWITCHING REGULATOR, 100 kHz SWITCHING FREQ-MAX, PSSO5 |
| 封裝： | TO-263, 5 PIN |
| 文件頁數： | 23/26頁 |
| 文件大?。?/td> | 676K |
| 代理商： | LM2587S-12 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁
Application Hints
(Continued)
The duty cycle of a flyback regulator is determined by the fol-
lowing equation:
Theoretically, the maximum output voltage can be as large
as desired— just keep increasing the turns ratio of the trans-
former. However, there exists some physical limitations that
prevent the turns ratio, and thus the output voltage, from in-
creasing to infinity. The physical limitations are capacitances
and inductances in the LM2587 switch, the output diode(s),
and the transformer— such as reverse recovery time of the
output diode (mentioned above).
NOISY INPUT LINE CONDITION)
A small, low-pass RC filter should be used at the input pin of
the LM2587 if the input voltage has an unusual large amount
of transient noise, such as with an input switch that bounces.
The circuit in Figure 43 demonstrates the layout of the filter,
with the capacitor placed from the input pin to ground and
the resistor placed between the input supply and the input
pin. Note that the values of R
and C
shown in the sche-
matic are good enough for most applications, but some read-
justing might be required for a particular application. If effi-
ciency is a major concern, replace the resistor with a small
inductor (say 10 μH and rated at 100 mA).
STABILITY
All current-mode controlled regulators can suffer from an in-
stability, known as subharmonic oscillation, if they operate
with a duty cycle above 50%. To eliminate subharmonic os-
cillations, a minimum value of inductance is required to en-
sure stability for all boost and flyback regulators. The mini-
mum inductance is given by:
where V
is the switch saturation voltage and can be
found in the Characteristic Curves.
CIRCUIT LAYOUT GUIDELINES
As in any switching regulator, layout is very important. Rap-
idly switching currents associated with wiring inductance
generate voltage transients which can cause problems. For
minimal inductance and ground loops, keep the length of the
leads and traces as short as possible. Use single point
grounding or ground plane construction for best results.
Separate the signal grounds from the power grounds (as in-
dicated in Figure 44). When using the Adjustable version,
physically locate the programming resistors as near the
regulator IC as possible, to keep the sensitive feedback wir-
ing short.
HEAT SINK/THERMAL CONSIDERATIONS
In many cases, no heat sink is required to keep the LM2587
junction temperature within the allowed operating range. For
each application, to determine whether or not a heat sink will
be required, the following must be identified:
1) Maximum ambient temperature (in the application).
2) Maximum regulator power dissipation (in the application).
3) Maximum allowed junction temperature (125C for the
LM2587). For a safe, conservative design, a temperature ap-
proximately 15C cooler than the maximum junction tem-
perature should be selected (110C).
4) LM2587 package thermal resistances
θ
JA
and
θ
JC
(given
in the Electrical Characteristics).
Total power dissipated (P
D
) by the LM2587 can be estimated
as follows:
Boost:
V
is the minimum input voltage, V
is the output voltage,
N is the transformer turns ratio, D is the duty cycle, and I
is the maximum load current (and
∑
I
is the sum of the
maximum load currents for multiple-output flyback regula-
tors). The duty cycle is given by:
DS012316-29
FIGURE 44. Circuit Board Layout
www.national.com
23
相關PDF資料 |
PDF描述 |
|---|---|
| LM2587SX-ADJ | SIMPLE SWITCHER 5A Flyback Regulator |
| LM2587SX-3.3 | SIMPLE SWITCHER 5A Flyback Regulator |
| LM2587SX-12 | SIMPLE SWITCHER 5A Flyback Regulator |
| LM2587 | Octal D-type Edge-Triggered Flip-Flops With 3-State Outputs 20-TSSOP -40 to 85 |
| LM2588SX-5.0 | SIMPLE SWITCHER 5A Flyback Regulator with |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM2587S-12/NOPB | 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LM2587S-3.3 | 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LM2587S-3.3/NOPB | 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LM2587S5.0 | 制造商:National Semiconductor 功能描述:Conv DC-DC Single Step Up 4V to 40V 6-Pin(5+Tab) TO-263 Rail |
| LM2587S-5.0 | 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
發布緊急采購，3分鐘左右您將得到回復。