- 您現在的位置：買賣IC網 > PDF目錄384596 > LM25005 (National Semiconductor Corporation) 42V, 2.5A STEP-DOWN SWITCHING REGULATOR PDF資料下載
參數資料
| 型號： | LM25005 |
| 廠商： | National Semiconductor Corporation |
| 英文描述： | 42V, 2.5A STEP-DOWN SWITCHING REGULATOR |
| 中文描述： | 42V的2.5A降壓型開關穩壓 |
| 文件頁數： | 13/21頁 |
| 文件大?。?/td> | 756K |
| 代理商： | LM25005 |
RAMP Generator
(Continued)
The Sample and Hold DC level illustrated in Figure 6. is
derived from a measurement of the re-circulating Schottky
diode anode current. The re-circulating diode anode should
be connected to the IS pin. The diode current flows through
an internal current sense resistor between the IS and PGND
pins. The voltage level across the sense resistor is sampled
and held just prior to the onset of the next conduction interval
of the buck switch. The diode current sensing and sample &
hold provide the dc level of the reconstructed current signal.
The positive slope inductor current ramp is emulated by an
external capacitor connected from the RAMP pin to AGND
and an internal voltage controlled current source. The ramp
current source that emulates the inductor current is a func-
tion of the Vin and Vout voltages per the following equation:
I
RAMP
= (5μ x (Vin – Vout)) + 25μA
Proper selection of the RAMP capacitor depends upon the
selected value of the output inductor. The value of C
RAMP
can be selected from: C
RAMP
= L x 10
-5
, where L is the value
of the output inductor in Henrys. With this value, the scale
factor of the emulated current ramp will be approximately
equal to the scale factor of the dc level sample and hold ( 0.5
V / A). The C
RAMP
capacitor should be located very close to
the device and connected directly to the pins of the IC
(RAMP and AGND).
For duty cycles greater than 50 percent, current mode con-
trol circuits are subject to sub-harmonic oscillation. Adding a
fixed slope voltage ramp signal (slope compensation) to the
current sense signal prevents this oscillation. The 25μA of
offset current provided from the emulated current source
adds some fixed slope to the ramp signal. In some very high
duty cycle applications, additional slope may be required. In
these applications, the ramp capacitor value can be de-
creased to increase the ramp slope compensation.
20170008
FIGURE 6. Composition of Current Sense Signal
L
www.national.com
13
相關PDF資料 |
PDF描述 |
|---|---|
| LM25005MH | 42V, 2.5A STEP-DOWN SWITCHING REGULATOR |
| LM25005MHX | 42V, 2.5A STEP-DOWN SWITCHING REGULATOR |
| LM25007 | 42V, 0.5A Step-Down Switching Regulator |
| LM25007MM | 42V, 0.5A Step-Down Switching Regulator |
| LM25007MMX | 42V, 0.5A Step-Down Switching Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LM25005_06 | 制造商:NSC 制造商全稱:National Semiconductor 功能描述:42V, 2.5A Step-Down Switching Regulator |
| LM25005EVAL | 功能描述:電源管理IC開發工具 LM25005 EVAL BOARD RoHS:否 制造商:Maxim Integrated 產品:Evaluation Kits 類型:Battery Management 工具用于評估:MAX17710GB 輸入電壓: 輸出電壓:1.8 V |
| LM25005EVAL | 制造商:Texas Instruments 功能描述:EVAL BOARD, LM25005 42V, 2.5A REGULATORU |
| LM25005MH | 功能描述:直流/直流開關轉換器 RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| LM25005MH/NOPB | 功能描述:直流/直流開關調節器 42V,2.5A STEP-DOWN SWITCHING REG RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。